Structural Engineering

Ask Structural Engineering Questions and Get Expert Answers ASAP

Connect one-on-one with {0} who will answer your question

Related Structural Engineering Questions
8x8x5/8" angle iron, can it span 16' bearing wall of block
8x8x5/8" angle iron, can it span 16' bearing wall of block that is two stories? … read more
PaulP324
PaulP324
consulting engineer
MS
714 satisfied customers
I have a provject where i am expanding an opening in a
I have a provject where i am expanding an opening in a double brick thick wall in a historical home i am thinking of using.a flitch beam, but want to make sure the beam will be structurally sufficient … read more
JAYCEG
JAYCEG
College Degree B.S.
99 satisfied customers
I have a house built in 1902 I just bought, I need to move
I have a house built in 1902 I just bought, I need to move washer and dryer into the other section of basement but that door way is maybe 20"wide. And I believe it is a load bearing brick wall. I need… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
I have a question. I have a 50 year old single story home in
I have a question.I have a 50 year old single story home in Kentucky USA over a walk out basement block foundation, 2 layers of asphalt shingles, brick clad exterior, and minimal snow load. I am consi… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
I have a question. I have a 50 year old single story home in
I have a question. I have a 50 year old single story home in Kentucky USA over a walk out basement block foundation. 2 layers of asphalt shingles and minimal snow load. I am considering cutting a hole in the block foundation, standard size triple cell block in good shape on a 24" footer, and installing a 5 foot slider in the walk out basement. There is limited headroom in the basement for a standard Rough Opening/RO so am limited in header size above the sliding door. I have maybe 4" for a header and would like to consider a steel I beam, perhaps a W4x13, above the door. So a 5' span and up to 8" on each side sitting on top of block foundation. Would this work to support the house/roof load with acceptable deflection? … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
Can I sister 2x8 floor joists with 2x12's instead of using
Can I sister 2x8 floor joists with 2x12's instead of using lally columns and support beam for a room that is 16x16… read more
walkereng
walkereng
Consultant
Bachelor's Degree
4,512 satisfied customers
Looking to see if a 3"x5" x 3/8" x 64" would be fine for
Looking to see if a 3"x5" x 3/8" x 64" would be fine for install in concrete block wall as header for a 3'4" door opening. one story , 14' walls. Commercial. … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
Trying out take out a wall for remodeling. Currently ballon
Trying out take out a wall for remodeling. Currently ballon articheture, brick outside, wood frame inside, about 6 feet opening, want to open up to 11 ft … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
I have 10' span, need to support 4" thick roof slab and 8"
i have 10' span , need to support 4" thick roof slab and 8" thick load bearing wall on top ,what size of steel beam would carry it, … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
I purchase a 70' x 30' commercial building. Constructed of
I purchase a 70' x 30' commercial building. Constructed of concrete block. I'm have a family (he's in construction) frame out a standard size garage door opening on the side of the building. He instal… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
What type and size lentil do I need for an 8'8" opening in
What type and size lentil do I need for an 8'8" opening in 8"CMU wall … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
What size angle do I need for a 2 - 10' wide x 7' tall
what size angle do I need for a 2 - 10' wide x 7' tall garage door openings using limestone rock. the gable center on a 10/12 measures about 13' above the doors… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
What glulam size beam to required to span a 14' opening to
what glulam size beam to required to span a 14' opening to support trusses with a 3:12 pitch that are spanning 31'? glulam will also support angle iron to serve as a brick ledge for 6 courses of brick… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
I added a 4' brick wall by bolting angle iron to the block
I added a 4' brick wall by bolting angle iron to the block foundation (block is filled with cement). I'm concerned with frost heave and wonder how deep I need to go to replace the dirt with stone and … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
I'm wanting to cut an opening and install a 20' x 10' overhead
I'm wanting to cut an opening and install a 20' x 10' overhead door. The opening is to be cut into a 6" thick, 25' wide and 12.5' tall concrete tilt-wall panel. Can I cut an opening that large in this… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
Hi I have a just widened an opening between my kitchen and
Hi I have a just widened an opening between my kitchen and a small dinning room. There was a single door there originally but my new opening is 2000mm wide and is the height of the original door. The … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
Need to size a lintel for an 8-0"x8-0" opening in a brick/block
Need to size a lintel for an 8'-0"x8'-0" opening in a brick/block cavity wall. (Brick on 4" block. Opening is on an end wall. Not load bearing, one story of brick above. (12'-0" to top of parapet)… read more
walkereng
walkereng
Consultant
Bachelor's Degree
4,512 satisfied customers
I want to create an opening from a kitchen to extend into my
I want to create an opening from a kitchen to extend into my utility to give a larger kitchen. The wall is a 300mm cavity wall and the opening will be 2650mm wide with the beam having a 100mm bearing … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

vgdlpc

vgdlpc

Master's Degree

17 satisfied customers

Civil Engineer, Major in Structures and Foundations. Professional Engineer 11 years of experience.

StructuralEng

StructuralEng

Consultant

9,772 satisfied customers

Structural Engineer

walkereng

walkereng

Consultant

4,512 satisfied customers

Over 35 years of Structural Engineering experience.

Shannon Galway

Shannon Galway

-

208 satisfied customers

VP Technical Services at Major Engineering Company

JAYCEG

JAYCEG

99 satisfied customers

Expert

PaulH471

PaulH471

Construction Manager

46 satisfied customers

Expert

William Purpura

William Purpura

Managing General Partner

25 satisfied customers

Managing General Partner at Dargon Developement

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x