How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Kelly Your Own Question
Kelly
Kelly, Appliance Technician
Category: UK Appliance
Satisfied Customers: 22263
Experience:  Highly accurate diagnostician with over 30 years experience!
11418111
Type Your UK Appliance Question Here...
Kelly is online now
A new question is answered every 9 seconds

Hello ,I have an Indesit washer dryer wd12x. The programme

This answer was rated:

Hello ,I have an Indesit washer dryer wd12x. The programme knob goes round after the first fill of water.The led flashes eight times.
Hi, my name is XXXXX XXXXX I look forward to helping you! That error (F08) indicates that the heater relay cannot be activated. I would begin by removing the top panel to access the main control PCB to inspect for poor solder connection. Let me know what you find.
Customer: replied 3 years ago.

It won't be until tomorrow before I can do what you have suggested.When I have I will rate how helpful your advice has been.


 


 


Regards,


 


 


 


Nigel

Oh sure, just reply when you can.
Customer: replied 3 years ago.

Hi, It is now flashing fifteen times. The machine still runs O.K. on the spin cycle.


 


 


Regards,


 


 


 


Nigel Smith

That error means the water has not drained properly. Is there water left in the tub at cycles end?
Kelly and other UK Appliance Specialists are ready to help you
Customer: replied 3 years ago.

Thank you for your help...I have run two cycles successfully.


 


 


Regards,


 


 


 


Nigel Smith

Customer: replied 3 years ago.

There is no water in the tub and when I open the water trap only a small amount of water comes out.It is showing fifteen flashes ,and it will not work on the rinse cycle.


All this after doing two cycles without any problem yesterday.


 


 


Regards,


 


 


 


Nigel Smith

With the erratic operation, it sounds to me like the main control module is faulty.