Structural Engineering

Ask Structural Engineering Questions and Get Expert Answers ASAP

Connect one-on-one with {0} who will answer your question

Related Structural Engineering Questions
I need to know what size steel i-beam I need for a 30' run.
I need to know what size steel i-beam I need for a 30' run. It will support three cross beams of a flat roof. The two end beams will remain under wall support. … read more
StructuralEng
StructuralEng
Consultant
8,655 satisfied customers
I am framing a porch roof. Pitch 2/12 Span 14' Slope stile
I am framing a porch roof. Pitch 2/12 Span 14' Slope stile roofI want to expose the rafters and have them 32” on center. Is that possible? 60lb snow load… read more
StructuralEng
StructuralEng
Consultant
8,655 satisfied customers
I am trying to figure out what size I beam I would need to
I am trying to figure out what size I beam I would need to span 24' , and carry a load of a 2X10 rafter on 16" centers, with steel roofing and 1X6 wood strips … read more
StructuralEng
StructuralEng
Consultant
8,655 satisfied customers
Walkereng, we are still working on the same building. You
Walkereng, we are still working on the same building. You suggested a steel span and I rejected the option because I could not get the beam in and lifted. We could probably do it now. I am assuming st… read more
StructuralEng
StructuralEng
Consultant
8,655 satisfied customers
I am building a free standing patio cover 23 ft by 10 ft
I am building a free standing patio cover 23 ft by 10 ft post to post ( 4 post I was going to use 4x4 steel 1/4 inch thick 6 1/2 ft tall( ontop of a concrete pylaster 3 ft deep 18x18 inch block with r… read more
walkereng
walkereng
Consultant
Bachelor's Degree
3,167 satisfied customers
I am wanting to build a pole barn, and the opening is 24
i am wanting to build a pole barn, and the opening is 24 feet. SO I need to construct a load bearing beam that is 24 feet. … read more
StructuralEng
StructuralEng
Consultant
8,655 satisfied customers
I have a room in a remodel with conventional 8' ceiling that
I have a room in a remodel with conventional 8' ceiling that I want to convert to cathedral. Walls are 2 X 6 - 16"OC - roof is a 4/12 pitch and is … read more
StructuralEng
StructuralEng
Consultant
8,655 satisfied customers
We are building a monoslope roof off existing cavity block
Hi we are building a monoslope roof off existing cavity block with SIP panels compostion is 9mm MGO board either side of an EPS core. The panel size is 2650 x 1200 and the roof size is 13.7m x 6.3m Ho… read more
StructuralEng
StructuralEng
Consultant
8,655 satisfied customers
I am renovating a 1959 ranch home and want to remove the
I am renovating a 1959 ranch home and want to remove the center (lengthwise) wall between the front living/dining area and the rear den/kitchen area. Beam span will be 24ft and span carried(front to b… read more
StructuralEng
StructuralEng
Consultant
8,655 satisfied customers
I'm looking to size a been to carry a roof load in Michigan
I'm looking to size a been to carry a roof load in Michigan (think snow). The beam span is 17 ft and the roof is essentially flat (1/2 : 12 pitch) and it will be full hip in design. The full dimension… read more
StructuralEng
StructuralEng
Consultant
8,655 satisfied customers
I want to cantilever a 1:12 roof 6'. The structure would be on an exi
Hi, I want to cantilever a 1:12 roof for about 6'. The structure would be on an existing light concrete deck supported by 4x10 beams. The existing roof has a 26" overhang. I wonder if I can attach a b… read more
StructuralEng
StructuralEng
Consultant
8,655 satisfied customers
Have a houseboat with sagging ceilings. Ceiling joists are
Have a houseboat with sagging ceilings. Ceiling joists are 1.5x4" actual dimension, 16" on center, spanning 13'. Roof gets some people activity on it, but doesn't need to be 50psf live load design. Be… read more
StructuralEng
StructuralEng
Consultant
8,655 satisfied customers
I need to replace a 4x6 doug fir post that is supporting a
I need to replace a 4x6 doug fir post that is supporting a ridge beam mid span with a small steel I-beam. The 4x12 ridge beam is fully supported at the ends which are 14' in one direction and 8' in th… read more
walkereng
walkereng
Consultant
Bachelor's Degree
3,167 satisfied customers
Require minimum size W beam to support 60 lbs/sq.ft live load
Require minimum size W beam to support 60 lbs/sq.ft live load plus 10 lbs/sq.ft dead load ( total design of 70 lbs. sq.ft.) over a span of 48 feet with one support at 24 feet. Beam will be used to sup… read more
walkereng
walkereng
Consultant
Bachelor's Degree
3,167 satisfied customers
I want to support a clear span over 34. The beam must hold
I want to support a clear span over 34'. The beam must hold 2" X 8" on one end which are 13' long. Above this is a bedroom with bath and pitched roof above that. What steam beam will do the job with o… read more
walkereng
walkereng
Consultant
Bachelor's Degree
3,167 satisfied customers
I am wanting to make an addition to my house. I would like
I am wanting to make an addition to my house. I would like the roof to be a vaulted ceiling. The span from the existing exterior 2x6 wall of the house to the new gable end is 28'. The width of the new… read more
walkereng
walkereng
Consultant
Bachelor's Degree
3,167 satisfied customers
I am doing a remodel and removing a 15 section of wall to
I am doing a remodel and removing a 15' section of wall to open the area up. It is a low pitched roof with the joist lap seamed on this center wall. do you think doing a 2 by 12 strong back attached t… read more
walkereng
walkereng
Consultant
Bachelor's Degree
3,167 satisfied customers
I need to stiffen a 21 long wall that is typical wood construction,
I need to stiffen a 21' long wall that is typical wood construction, with doubled-2X6 vertical studs (pine) on 16" centers, varying in length from 7 1/2' to 16', as the wall is taller on one end than … read more
StructuralEng
StructuralEng
Consultant
8,655 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

vgdlpc

vgdlpc

Master's Degree

17 satisfied customers

Civil Engineer, Major in Structures and Foundations. Professional Engineer 11 years of experience.

StructuralEng

StructuralEng

Consultant

8,655 satisfied customers

Structural Engineer

walkereng

walkereng

Consultant

3,167 satisfied customers

Over 30 years of Structural Engineering experience.

Shannon Galway

Shannon Galway

-

208 satisfied customers

VP Technical Services at Major Engineering Company

Matt

Matt

Engineer

55 satisfied customers

Mechanical Engineering Hons degree, been working in automotive industry for the last 18 years - Engine development engineer

William Purpura

William Purpura

16 satisfied customers

Managing General Partner at Dargon Developement

ibosley

ibosley

Master's Degree

88 satisfied customers

Mechanical Engineering

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x