Structural Engineering

Ask Structural Engineering Questions and Get Expert Answers ASAP

Connect one-on-one with {0} who will answer your question

Related Structural Engineering Questions
Second opinion] I have a 4.25 inch square wooden beam that
Second opinion] I have a 4.25 inch square wooden beam that is supported by a partial wall for half it's length. I intend to replace the beam but I am looking for ideas on how to strengthen the existin… read more
walkereng
walkereng
Consultant
Bachelor's Degree
4,128 satisfied customers
I want to open a room by removing two load bearing walls,
I want to open a room by removing two load bearing walls, the span is 22 feet, this is a single story residence. what size beam is required. … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,759 satisfied customers
I am adding on to an existing room (which is currently 22
I am adding on to an existing room (which is currently 22 feet wide), and will remove the end wall. The side (load bearing) walls are concrete block, and the new walls will be framed with 2x6's. How s… read more
walkereng
walkereng
Consultant
Bachelor's Degree
4,128 satisfied customers
I thought of another 2 questions. I am adding on to an
Second opinion] I thought of another 2 questions. I am adding on to an existing room (which is currently 22 feet wide), and will remove the end wall. the side (load bearing) walls are concrete block, … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,759 satisfied customers
I have a 3.875 wide "I" beam that is 7 inches tall, in the
I have a 3.875 wide "I" beam that is 7 inches tall, in the center of my basement and it spans about 16 feet but has a post at about 10'. There is 10 feet on one side and there will be 1 wall on the slab 3'f on the other side and I want to know if I can remove that post … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,759 satisfied customers
I would like to remove 8 feet of a load bearing wall. the
i would like to remove 8 feet of a load bearing wall. the house is one story brick, built in 63 with brick on concrete block. the roof is a hip roof, all open inside, just ceiling joists runing front … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,759 satisfied customers
Trying to determine if these walls in the master bathroom
Trying to determine if these walls in the master bathroom are load bearing. There is a former fireplace framing with 2x6s. One board only goes half way up, one is cut and the other is wobbly when I po… read more
walkereng
walkereng
Consultant
Bachelor's Degree
4,128 satisfied customers
We purchased an 1884 foursquare farmhouse in April. We would
We purchased an 1884 foursquare farmhouse in April. We would like to make some structural changes. On the first floor we would like to expand a pantry that is currently about four feet wide across the… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,759 satisfied customers
Planning to vault a ceiling in a 24' (clear span) x 28'
Planning to vault a ceiling in a 24' (clear span) x 28' total span room. Current roof structure is 2x6 rafters 16" oc. Hoping to install douglas fir ridge beam with support framing from concrete found… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,759 satisfied customers
What size microlam is needed for a 22' wide opening? I'm
what size microlam is needed for a 22' wide opening? I'm taking the center support out (3 ft wall between 2 garage door openings ) to create a 22 ft wide continuous span. My intent/plan is to use (2) … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,759 satisfied customers
I would like to install an LVL beam between my living room
Hello, I would like to install an LVL beam between my living room and kitchen, to open the floor space between the two rooms. The current non-load bearing wall that separates the two rooms, has two 2x… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,759 satisfied customers
My 2-storey house has a stairwell opening that is 3ft x 7ft
My 2-storey house has a stairwell opening that is 3ft x 7ft 8in. One long side is on a 2x6 bearing wall on a spread footing. The short sides are double 2x10 continuous floor joists. The other long sid… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,759 satisfied customers
We are wanting to put is french doors in the existing
Hello there, We are wanting to put is french doors in the existing opening to our front room. The existing opening is 77 in with the drywall removed. the door frame is 57 1/2 in wide. Above this wall … read more
walkereng
walkereng
Consultant
Bachelor's Degree
4,128 satisfied customers
I want to open up the wall between my kitchen and living room.
I want to open up the wall between my kitchen and living room. The wall is load bearing. The joists are 2x4 16 inch oc and the attic is non storage non occupied. The attic does hold the HVAC ducts, el… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,759 satisfied customers
I want to remove 14' of bearing to open from the dining room
I want to remove 14' of bearing to open from the dining room to my den which is an existing room addition. Plus want it to be flush ceiling, with no expose beam. The beam will sit on the outer top pla… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,759 satisfied customers
I am designing a beam residence that is carrying a portion
I am designing a beam for a residence that is carrying a portion of 310,000 lb load. I would like to weld two 12x4x.5 HSS beams together to get the proper capacity. The basement walls are all concrete… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,759 satisfied customers
I have a house that is now a two and a half story structure
I have a house that is now a two and a half story structure (basically configured as a Cape Cod structure). The roof trusses have a 2X8 top chord and a 2X10 bottom chord. The pitch is 10/12. The truss… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,759 satisfied customers
Im wondering if I should replace metal support posts in the
I'm wondering if I should replace metal support posts in the basement with a 2x4 wall running the full length under the support beam or should I incorporate the metal posts into the 2x4 wall? Also can… read more
walkereng
walkereng
Consultant
Bachelor's Degree
4,128 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

vgdlpc

vgdlpc

Master's Degree

17 satisfied customers

Civil Engineer, Major in Structures and Foundations. Professional Engineer 11 years of experience.

StructuralEng

StructuralEng

Consultant

9,759 satisfied customers

Structural Engineer

walkereng

walkereng

Consultant

4,128 satisfied customers

Over 35 years of Structural Engineering experience.

Shannon Galway

Shannon Galway

-

208 satisfied customers

VP Technical Services at Major Engineering Company

Matt

Matt

Engineer

69 satisfied customers

Mechanical Engineering Hons degree, been working in automotive industry for the last 18 years - Engine development engineer

William Purpura

William Purpura

Managing General Partner

41 satisfied customers

Managing General Partner at Dargon Developement

ibosley

ibosley

Master's Degree

88 satisfied customers

Mechanical Engineering

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x