Structural Engineering

Ask Structural Engineering Questions and Get Expert Answers ASAP

Connect one-on-one with {0} who will answer your question

Related Structural Engineering Questions
I wish to build a deck 36 feet 16 feet wide framed with
I wish to build a deck 36 feet long 16 feet wide framed with W8X10 beams. There will be a 3 ft foot cantilever along one 36 foot side. The deck joist will be 12 ga 8 inch CEE 2 1/2 inch flange on 16 i… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
7,484 satisfied customers
I need to know size of I beams or w beams I'll need to span
I need to know size of I beams or w beams I'll need to span 16' and be able to drive 5 ton truck across safely. Assume I'll use 2-4 beams anchored on concrete piers both ends … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
7,484 satisfied customers
I'm looking for a beam size. Going to lift off a garage roof
Hi, I'm looking for a beam size. Going to lift off a garage roof weighing roughly 3,500 lbs. Going to place it under the ridge beam (shoring up the truss framing) and lift it from a crane from 3 or 4 … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
7,484 satisfied customers
I'm building a bridge crane with posts on 27' centers on
Hi. I'm building a bridge crane with posts on 27' centers on both sides of runway. I'm looking at using 21" x 101lb beams for runway with 2-1/2" square solid bar on top for end truck wheels. Looking a… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
7,484 satisfied customers
I would like to know if two 14" x 26# wf beams, at a span of
I would like to know if two 14" x 26# ***** beams, at a span of 43', with 3" channel cross members every 16", will hold 60k lbs? … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
7,484 satisfied customers
I have to hold a 1500 lbs light bar in a house. The bar is
I have to hold a 1500 lbs light bar in a green house. The bar is 64 feet long. I can support the beam every 16 feet. The weight is evenly distributed. How big of an i beam do i need and how big do the… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
7,484 satisfied customers
I need to replace a failed roof header. It is supporting 10'
I need to replace a failed roof header. It is supporting 10' deep x 20' wide section of a flat roof. I would like to know what size steal and laminate beam could support the load, the building is loca… read more
walkereng
walkereng
Consultant
Bachelor's Degree
3,338 satisfied customers
How large of a steel I beam do I need to pull 17,000 pounds
How large of a steel I beam do I need to pull 17,000 pounds of pipe on a 2x4 rail system. I already have a hydraulic winch capable of pulling a max of 30K (Warn 30xl) The maximum span of the beam woul… read more
walkereng
walkereng
Consultant
Bachelor's Degree
3,338 satisfied customers
I am building a deck off of my house and I need help
I am building a deck off of my house and I need help determine the size of an I beam that will be needed to support the loading. The beam needs to be 15 feet long, with two support columns on either e… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
7,484 satisfied customers
Strength required for steel supports? Hi, I am trying to
Strength required for steel supports? Hi, I am trying to find out what type of steel supports I need for a project. The project is that we need to raise a shipping container(5300 lbs, 8x8x40') off the… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
7,484 satisfied customers
I need to elevate an oilfield skid. I plan to use I beam.
I need to elevate an oilfield skid. I plan to use I beam. I need to elevate the skid 12". The skid is 22,000 pounds. I plan on using 6 pieces, 4 on each corner, two in the middle (the skid is only 20'… read more
walkereng
walkereng
Consultant
Bachelor's Degree
3,338 satisfied customers
I am building a spreader bar for lifting molds off of a truck
I am building a spreader bar for lifting molds off of a truck and setting on a roller cart. I have to lift with two overhead cranes. The spreader bar will be 10 feet long, and I am planning on welding… read more
walkereng
walkereng
Consultant
Bachelor's Degree
3,338 satisfied customers
I want to build a horizontal platform from 6061 grade 1/4"
I want to build a horizontal platform from 6061 grade 1/4" aluminum plate and I beams. The platform will be 19' wide by 12' deep. One end of the platform will supported by a sturdy wall comprised of 6… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
7,484 satisfied customers
I want to mount 2 each 72 inch diameter vessel ( total weight
I want to mount 2 each 72 inch diameter vessel ( total weight with media and water ) 32,000 lbs. The skid will be 96 inches wide and 192 inches long. The vessels will have 4 welded structural legs and… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
7,484 satisfied customers
How much static weight will a W10"x15(lb/ft)x26 steel I-beam
How much static weight will a W10"x15(lb/ft)x26' steel I-beam support at one end of it, if that end is cantilevered 6 feet beyond a supporting column, (assuming the rest of the beam is solidly support… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
7,484 satisfied customers
I am building a ramp for a client that will be used for moving
I am building a ramp for a client that will be used for moving a jet ski up into an outbuilding. The trailer with jet ski weighs 1000 lbs. (two wheels) and the truck weighs 4000 lbs. (4 wheels). The r… read more
Mr T Licensed Engineer
Mr T Licensed Engineer
2 satisfied customers
Re: Two 2x6 std. pine joists glued and bolted together along
Re: Two 2x6 std. pine joists glued and bolted together along 10 feet. If I support this beam on two truck bed racks, front and rear, leaving a 4 foot cantilever, how much weight would the cantilever l… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
7,484 satisfied customers
Looking to build a travel trailer frame as light as possible.
Looking to build a travel trailer frame as light as possible. Frame length would be roughly 28' long, carrying roughly 6000 lbs (40% weight over axles), and dual axle. what size beams would I need? co… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
7,484 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

vgdlpc

vgdlpc

Master's Degree

17 satisfied customers

Civil Engineer, Major in Structures and Foundations. Professional Engineer 11 years of experience.

StructuralEng

StructuralEng

Consultant

7,484 satisfied customers

Structural Engineer

walkereng

walkereng

Consultant

3,338 satisfied customers

Over 30 years of Structural Engineering experience.

Shannon Galway

Shannon Galway

-

232 satisfied customers

VP Technical Services at Major Engineering Company

Matt

Matt

Engineer

56 satisfied customers

Mechanical Engineering Hons degree, been working in automotive industry for the last 18 years - Engine development engineer

William Purpura

William Purpura

19 satisfied customers

Managing General Partner at Dargon Developement

ibosley

ibosley

Master's Degree

88 satisfied customers

Mechanical Engineering

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x