Structural Engineering

Ask Structural Engineering Questions and Get Expert Answers ASAP

Connect one-on-one with {0} who will answer your question

Related Structural Engineering Questions
I'm remodeling a bathroom downstairs. As per of the project
I'm remodeling a bathroom downstairs. As per of the project I'd like to put in a vent fan. It would run in the joist bay then outside. But I'd have to cut a hole through the rim board. Is that okay?… read more
walkereng
walkereng
Consultant
Bachelor's Degree
4,728 satisfied customers
My radon guy wants to cut a 5" hole through the center of
My radon guy wants to cut a 5" hole through the center of five 2 x 10 deck joists. Can you do this if you put a Simpson 1 1/2" wide tie strap on the side of the 2 x 10 above and below the 5" diameter … read more
walkereng
walkereng
Consultant
Bachelor's Degree
4,728 satisfied customers
Last fall my bathroom was remodeled with a 21 inch tub, with
Last fall my bathroom was remodeled with a 21 inch tub, with tile surround. Because of others problems from the install, I went into my crawl space, which is fairly large, and found that near the foun… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
I would like to know how to reinforce joist that needs to be
I would like to know how to reinforce joist that needs to be cut to reroute plumbing and ducting … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
The plumbers cut a floor joist with a hole saw and then cut
The plumbers cut a floor joist with a hole saw and then cut out 3/4 of the support between the top horizontal and the lower board, through the mdf. The cut out a round hole through the mdf to run a wa… read more
walkereng
walkereng
Consultant
Bachelor's Degree
4,728 satisfied customers
I have a similar concern - I need to reinforce floor joists
I have a similar concern - I need to reinforce floor joists for tub placement in remodeled bathroom. The tub will weigh over 1000 lbs once filled with water. 2x6” lumber is used for the floor joists. … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
I would like to open a wall up between my kitchen and living
I would like to open a wall up between my kitchen and living room. I am trying to figure out the size LVL needed to accomplish this. The ceiling joists above the kitchen run perpendicular to the curre… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
Wondering about a second floor bath remodel that would
Wondering about a second floor bath remodel that would require adjustments to plumbing, would need specific guidance on the best way to route the plumbing for proper structural viability. … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
I'm looking for the maximum span which 16" on center 5.5"
Hi, I'm looking for the maximum span which 16" on center 5.5" LVL 2.0 for a second floor bathroom. I have full access to sister/replace 2x8 fir joist. Looking for > L/600 for a tile shower on a 10'… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
I am a licensed plumber in South Carolina. I have been asked
I am a licensed plumber in South Carolina. I have been asked to perform plumbing on a Remodel of a large home. What is installed is 2x10 I beam joist. The best I have been able to review in the plumbi… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
Trying to determine if these walls in the master bathroom
Trying to determine if these walls in the master bathroom are load bearing. There is a former fireplace framing with 2x6s. One board only goes half way up, one is cut and the other is wobbly when I po… read more
walkereng
walkereng
Consultant
Bachelor's Degree
4,728 satisfied customers
I have a question about a floor joist that has been
I have a question about a floor joist that has been compromised by a notch being cut out of it by an inexperienced plumber.… read more
walkereng
walkereng
Consultant
Bachelor's Degree
4,728 satisfied customers
What pattern of drilling holes /4 PEX pipe should I use
What pattern of drilling holes for 3/4 PEX pipe should I use for drilling through 8 " floor joists, in a basement and 1st floor re-plumbing operatwion, when I am running water lines through the joists… read more
walkereng
walkereng
Consultant
Bachelor's Degree
4,728 satisfied customers
Overview: I'm remodeling a bathroom located in the basement
Overview: I'm remodeling a bathroom located in the basement corner of a single two story home with walk out basement. I would like to install an ADA shower pan (no ledge). My concern: I have to lower … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
1.75 x 18" by 20' Microlam beam (3 together supporting 12'
1.75 x 18" by 20' Microlam beam (3 together supporting 12' floor joists for floor overhead) Joists on 16" ctr. Beam in center of 23 ft span for floor above. Is it structurally okay to drill 3.5 inch h… read more
walkereng
walkereng
Consultant
Bachelor's Degree
4,728 satisfied customers
I just had my kitchen completely redone (performed by a licensed
I just had my kitchen completely redone (performed by a licensed and insured contractor) approximately two months ago. As part of the project, I had wall cabinets and the above soffit removed. When th… read more
walkereng
walkereng
Consultant
Bachelor's Degree
4,728 satisfied customers
Remodeling a second floor earlier remodeling (from 10 years
Remodeling a second floor earlier remodeling (from 10 years ago) to create a second floor bath. When opened subfloor discovered a 12" Silent Floor joist system. Must traverse 8' of joists to get showe… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
I have a house that is now a two and a half story structure
I have a house that is now a two and a half story structure (basically configured as a Cape Cod structure). The roof trusses have a 2X8 top chord and a 2X10 bottom chord. The pitch is 10/12. The truss… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

vgdlpc

vgdlpc

Master's Degree

17 satisfied customers

Civil Engineer, Major in Structures and Foundations. Professional Engineer 11 years of experience.

StructuralEng

StructuralEng

Consultant

9,772 satisfied customers

Structural Engineer

walkereng

walkereng

Consultant

4,728 satisfied customers

Over 35 years of Structural Engineering experience.

Shannon Galway

Shannon Galway

-

208 satisfied customers

VP Technical Services at Major Engineering Company

JAYCEG

JAYCEG

99 satisfied customers

Expert

PaulH471

PaulH471

Construction Manager

46 satisfied customers

Expert

William Purpura

William Purpura

Managing General Partner

29 satisfied customers

Managing General Partner at Dargon Developement

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x