Structural Engineering

Ask Structural Engineering Questions and Get Expert Answers ASAP

Connect one-on-one with {0} who will answer your question

Related Structural Engineering Questions
I need to ride. Sorry ..typo. I have a existing garage with
Sorry ..typo. I have a existing garage with a 16 foot garage door. The door is on the gable end of the garage and the total span is 16'4", with a total garage outside width of 16'11". The garage was originally post and beam, with posts every 10 feet , and has a total depth (length) of 28 feet. I can't fit my 2 cars side by side on the garage and open any car door, so I want to widen the structure. I plan to replace the 16' door with two 8' doors, and overall widen one side of the structure by around 3 feet. Because the garage has an attic, the posts extend above the attic floor/garage ceiling, with the top of the beam 21" above the floor. Roof rafters sit on top of the beam. My plan is to extend the rafters on one side of the garage only to meet a new outside wall, placing a new beam at the attic floor level to carry the existing roof and floor load, and cutting off the existing posts , placing them above the new carrying beam. Essentially the existing roof structure remains intact, removing the existing outside bearing wall of the garage, and replacing it with a 28' long beam to carry the roof and floor load. allowing me to widen the garage. What size carrying beam can span 28 feet for this load? … read more
walkereng
walkereng
Consultant
Bachelor's Degree
3,432 satisfied customers
I want to build a house that is 52' wide by 60'. The home
I want to build a house that is 52' wide by 60' long. The home will have 8" thick buildblock ICF walls. If I run a steel i-beam across the length of the house (52'), would I be able to use AMVIC AMDEC… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,937 satisfied customers
I have spoken with before and he is very helpful. When you
I have spoken with Brad before and he is very helpful. When you has a minute, I would like to discuss over the phone an interesting topic regarding designing for bending vs. designing for deflection. Thanks. … read more
walkereng
walkereng
Consultant
Bachelor's Degree
3,432 satisfied customers
Hip rafter that is 16 ft and has triibutary area of 39 sq ft
hip rafter that is 16 ft long and has triibutary area of 39 sq ft on each side (78sf total) snow load is 20# ***** and 10# ***** deflection is limited to l/360 as its a finished cathedral clg inside. … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,937 satisfied customers
Looking to remove columns on garage space supporting a
looking to remove columns on garage space supporting a second floor. building is 28' wide x 20' deep with 20' beams supported by steel columns at 10' and 20' from the left of the 28' width. would like… read more
walkereng
walkereng
Consultant
Bachelor's Degree
3,432 satisfied customers
We are remodeling and have two 12" tall x 2"thick ceiling
We are remodeling and have two 12" tall x 2"thick ceiling support beams that butt end to end, with a vertical beam support coming up to support the 2 horizontal support beams where they meet. One beam… read more
walkereng
walkereng
Consultant
Bachelor's Degree
3,432 satisfied customers
I just found this and figured I would ask if anyone could
Hi, i just found this and figured I would ask if anyone could help me choose a headder. i am widening my garage door from 10 ft to 11. i need to put in a new headder. I have 2 2×10s with insert now wi… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,937 satisfied customers
Have a deck 6' x 26' and the outside beam will be over a
Hi have a deck 6' x 26' and the outside beam will be over a garage it has to span 25' 6"" from post to post and would like to know the size that I will need. can use steel flitches if possible. Thanks… read more
walkereng
walkereng
Consultant
Bachelor's Degree
3,432 satisfied customers
What size header beam (Lam) should I use, Gable end of my 1
What size header beam (Lam) should I use, Gable end of my 1 story garage I'm building with a 15' Garage door, total span is 16'- 6". 7/12 pitch w/ Asphalt Shingles. Standard wood construction w/ 2 x 8… read more
walkereng
walkereng
Consultant
Bachelor's Degree
3,432 satisfied customers
- I am using a 23' long 10W22 steel beam to strengthen
Hello - I am using a 23' long 10W22 steel beam to strengthen the attic floor over my garage. It is supported by load bearing walls at each end. A table that I found shows that this beam can support ab… read more
walkereng
walkereng
Consultant
Bachelor's Degree
3,432 satisfied customers
I am building a garage that is 24 x 32 outside dimension
I am building a garage that is 24' x 32' outside dimension with 12" foundation walls, that makes the interior dimensions 22 x 30. The garage will also have storage / living area above as well. I want … read more
walkereng
walkereng
Consultant
Bachelor's Degree
3,432 satisfied customers
Require minimum size W beam to support 60 lbs/sq.ft live load
Require minimum size W beam to support 60 lbs/sq.ft live load plus 10 lbs/sq.ft dead load ( total design of 70 lbs. sq.ft.) over a span of 48 feet with one support at 24 feet. Beam will be used to sup… read more
walkereng
walkereng
Consultant
Bachelor's Degree
3,432 satisfied customers
I want to support a poured concrete floor 5" thick of 5000
I want to support a poured concrete floor 5" thick of 5000 psi concrete with fiber, with wire mesh and #4 rebar 12" on center for a garage. This is supported by 8"X18" steel I beams 25' span resting o… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,937 satisfied customers
I need a Str. Eng. to run some numbers for me to size w beams
I need a Str. Eng. to run some numbers for me to size w beams in the basement, I have floor plans that I can email if that is possible. Thanks… read more
walkereng
walkereng
Consultant
Bachelor's Degree
3,432 satisfied customers
I am building a 31 x21 O.D. wood frame buliding (2 story
I am building a 31' x21' O.D. wood frame buliding (2 story , 1st flr slab,2nd flr 2x10 DF 16" oc w/ 3/4 ply floor & 5/8" gyp. ceiling >>>NEED to figure:(L/360) with 40lb L.L./20lb D.L.....>… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,937 satisfied customers
I have a simple truss carport spanning 20 feet that I want
I have a simple truss carport spanning 20 feet that I want to enclose. I need a header for a double garage door (18 feet), but only have eight inches to work with. Will a flitch plate with 2 by 8s wor… read more
walkereng
walkereng
Consultant
Bachelor's Degree
3,432 satisfied customers
3x 38 garage need a steel beam 38 ft long pitched roof
36 x 38 garage need a steel beam 38 ft long pitched roof center of bldg high ceiling one floor above no roof load depth of beam not an issue very high work area on first level… read more
walkereng
walkereng
Consultant
Bachelor's Degree
3,432 satisfied customers
im building a 40 x 30 garage with a 10/12 pitch roof. i want
im building a 40 x 30 garage with a 10/12 pitch roof. i want to use 2x10 ceiling joist and 2x8 rafters so i will have any area up stairs to work with in, maybe 10lb/sft. i need a beam to run to 40' so… read more
walkereng
walkereng
Consultant
Bachelor's Degree
3,432 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

vgdlpc

vgdlpc

Master's Degree

17 satisfied customers

Civil Engineer, Major in Structures and Foundations. Professional Engineer 11 years of experience.

StructuralEng

StructuralEng

Consultant

8,937 satisfied customers

Structural Engineer

walkereng

walkereng

Consultant

3,432 satisfied customers

Over 30 years of Structural Engineering experience.

Shannon Galway

Shannon Galway

-

208 satisfied customers

VP Technical Services at Major Engineering Company

Matt

Matt

Engineer

59 satisfied customers

Mechanical Engineering Hons degree, been working in automotive industry for the last 18 years - Engine development engineer

William Purpura

William Purpura

22 satisfied customers

Managing General Partner at Dargon Developement

ibosley

ibosley

Master's Degree

88 satisfied customers

Mechanical Engineering

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x