Structural Engineering

Ask Structural Engineering Questions and Get Expert Answers ASAP

Connect one-on-one with {0} who will answer your question

Related Structural Engineering Questions
Need header size and no. studs for 2nd floor window 36”
Need header size and no. Jack studs for 2nd floor window 36” rough opening, load bearing, wood frame osb sheathed stucco wall, open truss rafters, in orlando Florida … read more
PaulP324
PaulP324
consulting engineer
MS
1,276 satisfied customers
Im trying to figure out if the egress window Im about to
Im trying to figure out if the egress window Im about to install needs a header. There is no concrete above the window - currently only a 1x6 sill plate and then the 2x10 rim board spans the window an… read more
walkereng
walkereng
Consultant
5,339 satisfied customers
I am building a 20 by 20 Ft Garage - What size fir beam
I am building a 20 by 20 Ft Garage - What size Douglas fir beam would be required for a 16ft span. The garage is built using actual 2 by 4 Douglas Firs Studs. King stud on each end of the garage follo… read more
walkereng
walkereng
Consultant
5,339 satisfied customers
I have framed out a 30” opening in a former exterior wall
Hi! I have framed out a 30” opening in a former exterior wall (now porch) using 2kings and 1 jack with 2-2x8 header. However, I just noticed 6' slider 20” away was only installed with 1 king/ 1 jack. … read more
walkereng
walkereng
Consultant
5,339 satisfied customers
I have a 10' 9.5" double LVL header for a 10' sliding door
Hi I have a 10' 9.5" double LVL header for a 10' sliding door and the carpenter only put one jack stud on each side of it is there engineered wood that coud place of the wood so that we wouldn't need … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,463 satisfied customers
I'm installing a 3' x 7' (h x w) and a 6' wide sliding door
I'm installing a 3' x 7' (h x w) and a 6' wide sliding door on the same non-load bearing wall. There is an existing window in between the new door and window. What size LVL should I use for each? Ther… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,463 satisfied customers
We are cutting a pass through area in an 10 foot interior
We are cutting a pass through area in an 10 foot interior wall that is load bearing. The joists are 12 feet each side. The passthrough will be about 7 feet wide. . I need to know the size of a beam an… read more
walkereng
walkereng
Consultant
5,339 satisfied customers
We need a beam (girder) sized to support a floor. This is
We need a beam (girder) sized to support a floor. This is for a single family stick frame home. The Girder needs to span 12 ft between the jack studs. It will support a typical residential floor with … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,463 satisfied customers
Can i use (1) 1-3/4" x 11-7/8" LVL in loo of (2) 2x12 for
SECOND OPINION] can i use (1) 1-3/4" x 11-7/8" LVL in loo of (2) 2x12 for window header up to 5' opening w/ a 55 PSF roof at a total span of 28' ? … read more
walkereng
walkereng
Consultant
5,339 satisfied customers
Saltbox garage built in 1950's, 12 x 22 attached to house.
Hi, Saltbox garage built in 1950's, 12 x 22 attached to house. Gable is on sides as you face the garage door (ie door is on an end that supports rafters).No second floor.I want to reframe the garage d… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,463 satisfied customers
I have a 15' opening in a load bearing wall. What size LVL
I have a 15' opening in a load bearing wall. What size LVL beam do I need? And how many 2x4 jack studs to support each end? … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,463 satisfied customers
I need to frame out a rough opening for a sliding glass door
I need to frame out a rough opening for a sliding glass door in an exterior NON-load bearing wall. The size of the RO needs to be 121" . The house in on the beach in Florida and is subject to wind loa… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,463 satisfied customers
I have a rough opening of 8' 4" and I want a header size of
I have a rough opening of 8' 4" and I want a header size of 2x8s. Can I use 2 or 3 2x8 laminated (using structural screws ) Fir timbers? The load is one story with no roof load. The span of the floor … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,463 satisfied customers
I own a 1970s mobile home and want to replace the 36" front
I own a 1970's mobile home and want to replace the 36" front door with a new prehung 36" door. The rough opening is 37 1/2" wide and the recommended rough opening for the new door is 38". I want to wi… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,463 satisfied customers
I am planning to widen the door out to my pool from 36" to
I am planning to widen the door out to my pool from 36" to 84". This is a load bearing wall on a two story house with 2x6 construction and 9 ft ceilings. Unfortunately there is drain plumbing that com… read more
walkereng
walkereng
Consultant
5,339 satisfied customers
Hi I am installing two - 1 3/4" x 9 1/2 " Rigidlam Beams,
Hi I am installing two - 1 3/4" x 9 1/2 " Rigidlam Beams, 9' span My Question is Load 1 will be in a 2x4 wall Load 2 will be in the 2x6 wall the T's into the 2x4 wall. The Original load bearing wall i… read more
walkereng
walkereng
Consultant
5,339 satisfied customers
I have a covered porch that many many years ago was enclosed.
I have a covered porch that many many years ago was enclosed. Slab flooring, single story house, West Coast. There is an existing 6x8 header that spans the exterior wall (its framed w/ 2x6 because of … read more
walkereng
walkereng
Consultant
5,339 satisfied customers
Im installing a sliding door with 910" R.O. on an exterior
I'm installing a sliding door with 9'10" R.O. on an exterior load bearing wall in a Cape Cod style home. The floor and ceiling joists run parallel to the exterior wall in question. What type of tempor… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,463 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

vgdlpc

vgdlpc

Master's Degree

17 satisfied customers

Civil Engineer, Major in Structures and Foundations. Professional Engineer 11 years of experience.

StructuralEng

StructuralEng

Consultant

8,463 satisfied customers

Structural Engineer

walkereng

walkereng

Consultant

5,339 satisfied customers

Over 35 years of Structural Engineering experience.

Shannon Galway

Shannon Galway

-

208 satisfied customers

VP Technical Services at Major Engineering Company

JAYCEG

JAYCEG

99 satisfied customers

Expert

PaulH471

PaulH471

Construction Manager

46 satisfied customers

Expert

William Purpura

William Purpura

Managing General Partner

29 satisfied customers

Managing General Partner at Dargon Developement

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x