How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask sprinkles08 Your Own Question
sprinkles08, ASE Certified Technician
Category: Transmissions
Satisfied Customers: 22815
Experience:  Chrysler/Dodge/Jeep master tech ASE Master and Advanced Certified, Chrysler/Dodge/Jeep Master Certified, Trans Specialist
Type Your Transmissions Question Here...
sprinkles08 is online now
A new question is answered every 9 seconds

Bob..I have a Chrysler ..New Yorker..changed..transmission

Customer Question

Hello Bob..I have a Chrysler ..New Yorker..changed..transmission in limp mode...,R,D,N,P.eill not pass second gear..changed..speed sensors..input.output, changed solenoid pack..checked about to has no ground wire from Trans. Car bi..changed that next..of does not work..buying a Nissan.
Submitted: 1 year ago.
Category: Transmissions
Expert:  sprinkles08 replied 1 year ago.

Hello and welcome to JustAnswer!

It's possible that there could be an issue in both replacement transmissions but it's not really that likely. If the trans has been replaced twice, the speed sensors and solenoid pack have been replaced then I would suspect a wiring, TCM or possibly a trans relay issue. You can swap the trans relay with another to see if that helps.

The first step in diagnosing the problem is seeing what fault codes are set in the TCM. Do you know what codes are currently setting?

Customer: replied 1 year ago.
cannot said..solenoid pack...we changed it..i might putting the car to the side ..jjust bougt a nissan ...Altima...I will try to fix this car later...2008 Nissan Altima...purchased...going to give the car charity...already spent $2400 on both transmission...motor has 150 000 mi;es//1995...not bad...good car for project....antique.
Expert:  sprinkles08 replied 1 year ago.

If it's setting a solenoid circuit code and the solenoid pack has been replaced with a new part then it could be a wiring or TCM issue, but it's more likely a wiring problem. It could be high resistance, an open or short to power or ground.