Structural Engineering

Ask Structural Engineering Questions and Get Expert Answers ASAP

Connect one-on-one with {0} who will answer your question

Related Structural Engineering Questions
Im opening up an exterior wall to fit a 12 foot sliding
Im opening up an exterior wall to fit a 12 foot sliding door. Currently a 9 foot french door is there now. There is a 4 foot wide tiled deck above this door that is not covered with a roof. What size … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,761 satisfied customers
I want to build a plywood box beam for a 44 ft span. The
I want to build a plywood box beam for a 44 ft span. The beams will be on 12 ft centers so they would support a floor area of 528 square feet. Using a design load of 40 pounds per square foot this is … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,761 satisfied customers
Did u answer other questions. How do i attach beam to 4 2x4
did u answer other questions. How do i attach beam to 4 2x4 Studs ? And should i have a support beam in basement directly under 4 2x4 studs at end of beam that is toward middle of house? Other end of … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,761 satisfied customers
I am renovating an older home that has a flat roof framed
I am renovating an older home that has a flat roof framed with 2 x 8's 16" on center supporting the roof structure. Roof is plywood with a foam roof on top so the static load is very low. I have a 20'… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,761 satisfied customers
Is it safe to replace a (100 lbs) steel bathtub (alcove) with
Is it safe to replace a (100 lbs) steel bathtub (alcove) with a (312 lbs) cast iron (alcove) bath tub in a second floor wood framed house bathroom supported by 3 floor joists (each at 1.5"x 8"x 12 ft … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,761 satisfied customers
I want to open up the wall between my kitchen and living room.
I want to open up the wall between my kitchen and living room. The wall is load bearing. The joists are 2x4 16 inch oc and the attic is non storage non occupied. The attic does hold the HVAC ducts, el… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,761 satisfied customers
I have a 3.5 by 9.5 gang lam with posts every 7 feet. If I
I have a 3.5 by 9.5 gang lam with posts every 7 feet. If I want to reduce the height of the lam to 4.5 inches between two posts would 1/4 x 4 inch Steel plate bolted on both sides of the lam restore t… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,761 satisfied customers
Building a floor above my shop. The shop is 20 x 30 feet
Building a floor above my shop . The shop is 20 x 30 feet plan to use a ledger board and hoist hangers on each end with four I beams to support the floor joists with the first and fourth I beam four f… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,761 satisfied customers
I am removing a loadbearing wall in my living room and want
I am removing a loadbearing wall in my living room and want to put in a LVL beam. The house is basically a rectangle about 28 feet by 45 feet. it has 2 floors and the wall I want to replace is on the … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,761 satisfied customers
I am trying to figure out if a wall framed with 2X4s in the middle of the house is structu
I am trying to figure out if a wall framed with 2X4s in the middle of the house is structural. It is a middle unit condo with 2 I beams 11' 6" feet in from the outer walls. The middle of the place is … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,761 satisfied customers
I have a single story house, built in East TX in 1956 with
I have a single story house, built in East TX in 1956 with 1X6 T&G sheathing in on the roof, sheathing the walls, and under the ceiling joists. The den is 27' long and 13.5' wide and is very awkward. … read more
walkereng
walkereng
Consultant
Bachelor's Degree
3,287 satisfied customers
Hello, House is say 50-60 years old. 1st floor bathtub
Hello, House is say 50-60 years old. 1st floor bathtub was cast iron with thick 1.25 inch plaster walls, wire mesh and tile. Drain end of bathtub had sagged to pull away from tile almost 3/4 inch. Flo… read more
walkereng
walkereng
Consultant
Bachelor's Degree
3,287 satisfied customers
I have a new ranch style house with a full basement. I would
I have a new ranch style house with a full basement. I would like to place a 125 gal aquarium on a 72 x 18" stand on the the first floor. Total weight of the setup would be about 1400 pounds. From the… read more
walkereng
walkereng
Consultant
Bachelor's Degree
3,287 satisfied customers
I constructed a table that is 4 feet high 3 feet wide and 8
I constructed a table that is 4 feet high 3 feet wide and 8 feet long. I used 4x4 pressure treated lumber for legs, 3 four foot high legs on each side. Atop each set of 3 legs i attached a 4x4x8 lengt… read more
walkereng
walkereng
Consultant
Bachelor's Degree
3,287 satisfied customers
I built a addition for a hot tub on a deck. I used 2x12 joist
I built a addition for a hot tub on a deck. I used 2x12 joist doubled every 14" apart the beam on the outside is a 6x12 sitting 6x6 posts with a footing 25x25 by 3 feet deep with simpson post base. "O… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,761 satisfied customers
I am placing 2X12 Doug Fir Joists every 12 inches spanning
I am placing 2X12 Doug Fir Joists every 12 inches spanning 14 feet placed on 12X12 beams on top of 12X12 posts. Will this support a hot tub?… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,761 satisfied customers
Water leaked in from the range hood vent (over several years,
Water leaked in from the range hood vent (over several years, I presume), leaked down 2x4 (approx 5 feet) to floor. Plywood flooring and horizontal 2x4 are completely rotten. 4x6 frame beam below is r… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,761 satisfied customers
I am removing a interior wall with a 14ft span, I made a fletch
I am removing a interior wall with a 14ft span, I made a fletch beam using 2x8s with half inch steel plate 7.5inch tall . it is a load bearing wall on the first floor. is this enough support. thanks… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,761 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

vgdlpc

vgdlpc

Master's Degree

17 satisfied customers

Civil Engineer, Major in Structures and Foundations. Professional Engineer 11 years of experience.

StructuralEng

StructuralEng

Consultant

8,761 satisfied customers

Structural Engineer

walkereng

walkereng

Consultant

3,287 satisfied customers

Over 30 years of Structural Engineering experience.

Shannon Galway

Shannon Galway

-

208 satisfied customers

VP Technical Services at Major Engineering Company

Matt

Matt

Engineer

55 satisfied customers

Mechanical Engineering Hons degree, been working in automotive industry for the last 18 years - Engine development engineer

William Purpura

William Purpura

18 satisfied customers

Managing General Partner at Dargon Developement

ibosley

ibosley

Master's Degree

88 satisfied customers

Mechanical Engineering

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x