How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Peter Zavarelli Your Own Question
Peter Zavarelli
Peter Zavarelli,
Category: UK Car
Satisfied Customers: 28770
Experience:  Technical Consultant at Just Answer
Type Your UK Car Question Here...
Peter Zavarelli is online now
A new question is answered every 9 seconds

We have a E70 which has a parking brake failure and dynamic

Customer Question

Hi we have a E70 which has a parking brake failure and dynamic damping control failure. Both come on the minute you turn the ignition on. I have plugged it into our Delphi system and it has returned the following codes: 600E. 6011E , 6031, 6DDB, 6E6F, 6E09. With regards ***** ***** parking brake we are pretty confident it is the actuator at fault but stuck on the dynamic damping control
Vin: WBAFF02000L294310
Submitted: 1 year ago.
Category: UK Car
Customer: replied 1 year ago.
Also, if it is a failed dynamic drive module, can we buy a second hand one, and if so, do they require coding?
Expert:  Peter Zavarelli replied 1 year ago.
My name is ***** ***** I am a professional here at Just Answer. I noticed that your question had not received a response and thought I would see if you still need help with this.I apologize for the delay and I hope I can still assist you with this here.My info is somewhat limited on your model here but I had seen no one else has responded and would like to see if I can help here.If at any time you feel that I cannot help with this please let me know. The codes you have set here are for a fault with the electromechanical parking brake control unit internal failure.The control unit usually fails internally and sets off these codes here.This would be the module itself.I wouldnt rule out the actuator as the cause here as well though as sometimes it can fail and may short out the control module.Usually it does need programmed to your vehicle by a dealer after it is installed.I believe a used one can be used as long as it is programmed to your model but it is always best to go with a new or rebuilt one to be safe. If more help is needed, use the reply tab to continue our conversation. If no further assistance is needed, kindly rate my service.You can rate at any time and we can continue to work on your question as this will not close out your question.Keep in mind in some cases it can be difficult to fully diagnose or help repair your vehicle without seeing it and I work on delivering the best possible answer from what I see to work with.Thanks Pete