How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Rob Your Own Question
Rob, Home Appliance Technician
Category: UK Appliance
Satisfied Customers: 3409
Experience:  20 yrs. experience with a major worldwide manufacturer.
Type Your UK Appliance Question Here...
Rob is online now
A new question is answered every 9 seconds

My diahwasher will notfill with water it will start for a

Customer Question

my diahwasher will notfill with water it will start for a few minutes then it will start beeping as if it was finished it wont move to another program i had the same problem early this year and the engineer said it just needed to reprograme he said to hold down the button for a while then it would start i did that and nothing happened it is ZANUSSI ZDT41
JA: Just to clarify, what's the make and model of your dishwasher? And have you run a diagnostic test cycle?
Customer: ZANUSSI ZDT 41 911D53-06 PNC 911539 041 03 SNO 04797688
JA: Do you plan on doing the work yourself?
Customer: well it cost 65 euros just for few minetus so i thought i would
JA: Anything else we should know to help you best?
Customer: no
Submitted: 10 months ago.
Category: UK Appliance
Expert:  Daniel replied 10 months ago.

Hi, I'm Daniel welcome to JustAnswer, Im reviewing your question now and will post back with your reply momentarily

Expert:  Daniel replied 10 months ago.

When it starts beeping if you look at the end of cycle light which is the picture of the arrow is this flashing?

If so then count the number of flashes from it inbetween the pause and let me know.

Customer: replied 10 months ago.
over 20 times nd that was 30 wash
Expert:  Daniel replied 10 months ago.

Ok thats not what i would have thought it would give.

Lets try another way.

Look at the row of buttons on the control panel and number them from left to righ with 1 on the left.

Open the door and turn the dishwasher off.

Press and hold buttons 1 and 3 and keep them held in and turn the dishwasher on.

Keep the buttons held in for several seconds till the leds start to flash then let go.

wait till the lights stop flashing and then press button 1 once.

Now the end of cycle will be flashing. Count the number of flashes from it in between the pause and let me know.

Then turn the dishwasher off again and let me know what you found.