Transmissions

Have Transmission Questions? Ask a Mechanic for Answers ASAP

Ask an Expert,
Get an Answer ASAP!

Related Transmissions Questions
I have a 6 Speed Allison 1000 in a 2008 GMC Sierra 2500HD.
I have a 6 Speed Allison 1000 in a 2008 GMC Sierra 2500HD. The transmission has recently started running hot (about 215 degrees) it usually runs around 175. I've checked the transmission fluid, and it… read more
Jared D
Jared D
Shop Supervisor
Bachelor's
2,327 satisfied customers
I replace the a& shifting solenoid ,fluid and filter.
I replace the a&b shifting solenoid ,fluid and filter . Transmission will not shift into 3rd gear or overdrive.1 and 2 shift fine shift fine RPM races if I try to go over 50.I can press gas to floor i… read more
Tim's Auto Repair
Tim's Auto Repair
Mechanic
High School or GED
513 satisfied customers
I have a cj7 installed v8 350 engine and 1998 Chevy suburban
I have a cj7 installed v8 350 engine and 1998 Chevy suburban tranny , now it doesn't change gear, thanks… read more
kalamykid
kalamykid
Pactor automotive
Vocational, Technical or Trade Scho
5,398 satisfied customers
Allison transmission jumps out of gear and I rev it a couple
Allison transmission jumps out of gear and I rev it a couple times and it drops in and stays in low gear and wont shift up....I turn off the engine and sit for a minute and it finally starts to shift.… read more
GM Tech (Cam)
GM Tech (Cam)
Owner/Technician
Vocational, Technical or Trade Scho
26,869 satisfied customers
Just put a rebuilt autozone transmission in my 96 GMC
Just put a rebuilt autozone transmission in my 96 GMC sierra. 5.7. Changed ignition switch, speed sensor on transfer case. Also I changed the ignition module on motor. The truck drove great around far… read more
Gary
Gary
ASE Certified Technician
Vocational, Technical or Trade Scho
18,051 satisfied customers
Gotta 91 chevy 1500 with a enging swap from a 4.3 v6 to a
gotta 91 chevy 1500 with a enging swap from a 4.3 v6 to a 1995 5.7 vortec 350 with a 4l60e transmission. i am trying to find the correct diagram to hook up the transmission to the motor to sync correc… read more
Ron
Ron
Automotive Tech
Vocational, Technical or Trade Scho
37,455 satisfied customers
Ram hemi 2x4: I have a 2011 ram that's gotten stuck in 4th
I have a 2011 ram that's gotten stuck in 4th gear. "Limp home mode" codes are p0750 and p0882. Could this be related to a faulty TIPM?… read more
sprinkles08
sprinkles08
Technician
High School or GED
18,065 satisfied customers
Dodge 2500: 2005 2500 4x4 5.7 hemi auto.was driving down highway
2005 2500 4x4 5.7 hemi auto.was driving down highway about 70 when transmission just quit..now will do nothing in forward gears..but reverse works normal..70000 miles on it.… read more
sprinkles08
sprinkles08
Technician
High School or GED
18,065 satisfied customers
chevy k1500: 1993 chevy silverado 4x4. 5.7L. 4l60e transmission.
1993 chevy silverado 4x4. 5.7L. 4l60e transmission. What year transmission will interchange with this vehicle?… read more
Gary
Gary
ASE Certified Technician
Vocational, Technical or Trade Scho
18,051 satisfied customers
Chevrolet Silverado 1500: I HAVE A 1993 CHEVY SILVERADO AND
I HAVE A 1993 CHEVY SILVERADO AND I HAVE TO LET OFF THE GAS FOR IT TO SHIFT FROM 1ST TO 2ND IT IS A 4L60E TRANS… read more
Joe  Barfield
Joe Barfield
Retired-Disabled
Master Aamco
1,303 satisfied customers
GMC Yukon: Hello, I have a 2004 GMC Yukon SLT 4x4 with the
Hello, I have a 2004 GMC Yukon SLT 4x4 with the 4l60e transmission. Recently I lost all forward gears and reverse. If I let the vehicle sit for a few minutes I could shift into reverse and the truck w… read more
