Structural Engineering

Ask Structural Engineering Questions and Get Expert Answers ASAP

Connect one-on-one with {0} who will answer your question

Related Structural Engineering Questions
I removed a segment of a load bearing header. I attempted to
Hello, i removed a segment of a load bearing header. I attempted to remedy this by adding a post support under the end of the beam. I was hoping to find out if what i did was sufficient. … read more
walkereng
walkereng
Consultant
Bachelor's Degree
4,128 satisfied customers
I have a question. I have a 50 year old single story home in
I have a question.I have a 50 year old single story home in Kentucky USA over a walk out basement block foundation, 2 layers of asphalt shingles, brick clad exterior, and minimal snow load. I am consi… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,759 satisfied customers
We are wanting to put a 10 foot opening in load bearing wall
We are wanting to put a 10 foot opening in load bearing wall supporting flat roof. Below is garage that has 6 × 12 center beam which is 15 inches off center from load bearing wall. The joists below wa… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,759 satisfied customers
I want to build a loft in a cement block building, The
I want to build a loft in a cement block building, The building is 40 x 40. How large of a wood beam would be required to span 40' support on each end by a block pier? The beam would be 8' from the en… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,759 satisfied customers
I need a laminated beam to span and support 24 feet to build
I need a laminated beam to span and support 24 feet to build a rubber roof with double 2 x 10 joists, 16" OC (576 square feet) off of the front of my existing garage, Existing garage is constructed wi… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,759 satisfied customers
We have a shop with a 12' wide and 11' tall shop door. The
We have a shop with a 12' wide and 11' tall shop door. The existing header over the shop door is a 5.5" wide by 9" tall glu lam beam. We need to shrink the height of the 9" tall beam as much as possib… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,759 satisfied customers
I have a question. I have a home in Scottsdale Az, obviously
Hello, I have a question. I have a home in Scottsdale Az, obviously we have no snow, weight issues. My question is the living room, dining room, and kitchen are separated by interior walls. We want to… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,759 satisfied customers
I would like to open up two rooms in my basement into one
I would like to open up two rooms in my basement into one large room. It is a 2 story house. The two rooms are 14' x 14' and 14' x 16'. The opening I want to create is 12' wide with about 20-24" on ea… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,759 satisfied customers
I have a 16' span that will carry 2x12x 17' joists on HD
i have a 16' span that will carry 2x12x 17' joists on HD hangers the floor will be 5/8" t&g sturdi floor and will be used as full storage say 40lbs sq ft...will a 5.5 x 16 glu lam on 4x6 posts be ok f… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,759 satisfied customers
I'm building a 30' by 40' garage with approved drawings from
I'm building a 30' by 40' garage with approved drawings from an architectural firm. It has three garage doors on the front 40', with the 5/12 pitch roof gong to the sides to eliminate snow build up in… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,759 satisfied customers
I have a steel I beam that is 6" x 16' and want to replace
i have a steel I beam that is 6" x 16' long and want to replace it with a a 6" x 16' wood beam. How many 2x6's would need to be laminated together to replace this I beam? … read more
walkereng
walkereng
Consultant
Bachelor's Degree
4,128 satisfied customers
I have a (2x10)4 beam spanning 25 feet supported midway by a
I have a wood (2x10)4 beam spanning 25 feet supported midway by a pillar and I would like to remove the pillar. What size of beam- steel or glue laminate - would I need to replace the beam that is the… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,759 satisfied customers
I will be constructing a24' x 40' pole barn. I am using
I will be constructing a24' x 40' pole barn. I am using 3-ply 2x6 laminated posts spaced 8' OC with trusses sitting on a truss carrier 4' OC / 24' span plus 1' overhang. The structure will have a 10' … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,759 satisfied customers
I need to size a Beam, Glu-Lam, to replace a bearing wall.
I need to size a Beam, Glu-Lam, to replace a bearing wall. The Span of the G;u-Lam Beam end to end is 13'-8" It will carry a Side Point Load of 2,162 lbs, Steel Bracket 90 deg from Glu-Lam to the exis… read more
walkereng
walkereng
Consultant
Bachelor's Degree
4,128 satisfied customers
What size LVL do I need to span a 12' opening on an interior
What size LVL do I need to span a 12' opening on an interior 2x4 garage wall (load bearing)? The wall is a 2x4 wall, 10' height. For each end of the LVL, can I support the LVL with 3 2x4 jack studs?… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,759 satisfied customers
This is residential project in Seattle, WA. I need to
This is for a residential project in Seattle, WA. I need to size a header for an exterior door opening that measures 8'-6". It is for a 3-panel bifold door system. The header will need to support the … read more
walkereng
walkereng
Consultant
Bachelor's Degree
4,128 satisfied customers
I have a shop that has a 30' long, 12"x12" glu-lam supporting
I have a shop that has a 30' long, 12"x12" glu-lam supporting a loft. The shop is 30' deep but I have 2 post 16' apart supporting the glu-lam. The floor of the loft goes 12' either direction of the gl… read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,759 satisfied customers
We are removing a wall 18 ft. long and installing a below ceiling
We are removing a wall 18 ft. long and installing a below ceiling laminated header (the existing headers will stay in place.) What size laminated header should we use. There will be no center support … read more
StructuralEng
StructuralEng
Consultant
Bachelor's Degree
9,759 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

vgdlpc

vgdlpc

Master's Degree

17 satisfied customers

Civil Engineer, Major in Structures and Foundations. Professional Engineer 11 years of experience.

StructuralEng

StructuralEng

Consultant

9,759 satisfied customers

Structural Engineer

walkereng

walkereng

Consultant

4,128 satisfied customers

Over 35 years of Structural Engineering experience.

Shannon Galway

Shannon Galway

-

208 satisfied customers

VP Technical Services at Major Engineering Company

Matt

Matt

Engineer

69 satisfied customers

Mechanical Engineering Hons degree, been working in automotive industry for the last 18 years - Engine development engineer

William Purpura

William Purpura

Managing General Partner

41 satisfied customers

Managing General Partner at Dargon Developement

ibosley

ibosley

Master's Degree

88 satisfied customers

Mechanical Engineering

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x