How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Jack Your Own Question
Jack
Jack, Technician
Category: TV
Satisfied Customers: 9573
Experience:  40 years experience as audio,video repair and installation tech
39158752
Type Your TV Question Here...
Jack is online now
A new question is answered every 9 seconds

I have a JVC TV and Comcast cable. I have a comcast universal

Resolved Question:

I have a JVC TV and Comcast cable. I have a comcast universal remote but no longer have the book to program the remote and tv together. Can you give me the steps to program the comcast remote to also work the TN. As in turn up and down volume and turn tv on and off? Thanks,
Submitted: 5 years ago.
Category: TV
Expert:  Jack replied 5 years ago.

Jack :

Hi and welcome bcak to justanswer.
To answer your question;
As there are different types of comcast remotes, i will give you the code search procedure that stays the same on all their remotes.

Jack :

Here it is;

1. Turn on your TV.
2. On the remote control, press TV
once.Then press and hold Setup
until the TV key blinks twice, then
release Setup.
3. Enter 9 - 9 - 1.The TV key will
blink twice.
4. Aim the remote control at the the
TV and slowly alternate between
pressing Power and TV.
Stop when the TV turns off.A
working code has been found.
NOTE: In the search mode, the remote
control will send IR codes from its
library to the selected device, starting
with the most popular code first.
5. Press Setup once to lock in the
code.The TV key will blink twice.

Jack :

Hope this help and let me know if you have any questions.

Customer:

ok, thank you. I will try this and see if this works.

Jack :

If it was programmed to work before then it means that remote is capable of controlling this tv`s functions.
Therefore you should be able to re-program it with the procedure i gave you.

Jack :

Just make sure you do not go too fast while pressing the POWER/TV buttons or you may overshoot your code and will have to start again.

Jack :

Good luck

Customer:

IT WORKED, THANKS!

Jack and 3 other TV Specialists are ready to help you