GM Tech (Cam)
GM Tech (Cam)
Owner/Technician
Vocational, Technical or Trade Scho
26,869 satisfied customers
Ford F-150: 1996 Ford F-150 4.9 L6 engine/auto trans. Hello,
1996 Ford F-150 4.9 L6 engine/auto trans. Hello, I'm about to change the tranny in this truck but I'm not exactly sure what tranny it is. I know it's an automatic but thats about it. My question is, w… read more
Ron
Ron
Automotive Tech
Vocational, Technical or Trade Scho
37,455 satisfied customers
GMC Yukon: My son has a 1996 Yukon. It has been fine until
My son has a 1996 Yukon. It has been fine until this afternoon when the transmission started making a whine and started slipping. He was less than a mile from home. Fluid level was correct. No burnt s… read more
Dave Nova
Dave Nova
ASE Certified Tech
Associate Degree
98 satisfied customers
pu: I have a 1993 GMC pickup and I have a problem with my transmission.
I have a 1993 GMC pickup and I have a problem with my transmission. If I take off too fast or try to use the passing gear ,the engine will just rev up.If I take off normal it seems to shift ok,but it … read more
kalamykid
kalamykid
Pactor automotive
Vocational, Technical or Trade Scho
5,398 satisfied customers
Transmissions 4L60E: 98 chevy tahoe, 5.7l, 4wd, 4l60e. I changed
98 chevy tahoe, 5.7l, 4wd, 4l60e. I changed the oil and filter and having forgot about the torque converter I overfilled. Having not driven it I removed the pan and got the level back down to hot add … read more
Dave Nova
Dave Nova
ASE Certified Tech
Associate Degree
98 satisfied customers
Transmissions th700R4: Hi! I put a rebuilt 4L60 Transmission
Hi! I put a rebuilt 4L60 Transmission in my restored 1979 Gmc pickup about 6 or seven years ago. Now for the past year or so ive noticed a huge oil leak on the underside of my cab right above the exte… read more
Gary
Gary
ASE Certified Technician
Vocational, Technical or Trade Scho
18,051 satisfied customers
Chevrolet Suburban: 1993 Suburban. Overhauled 4L60E,with shift
1993 Suburban. Overhauled 4L60E,with shift kit,won't shift into 3rd till 30 mph,4th won't shift till 40 mph.… read more
Joe  Barfield
Joe Barfield
Retired-Disabled
Master Aamco
1,303 satisfied customers
CHEVY Z-71 PICKUP: I rebuilt my 4l60e transmission in a 1987
I rebuilt my 4l60e transmission in a 1987 chevy truck and I have low line pressure. 60 psi at idle and will only go up about 10 lbs when you raise rpm. Reverse 70 psi. Trans. shifts thru all gears and… read more
GM Tech (Cam)
GM Tech (Cam)
Owner/Technician
Vocational, Technical or Trade Scho
26,869 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

< Previous | Next >

Meet the Experts:

Chris (aka- Moose)

Chris (aka- Moose)

Technician

1,963 satisfied customers

16 yrs. experience with auto, manual, & CVT drivelines

Tim&#039;s Auto Repair

Tim's Auto Repair

Mechanic

513 satisfied customers

I have been rebuilding automatic transmissions for 25 years

Gary

Gary

ASE Certified Technician

18,051 satisfied customers

25 years GM master tech

Matt

Matt

Engineer

161 satisfied customers

Mechanical Engineer BEng Hons22 years experience in car engine industry, 10 years in formula 1

Mike Kelly

Mike Kelly

ASE Certified Technician

150 satisfied customers

17 years experience as an auto mechanic, foreign and domestic. 5 years running my own repair business.

Dave Nova

Dave Nova

ASE Certified Tech

98 satisfied customers

ASE Master Certification. 25 yrs experience

Marty

Marty

Bosch Certified Technician

94 satisfied customers

Bosch certified master technician. Over 35 years experience.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x