Structural Engineering

Ask Structural Engineering Questions and Get Expert Answers ASAP

Connect one-on-one with {0} who will answer your question

Related Structural Engineering Questions
I'm looking to construct a barn hoist with a cantilever of
Hi I'm looking to construct a barn hoist with a cantilever of 10' and a trolly load of 1000 lbs max can not have a flange width mor than 8” what size would be recommended … read more
walkereng
walkereng
Consultant
Bachelor's Degree
4,728 satisfied customers
I am building a 30 x 50 shop and plan on using w 12x 22
I am building a 30 x 50 shop and plan on using w 12x 22 beams for the rafters on a 3 on 12 pitch. there will be 3 of those and I plan to put a beam down the center for a chain hoist. there wil be 25' … read more
walkereng
walkereng
Consultant
Bachelor's Degree
4,728 satisfied customers
If I used 1” plywood and 1” 1/2 plank on top screwed and
If I used 1” plywood and 1” 1/2 plank wood on top screwed and glued what would be the rolling load say Bobcat or forklift of 175psf barn floor from a previous question?… read more
walkereng
walkereng
Consultant
Bachelor's Degree
4,728 satisfied customers
I'm building a bridge crane with posts on 27' centers on
Hi. I'm building a bridge crane with posts on 27' centers on both sides of runway. I'm looking at using 21" x 101lb beams for runway with 2-1/2" square solid bar on top for end truck wheels. Looking a… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
I want to install a chain hoist in my garage on a overhead
I want to install a chain hoist in my garage on a overhead i-beam with a trolley so I can move it one side to the other to centre over engine compartment and then slide over to the side when out of ca… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
I am looking structural engineer to get a recommendation on
I am looking for a structural engineer to get a recommendation on making a material choice for deflection… read more
walkereng
walkereng
Consultant
Bachelor's Degree
4,728 satisfied customers
I have a large glue lam beam across my garage ceiling, about
I have a large glue lam beam across my garage ceiling, about 6 inches wide by 19" deep, rated load of over 1,000 lbs. I want to mount an I Beam on it so I can mount a trolley and hoist. What's the bes… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
I am going to be lifting a 2000 lb load. I will be using an
I am going to be lifting a 2000 lb load. I will be using an w8x13 beam 5'11" long bolted between two concrete beams overhead. the concrete beams are 36" tall x 24"wide. the W beam will be attached the… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
I have an(6061-T6 Aluminum I Beam - AS) that's 3"H X 2.33 wide
I have an(6061-T6 Aluminum I Beam - AS) that's 3"H X 2.33 wide flange X.170 Web X 8'LONG. Will be using for gantry and wanted to know load capacity? Thanks… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
22' span supported at each end, 2600 lb load, 5' maximum from
22' span supported at each end, 2600 lb load, 5' maximum from 1 end, load is an electric motor which will be hoisted with a beam trolley at 5', and rolled to 1'6" position and lowered to a cart, and t… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
We are using a S24 X 100 lb. beam supported at each end @
We are using a S24 X 100 lb. beam supported at each end @ 46 ft. center to center on the supports Can this beam support an underslung load 18 inches wide that weighs 10,000 lbs?… read more
walkereng
walkereng
Consultant
Bachelor's Degree
4,728 satisfied customers
If I am installing the rails for a bridge crane to run on,
If I am installing the rails for a bridge crane to run on, 16ft between columns, would 12X35lbs with a 5.078 flange work?… read more
walkereng
walkereng
Consultant
Bachelor's Degree
4,728 satisfied customers
I need assistance specing a structural beam. The beam needs
I need assistance spec'ing a structural beam. The beam needs to: 1) Span seven (7) feet 2) Support a winch lifting loads of up to 500 pounds at typical winch rates 3) Have a safety factor suitable for… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
I am putting a crane in my shop I already have twosteel
I am putting a crane in my shop I already have twosteel posts installe 38 feet apart angle braced to concrete piers and bolted to the walls i need to put a beam between them . they are 38 feet apart t… read more
walkereng
walkereng
Consultant
Bachelor's Degree
4,728 satisfied customers
I have a 15 foot long gantry.. it was homemade and I think
I have a 15 foot long gantry.. it was homemade and I think the sides are plenty strong for what Im trying to do.. I am looking to lift 10 ton with this gantry.. I need an I beam to support this weight… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
My client wants to use an aluminum I-Beam to support a lifting
My client wants to use an aluminum I-Beam to support a lifting hoist across a 23 foot span. The hoist will be for lifting equipment up through the shaft. Maximum weight is designed for 4000 lbs. Using… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
I have a 60 I beam 20" with 6.255 flanges .5" web. How much
I have a 60' I beam 20" with 6.255 flanges .5" web. How much weight will it support in the middle if supported at both ends.… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
Sculptor needs 12 Aluminum I beam and rolling carrier for
Sculptor needs 12' Aluminum I beam and rolling carrier for my 2nd story removable winch to occasionally raise and lower 200 lb or less sculpture to ground. Two thirds will be well supported one third … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,772 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

vgdlpc

vgdlpc

Master's Degree

17 satisfied customers

Civil Engineer, Major in Structures and Foundations. Professional Engineer 11 years of experience.

StructuralEng

StructuralEng

Consultant

9,772 satisfied customers

Structural Engineer

walkereng

walkereng

Consultant

4,728 satisfied customers

Over 35 years of Structural Engineering experience.

Shannon Galway

Shannon Galway

-

208 satisfied customers

VP Technical Services at Major Engineering Company

JAYCEG

JAYCEG

99 satisfied customers

Expert

PaulH471

PaulH471

Construction Manager

46 satisfied customers

Expert

William Purpura

William Purpura

Managing General Partner

29 satisfied customers

Managing General Partner at Dargon Developement

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x