While making soft or left turns BEST light comes on in the…

O.k.,the sensors you are speaking of are the tire pressure sensors.These are different sensors then the wheel speed sensors.The wheel speed sensors read the speed of each wheel.The speeds should match on all 4 wheels.If your left front hub wheel speed sensor is sending a false signal when turning this can cause the anti lock brakes to lock up the left front tire like this here and cause this issue.This is fairly common when this speed sensor is sending an incorrect signal.It may have been damaged when the alignment was checked or performed as I have seen before.

If they have not checked the wheel speed sensor signals on a scan tools data list when driving your vehicle when this fault occurs this needs done.If the signal for the left front speed sensor shows erratic when the lock up occurs I suspect the speed sensor needs replaced.This is common.There is also a chance when the wheel was left loose that this may have damaged the wheel bearing in the left front hub which can damage the tone ring for the wheel speed sensor and may need replaced.

If they have not looked into this as a possible fault here this needs done to see if the sensor or hub/bearing assembly needs replaced as this is most common for this fault.If you find out that they did check into this let me know.

If more help is needed, use the reply tab to continue our conversation. If no further assistance is needed, kindly rate my service,your 5 star rating is appreciated.You can rate at any time and we can continue to work on your question as this will not close out your question.Keep in mind in some cases it can be difficult to fully diagnose or help repair your vehicle without seeing it and I work on delivering the best possible answer from what I see to work with.

Thanks Pete

O.k.,if you can let me know what codes set with this issue here as well this will help.It does sound like something was damaged when they lifted your vehicle.

Thanks Pete

Did they check for any damaged wiring leading to the abs control unit that may be affected when turning?

If you can get a list of what has been checked or done this will help let me know.

Thanks Pete

I apologize for the delay.

Did they check the steering box already since you last posted and did it resolve the issue here?

If they are off just slightly when it was installed with the steering shaft alignment it is possible that this is the issue here.

If it never came off then most likely this is not the cause here.

It is possible it rotated but usually it would be rotated back if this was the case on install.Did the rep say why they think this is the cause here?

I apologize for all of this that you have gone through.With the yaw sensor and steering angle sensor not reading properly together there is a good chance all that was needed was the recalibration which is very possible they may not have done.I have seen this before and they may have covered it up by removing and reinstalling the steering box.Please don't run your car into a tree.If it comes back on let me know and maybe I can make a call to a couple people to get their input as well so we can get this corrected.I hope that the light stays off and all is well but if not let me know.

Thanks Pete

Ask them to drive it for a day or two if you can go without it.This way they can see if the fault is gone.I have done that before with several of my customers to ensure the issue had been corrected especially when the customer lived so far away.

I am in the US but have been told in some cases by the dealer I had worked at that I am to honest if that helps any.But there are some facilities that like to guess or misdiagnose and over charge etc.I do what I can to help and try and put myself in customers positions as I know what its like to go through something like this here.I will await your reply and hope for the best.

Thanks Pete

Your welcome

I am online today off and on.

Yeah most likely all that was needed originally is the relearn.It sounds like they messed up.I wish you had a way to get some of your funds back but glad to hear it is operating properly now,

Thanks Pete