Structural Engineering

Ask Structural Engineering Questions and Get Expert Answers ASAP

Connect one-on-one with {0} who will answer your question

Related Structural Engineering Questions
I am looking for an answer to the following questions. How
Hi,I am looking for an answer to the following questions. How much force would it take push in a concrete Foundation wall if the following was in place.1. strength of a concrete wall after 28 days of … read more
Yaw, BSc
Yaw, BSc
24,156 satisfied customers
What is the deflection of 1/4 steel 3x3 angle iron, 16 ft
What is the deflection of 1/4 steel 3x3 angle iron … read more
Yaw, BSc
Yaw, BSc
24,156 satisfied customers
Can I remove these 2 walls if the joists are running with
Can I remove these 2 walls if the joists are running with the wall with the opening? I would stop the other wall right where that door is on the left.… read more
Yaw, BSc
Yaw, BSc
24,156 satisfied customers
I want to lift 400 lb using a 10 ft, 3 x 3 x 3/8" angle as a
I want to lift 400 lb using a 10 ft, 3 x 3 x 3/8" angle as a lever. will it do so … read more
walkereng
walkereng
Consultant
Bachelor's Degree
5,520 satisfied customers
Removing a 14 foot span of load bearing wall that is down
Removing a 14 foot span of load bearing wall that is down the center of my house. The bottom plate of the existing wall falls on top of the existing floor joist overlap and the foundation piers. The w… read more
PaulP324
PaulP324
consulting engineer
MS
1,276 satisfied customers
Concrete block basement wall below load bearing wall, when
concrete block basement wall below load bearing wall , when central force air heating was installed they knocked out 4 ft. of wall to run ductwork in crawlspace , 3 joists are sagging . What size of a… read more
walkereng
walkereng
Consultant
Bachelor's Degree
5,520 satisfied customers
I would like to know how much load I can put on the outside
I would like to know how much load I can put on the outside point of an angle brace. The brace is 2"X2"X1/4" angle iron, it is fixed at the bottom. The horizontal member at the top is also 2" angle ir… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,463 satisfied customers
I have a stick-built home with 2x16 old growth yellow pine
I have a stick-built home with 2x16 old growth yellow pine rafters and a 15ft tributary width. The rafters are reinforced with diagonal 2x4 bracing which runs from about the mid-point of the rafters d… read more
walkereng
walkereng
Consultant
Bachelor's Degree
5,520 satisfied customers
I am using a boat trailer to make a flatbed car hauler
I am using a boat trailer to make a flatbed car hauler trailer. This is a big heavy duty boat trailer. It use to haul a 28ft Bayliner Cabing Cruiser. It is a tandem axle trailer with A hydraulic surge… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,463 satisfied customers
I have a load bearing beam that runs about 12 feet
I have a load bearing beam that runs about 12 feet perpendicular to my front door. The hallway wall that it rests on does not have another wall directly below it to transfer the weight so it is probab… read more
walkereng
walkereng
Consultant
Bachelor's Degree
5,520 satisfied customers
I want to add a beam in order to remove part of a load
I want to add a beam in order to remove part of a load bearing wall. The goal is to open up the living/kitchen … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,463 satisfied customers
I have a single story house with drywall ceilings and no
I have a single story house with drywall ceilings and no attic storage. The center of the house has a load bearing wall that supports the ceiling joists. My kitchen ceiling has 2x6 joists on 16" cente… read more
walkereng
walkereng
Consultant
Bachelor's Degree
5,520 satisfied customers
I have a thick (12" deep) concrete retaining wall, built on
I have a thick (12" deep) concrete retaining wall, built on footings pinned to ledge, on the side of a steep hill. My house is set back, up the hill, and very solidly built on footings and a concrete … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,463 satisfied customers
I have a 35yr old 28 by 56ft 2 story garden level log house(logs
I have a 35yr old 28 by 56ft 2 story garden level log house(logs are 4"by5"). On the 28' by 16' wall I have a 3 window unit measuring 5'by5' and want to add an iron 30"by88" attached balcony outside t… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,463 satisfied customers
1 1/2 x 1 1/2 x 3/16 angle iron back to back by 16 in deep
1 1/2 x 1 1/2 x 3/16 angle iron back to back by 16 in deep built like a truss for 36 ft opening for aircraft hanger door opening. Would this be strong enough?… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,463 satisfied customers
I am looking for an authoritative source that lists the load
I am looking for an authoritative source that lists the load bearing capacity of (2) 4x4x1/4" angle iron over a 30 inch span. I am trying to get my building inspector to allow me to use this to enlarg… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,463 satisfied customers
One floor of our house is above the carport, which is supported
One floor of our house is above the carport, which is supported from beneath by 10"x10" timber posts. There are 3-1/2" x 5-1/2" timbers at a 45 degree angle reinforcing the joists. These connect to th… read more
walkereng
walkereng
Consultant
Bachelor's Degree
5,520 satisfied customers
How heavy of beam would I need to clear span 32 feet in my
How heavy of beam would I need to clear span 32 feet in my garage? This is on a ranch house, nothing but roof above.… read more
walkereng
walkereng
Consultant
Bachelor's Degree
5,520 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

vgdlpc

vgdlpc

Master's Degree

17 satisfied customers

Civil Engineer, Major in Structures and Foundations. Professional Engineer 11 years of experience.

StructuralEng

StructuralEng

Consultant

8,463 satisfied customers

Structural Engineer

walkereng

walkereng

Consultant

5,520 satisfied customers

Over 35 years of Structural Engineering experience.

Shannon Galway

Shannon Galway

-

208 satisfied customers

VP Technical Services at Major Engineering Company

JAYCEG

JAYCEG

99 satisfied customers

Expert

William Purpura

William Purpura

Managing General Partner

52 satisfied customers

Managing General Partner at Dargon Developement

PaulH471

PaulH471

Construction Manager

46 satisfied customers

Expert

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x