How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Russell A. Your Own Question
Russell A.
Russell A., Camera and Video Technician
Category: Camera and Video
Satisfied Customers: 6050
Experience:  30 years of experience as a TV station technician gives me a unique understanding of technical equipment issues.
24675295
Type Your Camera and Video Question Here...
Russell A. is online now
A new question is answered every 9 seconds

I ahve a Kodak PixPro AZ521, and the lens is stuck, PixPro

Customer Question

Hi there! I ahve a Kodak PixPro AZ521, and the lens is stuck
JA: What's the make/model of your camera? How old is it?
Customer: PixPro AZ521
JA: What happened right before this popped up? What troubleshooting have you tried?
Customer: Hi tried taking a piece of paper and sliding it into the crevise as I saw on youtube. But it did not work. It jsut did it one time when I turned it on. I thik I have had it for 3-4 years
JA: Anything else you want the Camera Expert to know before I connect you?
Customer: I don't think so. thank you
Submitted: 1 month ago.
Category: Camera and Video
Expert:  Russell A. replied 1 month ago.

Hi,

First, to make sure that poor contact is not causing the issue, AND IF you are positive that the new batteries start out good, remove them from the camera and clean the metal battery contacts inside of the battery compartment and on the battery with a q-tip and alcohol to make sure that any residue from the stuck batteries is removed. The connection is very critical and a very small amount of residue or dust can inhibit the power transfer.

Next, please be aware that resolving this issue can take multiple attempts. With some units that have had this problem it has taken me up to 6 or 7 hours of manipulation, over a few days, to make the lens move freely.

Make sure that the battery or batteries are new or fully charged.

Put the camera switch in the Off position.

Place it on the back with the lens facing up and take a look at the spacing between the lens and the lens housing.

If you notice that the gap is not even all the way around the lens, the problem should be easy to fix.

This type of a problem usually occurs if the camera was accidentally turned on while the lens is restricted.

Next, if uneven, apply gentle pressure down the lens on the side where the gap is the biggest.

You should hear a "click" as it pops back into place.

Try powering the camera on.

If the lens doesn't extend at all or it extends, and then retracts again, do the following.

Turn the camera off.

Take the camera in one hand and with the other gently take one part of the lens and gently move it round in a circular movement.

Do so with both sections of the lens. You will hear a "click" as it pops back in place.

Power the camera on. Next, try to pull and twist on the largest ring of the lens while turning the camera on.

Listen for a "click". If at first the focus seems to be off, turn the camera on and off and take lots of pictures, close ups and distance. Focus should slowly start improving.

Lens errors are a common problem. It may just be misaligned or an internal component has failed due to the impact. Here are a couple of links to some other things to try. With newer cameras I am usually hesitant to suggest these options since they include some more extreme procedures that may cause further damage if not done correctly, but since you can't use the warranty and yours has been dropped, they may save you an expensive repair bill. An older Canon camera is used to demonstrate these procedures but, the lens structure of these compact cameras is the same so the examples do apply to this unit. These procedures are effective about 60% of the time.

Click on or copy and paste the links into your browser.

http://www.e18error.com/repair.html

http://camerarepair.blogspot.com/2007/12/fixing-lens-error-on-digital-camera.html

Please keep in mind that my diagnosis & solutions provided are directly dependent on the accuracy of your description of the problem. As with any "do it yourself" fixes, success is a "team effort", since I can't see or touch the camera, and relies on the customer's manual dexterity and ability to follow the instructions well. If the "do it yourself" approach doesn't work out for you and you need conventional repair, please let me know.

If you require additional information, please use the Reply to Expert Tab to contact me. Click the ratings only after our exchange is complete and you are satisfied.

If you are satisfied that my answer is accurate or has provided a reasonable alternative solution, please do not forget to rate my answer OK, Good or Excellent.

Thank you