Have Toyota Questions? Ask a Mechanic for Answers ASAP

Ask an Expert, Get an Answer ASAP!

Toyota Water Pump Problems

Is your Toyota running hot or losing water? Do you wonder if your water pump needs replaced? The Toyota water pump is a reliable device, but over time problems can occur. If these are not attended to in time, the engine can overheat and major damage could result. Car owners who are aware of the nature of the problems they face and the repairs that need to be done are best placed to have their water pump problems resolved. However there are times when questions come up regarding repair and options.

Read below where Experts have answered questions regarding Toyota water pump repair.

How can a water pump be replaced on a 2007 Camry XLE?

The first step is to drain the system and remove the drive belt. A 12mm wrench is usually needed to remove the pump pulley bolts. On the front of the pump the crank sensor wire will be seen. It is attached by a metal bracket. Remove this first and only then disconnect the crank sensor which is above the alternator. Now look for a clip at the bottom of the pump and carefully pry this off. Now the sensor wire can be pulled out and down until the connector is at the pump and the wires fit out of the groove. The remaining bolts can now be removed and the pump pried off. To install a new water pump reverse this procedure.

Is it common for the rubber seal on a 2007 Sequoia Toyota water pump to leak after 83k miles? .

The rubber seal on a water pump will sometimes fail before they normally need replacement. A replacement is recommended at around 90,000 miles, when the timing belt is normally replaced. For a rubber seal to fail at 83,000 miles is uncommon, however rubber parts can be unpredictable.

Does a water hose need to be replaced at the same time a water pump is replaced on a Toyota Corolla?

Since the hoses are subjected to a lot of heat, it is normally recommended to replace all hoses when a water pump is replaced.

If a Toyota water pump is seized on a 1992 Camry and stripped the teeth off and broke the timing belt; can this bend the valves?

The engine in this car is not an interference engine. This means that there is almost no chance of a timing belt break causing the engine valves to bend.

How long does it take to replace the Toyota water pump on a 2007 RAV4?

The typical time needed for this Toyota water pump replacement is between 3.4 to 4 hours. It will be advisable to find a good shop that will quote on these lines.

Toyota water pump problems are often hard to diagnose and if the wrong repairs are done, the result could cause serious engine damage. It is best if car owners have an understanding of the Toyota water pump, the nature of the problem they face and the repair options available to them. This will allow for the right solutions to be applied. Answers and insights form Experts will provide owners with the information they need to ensure that the] correct Toyota water pump repairs are done.
Please type your question in the field below

6 verified Toyota Mechanics are online now

Toyota Mechanics on JustAnswer are verified through an extensive 8-step process including screening of licenses, certifications, education and/or employment. Learn more

Chris (aka-Moose)

Auto Technician

Vocational, Technical or Trade School

1429 positive reviews

ASE Certified Technician

Associate Degree

244 positive reviews

Toyota Technician

Vocational, Technical or Trade Scho

1316 positive reviews
See all Toyota Mechanics