How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Marty Your Own Question
Marty
Marty, European Car Expert
Category: UK Car
Satisfied Customers: 407
Experience:  ASE & Bosch Certified Master Tech. Over 30 years experience.
13230946
Type Your UK Car Question Here...
Marty is online now
A new question is answered every 9 seconds

Volkswagen 2.8 v6 4motion: Right got a v6 4motion got 3 errors

Customer Question

Right got a v6 4motion got 3 errors on ecu, one is maf one is throttle response one is 02 sensor they all say low circuit, changed maf still not any better, traction light comes on with epc and management light runs in lean mode and curs out on when epc n traction light comes on or goes out idling around 750 revs even when cold
Submitted: 2 years ago.
Category: UK Car
Expert:  Wolfgang replied 2 years ago.
hello there i'm Wolfgang here to assist. i do need some info ! first i do need to know what model vehicle you have.second can you list the fault code #'s that are stored?third in the back where the spare tire , there is a 3x5 white sticker . can you provide that pic of the sticker which has codes so i can get the repair information of the vehicle with wiring diagrams.thanks
Customer: replied 2 years ago.
Hi Wolfgang i will tell you codes and numbers of ticket in boot the codes are p0571,p0102,p1198 traction light on epc and management light on running lean exhaust exstreamly spluttery at just over 1000 revs and 2000 revs idles cold and warm at same revs, its a 2002 v6 4motion 2.8l i i cant send photo of sticker unless i have your mobile number it wont let me attatch files
Customer: replied 2 years ago.
Engine code and trans code is bde drp lazw vv
vehicle ident no is wvwzzz 1j z 2d355297
type 1j1 3wj
golf v6 4-mothighL
150kw 6-g
at top of ticket is 1630 15-5-4164 210en
Expert:  Wolfgang replied 2 years ago.
ok that info will work!!! let me get the manual information pulled up and will get back asap!!! thanks
Customer: replied 2 years ago.
Ok pal thanks
Expert:  Wolfgang replied 2 years ago.
ok is fuse 43 blown ? if not do you have 12 volts at pin 2 of the mass air flow sensor while running and unplugged?
Customer: replied 2 years ago.
I shall check tonight Wolfgang and get back to you asap pal
Customer: replied 2 years ago.
No fuse 43 red and its got power there are three other management fuses i will check for current on these too
Expert:  Wolfgang replied 2 years ago.
do you have 12 volts at pin 2 of the mass air flow sensor engine running?
Customer: replied 2 years ago.
No only 5 volts on maf, throttle body, and there is continuity between pins on sensor on induction pipe
Customer: replied 2 years ago.
All fuses in car fine all 25 amp fuses 12 volts etc now just engine management light on epc and traction gone out car no horse power and exhaust noisey n sluggish
Expert:  Wolfgang replied 2 years ago.
note pin 2 blue/yellow wire must have 12 volts measure pin 2 to battery ground
Customer: replied 2 years ago.
On that wire 14/15 volts with engine checked battery 14/15 volts the same
Customer: replied 2 years ago.
With engine on
Customer: replied 2 years ago.
What about throttle body and egr valve as it stinks when its running
Customer: replied 2 years ago.
And its like the engine is suffocating
Expert:  Wolfgang replied 2 years ago.
ok if you have vag com i do need to know what is the values of measure value block 32, 1,2,3 please let me know