hello, I have a problem with my dishwasher. Its a bosch

I think it helped!! I couldn't see any blockings, but took it apart anyway and cleaned it. Especially the red anti flood device was very dirty, just the slimy stuff you get from water, so i suspect that it got stuck in the up position and shut off the water. Is the program supposed to cycle as normal even though the anti flood device has been activated? If this is the case, the problem is fixed i guess!

I'm running a program now with the left side open and when the appliance got water, the anti flood device kept going up and down a bit for a few secs, occasionally stopping the water inflow but immediately releasing it again. It did fill up properly. I did not take out the hose from the pressure chamber to the wash motor, I don't know how. Can you tell me please? I would lik to check it for small blockages, just to be safe..

OK, test run is still going, but looks fine. I'll take it out after and clean it.

Is the program supposed to cycle as normal even though the anti flood device has been activated and there's no water coming in?

Does it matter that the anti flood device kept going up and down a bit for a few secs, occasionally stopping the water inflow but immediately releasing it again?

Thanks

Hey again.

Almost through the program, the time indicator swithed to 199 mins... Is that normal?

thanks

it jumped back to 15 mins from 120 mins. I let it finish and took out the pipe. Had to put the appliance on its back. Pipe is apprx. 15 inches long. It wasn't blocked at all, little slimy stuff inside but not near enough to block it... Any advice on what i can do now?

Thanks