Nissan Versa SL Troubleshooting
Does your Nissan Versa SL have driving issues? Do you need help in troubleshooting your problems and finding the right solutions? Professional help can be invaluable in such circumstances. The recommendations of verified mechanical Experts will guide you to the causes of your problems and the correct solutions.
Here are some questions that Experts have answered.
If a new key for a 2012 Nissan Versa SL has been purchased online, can it be programmed without taking it to a dealer?
All the keys (new and old) will have to be taken to a dealer for programming. This is because the previously registered keys will lose their registration when a new key is programmed. The 2012 and later models of the Versa have a “BCM pin read through Assist” for which the software is usually only available with dealers.
Why does the manual transmission of a 2009 Nissan Versa SL with 43,000 miles slip in 6th gear when accelerating up a gradient?
When accelerating up a gradient, the maximum amount of torque is being applied to the clutch plate. If the plate is worn, the pressure plate will slip under these conditions. While 43,000 mile is early for a clutch to wear out, it is known to happen. The clutch and pressure plate will have to be replaced. It is advisable to use new and not rebuilt parts.
Why does a 2008 Nissan Versa SL with CVT automatic transmission not rev beyond 1,000 rpm when cold?
Case Details: The engine will rev freely in Park and Neutral, but not in gear. Once the blue temperature light goes out, the situation begins to slowly improve until it functions normally.
This problem is often caused by a Transmission Control Module (TCM) software issue or a weak battery. Check the battery first as low amperage can produce these symptoms. If that is not the cause, the TCM program may need to be updated by a dealer.
What causes the driver’s side power window on a 2008 Nissan Versa to intermittently stop half way up and have to be pulled the rest of the way by hand and what is the repair?
Since the window is moving part way up, it is not a switch, regulator or wiring problem that is causing this. The motor is the issue. It is probably worn out and weak. Replacing it should fix the problem. Replacement involves removing the door panel, disconnecting the wires, removing the three bolts securing the regulator to the motor and then swapping the motor out.
What does a P0A200 code mean on a 2007 Nissan Versa SL and is it a simple fix?
Case Details: The Check Engine light is also on.
The code, along with the Check Engine Light indicates that the Air Fuel Ration sensor is faulty. This is like a front oxygen sensor and is mounted on the exhaust manifold before the catalytic converter. It will have to be replaced. The sensor can usually be easily removed but at times it can get jammed in place in which case the manifold will have to be removed to get it out. The sensor should be purchased only from a dealer as the component has been upgraded since 2007.
What causes a barely audible clunking noise from the front wheels of a 2008 Nissan Versa SL when turning left or right and is the repair an urgent one?
The noise is probably from the front strut top bearing. It is a common issue on this model. The repair is to replace the strut mounts and fit a special tube on the coil springs to prevent the problem from recurring. This is not an urgent repair. The noise will not normally get worse and will not affect drivability. In the worst case scenario, it may make the steering harder, but this rarely happens. Repairing it is the driver’s choice.
Why has a 2008 Nissan Versa SL developed a rough idle after the CVT transmission and battery were replaced?
Case Details: In Neutral and Park, the idling is smooth.
The vehicle should be taken back to the shop or dealer that did the replacement. The low voltage from the old battery could have affected the engine settings which will have to be reset. Another possibility is that the idle volume learn procedure will have to be done. Also, a vacuum hose or some other part that was removed to replace the transmission may not have been properly put back in place.
Why has the muffler on a 2007 Nissan Versa SL suddenly become very loud when the accelerator is pressed?
Case Details: The sound drops back to normal levels when idling.
This looks like a pipe going to the muffler having broken. Plug a rag into the exhaust pipe and look for any exhaust leaks while a helper presses the accelerator. Also listen to see if the source of the sound can be detected. The leak could also be from the front pipe where it bolts on to the exhaust manifold. If nothing can be seen or heard, then the muffler may have gone bad inside. The repairs should be done at a dealer or a specialist muffler shop.
Can a remote starter be installed on a 2009 Nissan Versa with an Intelligent Key system?
A remote starter can be installed on this vehicle.
Reading this article will have given you some idea of the types of problems that could arise with a Nissan Versa SL. You will also have seen that the help of professionals makes problem diagnoses and repair decisions much easier. The opinions of verified mechanical Experts will give you the information you need to keep your vehicle running the way you want it. You can contact Experts online to get clear, usable, customized and economical answers to your questions.






