Ford Suspension Problems
A car owner may run into various Ford suspension problems that might disrupt the smooth operation of a vehicle. Some of those problems could be faulty air pumps, defective height sensors, and bad control valves. Normally, these problems could lead to several questions wherein seeking Expert help is the best way out.
Below are frequently asked questions on issues relating to Ford suspension problems that have been answered by the Experts.
What could be the possible reason for a Ford suspension to fail to work properly even after a pump and reserve tank replacement?A problem like this might happen if the height sensor located at the back of the vehicle has gone bad. Most likely, the sensor may not be able to send a proper signal to the module for the rear air bags to inflate, causing the issue to arise.
What can a person do to stop a dashboard from displaying a message that says ‘Ford suspension off’, every time the car is driven?To fix this problem one may have to have the instrument cluster properly configured. This would allow the cluster to receive a command that would help it to effectively understand the deactivated status of the suspension, preventing the message from appearing. In order to perform the configuration, a Ford scanner would be required.
What could be the problem if a Ford suspension fails to raise up and the check suspension light starts to appear?The problem could either be a defective rear height sensor or a leaky rear air bag. The best possible mechanical recourse would be to have the modules inspected for any faulty codes. This would help to figure out the exact cause of the problem. A person would need to use a scan tool in order to do so.
What could cause a Ford suspension air bag to fail to inflate in cool temperature? What could be the best course of action?A faulty solenoid seal may likely cause the issue described. The problem could also occur due to a leakage in the seal. The best course of action would be to replace the faulty parts. However, a person would be better off troubleshooting the issue prior to doing any replacements. One could also seek Expert help to get the correct test procedures and replacement instructions, if required.
Why would a Ford suspension go low at the rear end of a car when going from a parked position on an incline?This could occur if there is a leakage issue with the air springs in a vehicle’s suspension system. The best possible solution would be to have the air springs replaced as otherwise; it may cause damage to the air suspension compressor. However, while replacing the springs, one would need to make sure to change the parts in pairs. Additionally, as a precautionary measure, scanning the air suspension module for any other faults would be a good idea.
What could be the best possible thing to do if the check Ford suspension light appears to be turned on and the car r is not running or leveling?A person might experience an issue like this if the air suspension disable switch is turned off. The best possible thing to do would be to turn that switch on. This should solve the issue. However, if it fails to fix the problem, extracting the faulty codes from the suspension module using a scan tool would be the next best available option. This would help to give a proper idea on how to go about dealing with this problem.
Consulting an Expert for a professional advice is usually a good plan of action, if faced with any Ford suspension problems. This is because, a lot of times, a problem may have several possible reasons for it to occur. A car owner with little or no mechanical experience may not be skilled enough to handle the issue on their own. The Experts on JustAnswer, therefore, may be better suited to help aid in the repair in such a scenario.