How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Daniel Your Own Question
Daniel
Daniel, Home Appliance Technician
Category: UK Appliance
Satisfied Customers: 16534
Experience:  25+ yrs. experience in white goods repair. NVQ Level 2 electronics manufacturers training courses.
15468697
Type Your UK Appliance Question Here...
Daniel is online now
A new question is answered every 9 seconds

H20 fault code on hotpoint drier-all filters clear and water

Customer Question

h20 fault code on hotpoint drier-all filters clear and water condenser tank is empty-stops after a few minutes?
Submitted: 2 years ago.
Category: UK Appliance
Expert:  Daniel replied 2 years ago.

Hi

Normall when you get this fault its down to the pump at the back not pumping the water up to the bottle so its activating the water switch.

What you need to do is look on the back in the bottom right corner.

There you will see the pump in a plastic housing unit.

Use a flat screwdriver and insert it behind the tabs that goes into the back panel and prise them out.

Then you can remove the pump from the chamber.

From there give the container a good clean out as fluff builds in there and blocks it.

Also make sure the pump impeller is ok and not broken.

Then refit it and retry it and see how it goes. Fingers crossed that sorts it but if it happens again then the pump will need to be replaced to cure this.

If you need anymore info just get back to me.

Regards