Structural Engineering

Ask Structural Engineering Questions and Get Expert Answers ASAP

Connect one-on-one with {0} who will answer your question

Related Structural Engineering Questions
Howdy, I am removing a bearing wall in a 1906 home. The
Howdy, I am removing a bearing wall in a 1906 home. The house is a story and a half cape cod that is 28' wide and 26' long. The bearing wall runs in the 26' direction with bedrooms on the second floor… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,934 satisfied customers
I am removing a load bearing wall that divides the kitchen
I am removing a load bearing wall that divides the kitchen from the living room in an older house I just bought. It will open a space from the outside wall to the hallway load bearing wall, which is 2… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,934 satisfied customers
I'm buying a ranch house that has an extension where an
I'm buying a ranch house that has an extension where an additional room (about 10 x 12) was added off the side of the house by building on top of a concrete patio. I'd like to open up part of the wall… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,934 satisfied customers
This one is pertaining to the use of LVL LAMINATED beams. I
This one is pertaining to the use of LVL LAMINATED beams. I had a load bearing wall removed down the center of my home. The total length of the beam is 18 foot. The size is 4 each, 1 3/4” thick x 14” … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,934 satisfied customers
I HAVE TWO STRUCTURAL QUESTIONS the project is a 26x50 home
I HAVE TWO STRUCTURAL QUESTIONS the project is a 26x50 home with a stem wall foundation and a crawl space. There is a 21 foot length of the exterior wall (supporting aprox 7 trusses) I would like to i… read more
walkereng
walkereng
Consultant
Bachelor's Degree
3,412 satisfied customers
Looking at doing a 2x8 beam on south wall of house for
Looking at doing a 2x8 beam on south wall of house for garage door opening. Planning on using flitch plate with triple 2x8's and steel sitting on top of the sill plate if I use 1/2" steel, what hole s… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,934 satisfied customers
I have a truss floor system, 2x4, 14' in depth, 2' on center
Hello - I have a truss floor system, 2x4, 14' in depth, 2' on center on the second floor of the home. The room is quite large but already has a pool table in it for ten years with no issue. I am hopin… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,934 satisfied customers
I want to open up the wall between my kitchen and living room.
I want to open up the wall between my kitchen and living room. The wall is load bearing. The joists are 2x4 16 inch oc and the attic is non storage non occupied. The attic does hold the HVAC ducts, el… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,934 satisfied customers
This is a 2story house on the second floor i am removing a
this is a 2story house on the second floor i am removing a load bearing wall it is 21' long It holds a roof above with a 5.5 x 12 pitch roof. one end of the beam pockets in the primer wall the other e… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,934 satisfied customers
I have an existing wooden beam that consists of 3- 1 1/2" x
I have an existing wooden beam that consists of 3- 1 1/2" x 9" x14' nailed together , however two are spliced! Only see glue on one board not the other. The beam deflected about 1 1/8". Some termite d… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,934 satisfied customers
My basement living room has a 6x7 beam in the center holding
My basement living room has a 6x7 wood beam in the center holding up 20' floor joint. The lolly columns are set 8' apart. It's a 2 story house w crawl space. I want to install a 16 foot 1/2x7 flitch p… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,934 satisfied customers
I want to place a beam spanning 16' that will replace a wall
I want to place a beam spanning 16' that will replace a wall in the center of my single story truss roof. there is aprox. 13' on either side of the wall. about 6' of the 16' opening is currently open … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,934 satisfied customers
To take out a load bearing wall, which will open up the
To take out a load bearing wall, which will open up the kitchen and dining room to the living room. It's on one end of the house placed in the center. Manufactured trusses on 16'' centers and aprox. 2… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,934 satisfied customers
In my 1904 House, in my basement, I want to remove a structurally
In my 1904 House, in my basement, I want to remove a structurally supportive brick (not cinder block) wall and replace it with a beam or header which would clear span 15 feet and 1-1/2 inches without … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,934 satisfied customers
I am renovating a one hundred year old house. The basic original
I am renovating a one hundred year old house. The basic original structure is in excellent shape. A rear, added on structure, needs some shoring up. I need to install a beam 13' 9 1/2" . This beam wil… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,934 satisfied customers
what size flitch plate do I need for an 8-0" opening. This
what size flitch plate do I need for an 8'-0" opening. This is a one story house with an attic. Back wall to bearing wall is 10'-0" Front wall to bearing wall is 15'-0"… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,934 satisfied customers
I torn down a wall that separated my kitchen from my dining
I torn down a wall that separated my kitchen from my dining room and living room. Everything seemed small so I wanted to open things up. My house is a two level home with the kitchen being in the 2nd … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
8,934 satisfied customers
Im wondering if I should replace metal support posts in the
I'm wondering if I should replace metal support posts in the basement with a 2x4 wall running the full length under the support beam or should I incorporate the metal posts into the 2x4 wall? Also can… read more
walkereng
walkereng
Consultant
Bachelor's Degree
3,412 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

vgdlpc

vgdlpc

Master's Degree

17 satisfied customers

Civil Engineer, Major in Structures and Foundations. Professional Engineer 11 years of experience.

StructuralEng

StructuralEng

Consultant

8,934 satisfied customers

Structural Engineer

walkereng

walkereng

Consultant

3,412 satisfied customers

Over 30 years of Structural Engineering experience.

Shannon Galway

Shannon Galway

-

208 satisfied customers

VP Technical Services at Major Engineering Company

Matt

Matt

Engineer

58 satisfied customers

Mechanical Engineering Hons degree, been working in automotive industry for the last 18 years - Engine development engineer

William Purpura

William Purpura

22 satisfied customers

Managing General Partner at Dargon Developement

ibosley

ibosley

Master's Degree

88 satisfied customers

Mechanical Engineering

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x