Small Engine

Small Engine Troubleshooting Problems? Ask a Mechanic Now.

Connect one-on-one with {0} who will answer your question

Related Small Engine Questions
I think I have the same generator you sent the other fella
I think I have the same generator you sent the other fella the wiring diagrams to. Here is my situation. First I have the 15000 watt 992cc generic portable generator, mine was running along fine and t… read more
Hank F.
Hank F.
Service Technician
High School or GED
1,541 satisfied customers
I can not find a part number for my customers generator
please I can not find a part number for my customers generator 04096-1 i need a water pump on the engine powered by the belt … read more
Hank F.
Hank F.
Service Technician
High School or GED
1,541 satisfied customers
Mike G. I'm trying to figure out if my current generator can
Hi Mike G. I'm trying to figure out if my current generator can run my well pump, and what size transfer switch I need. But I'm a little confused, my well is only supposed to be 250' and 1.5hp but at … read more
J LaGrutta
J LaGrutta
AA
408 satisfied customers
Briggs01, 8hp horz shaft. Crank seized on Magneto end. I
Briggs(###) ###-####01, 8hp horz shaft. Crank seized on Magneto end. I need to have front bushing replaced. I think it needs special tools to replace but not sure where to find info. … read more
Curtis B.
Curtis B.
Technician
Associate Degree
19,291 satisfied customers
I have a generac series impact 36LP plus generator. It idles
I have a generac series impact 36LP plus generator. It idles and starts well and seems to run well when under load. But after a minute of just idling without any demand or even very little demand, i s… read more
Tamar D.
Tamar D.
Mechanic II
Vocational, Technical or Trade School
11,354 satisfied customers
Request owners Manuel 1p902-0129-b1. Request owners Manuel
Request owners Manuel 1p902-0129-b1 JA: Who makes your tool or machine? How old is it? Customer: Request owners Manuel 1p902-0129-b1 JA: How long has this been going on? What have you tried so far? Cu… read more
MNightTech
MNightTech
Consultant
Owner HPAR
2,490 satisfied customers
Kawasaki FC540v; a few years back the governor went bad. I
Kawasaki FC540v; a few years back the governor went bad. I tried adjusting the governor, but the engine would still race when started. i tracked down the parts and had the gov replaced.Subsequently no… read more
MowerDocMD
MowerDocMD
666 satisfied customers
I have an 8kw Generac Centurion propane generator that keeps
I have an 8kw Generac Centurion propane generator that keeps blowing the 7.5 amp fuse....immediately and repeatedly. All connections are secure. It had been doing it's weekly cycling but the battery w… read more
Hank F.
Hank F.
Service Technician
High School or GED
1,541 satisfied customers
Briggs and Stratton model # 040220 7000 watt home generator.
Briggs and Stratton model #(###) ###-####watt home generator. Propane powered. … read more
Hank F.
Hank F.
Service Technician
High School or GED
1,541 satisfied customers
We have a 4000 watt Generac generator. It was working fine,
We have a 4000 watt Generac generator. It was working fine, powering our house during a time when the Edison power was off. I shut it down to add fuel. When I restarted it, it ran for 10 seconds, and … read more
Hank F.
Hank F.
Service Technician
High School or GED
1,541 satisfied customers
I have a 7500W, diesel Generac in a 1994 RV. It has less than
I have a 7500W, diesel Generac in a 1994 RV. It has less than 1000 hours and runs fine, but when the 115v, 15A cabin service is loaded with a coffee maker, it takes it for about 20 seconds then depowe… read more
Hank F.
Hank F.
Service Technician
High School or GED
1,541 satisfied customers
I have a Generac generator model(NNN) NNN-NNNNand Ive left it sitting
I have a Generac generator model(NNN) NNN-NNNNand I've left it sitting for too long between starts and now it won't start. The gas I'm sure was old (at least a year) and it may have gummed up the work… read more
Rick
Rick
Factory Authorized Trainer
Vocational, Technical or Trade Scho
4,218 satisfied customers
wheelhouse 5550 with 8550 surge. Model No. 1646-4.
Hello, I have wheelhouse 5550 with 8550 surge. Model No. 1646-4. All is tested and appears that the alternator assembly is faulty. Will kick out under a load, but does not put out the power that it sh… read more
Hank F.
Hank F.
Service Technician
High School or GED
1,541 satisfied customers
I have a 2001 GENERAC 3000W portable generator with a Tecumseh
I have a 2001 GENERAC 3000W portable generator with a Tecumseh OHH60 71122C engine. Lost power today and were running it to keep a freezer powered. It shut down when we were away from it and now it se… read more
Rick
Rick
Factory Authorized Trainer
Vocational, Technical or Trade Scho
4,218 satisfied customers
I recently bought a new Briggs (Generac) portable generator
I recently bought a new Briggs (Generac) portable generator model 030242 that is rated 6200 watts with a very nice Briggs OHV 11 hp motor. I am having low voltage problems. If I get it loaded to 3400 … read more
Hank F.
Hank F.
Service Technician
High School or GED
1,541 satisfied customers
The question concerns a 3500W portable generator. I confess
The question concerns a 3500W portable generator. I confess that I did not thoroughly check it out when I purchased..I merely started it and I "assumed" it was ok....well I plugged it in and ended up … read more
Hank F.
Hank F.
Service Technician
High School or GED
1,541 satisfied customers
I have Troy-Bilt 8000Watt Generator Model 030247 that worked
I have Troy-Bilt 8000Watt Generator Model 030247 that worked well for two days during the power outage, next time I went to use it stop putting out power. It looks like the is a inline pc board part n… read more
cameronsmallengines
cameronsmallengines
Small Engine Service Technician
High School or GED
170 satisfied customers
generac model #01313_0 serial#5609865 series 3500, was running
generac model #01313_0 serial#5609865 series 3500, was running good for 3 hours then stopped. only runs for ten seconds and quits. have full of oil but no low oil light on. have changed oil and filter… read more
Rick
Rick
Factory Authorized Trainer
Vocational, Technical or Trade Scho
4,218 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Curtis B.

Curtis B.

Technician

19,291 satisfied customers

have worked on and around most engine models for 35 yrs./Polaris ATV expert

Rick

Rick

Factory Authorized Trainer

4,218 satisfied customers

Outdoor Power Equipment technical trainer since 1990, covering eight states.

Vince O.

Vince O.

Small Engine Technician

3,283 satisfied customers

Over 30 years experience repairing lawn and garden equipment. Chainsaws, mowers,blowers and trimmers

Jon K.

Jon K.

Small Engine Diagnostic Expert

2,995 satisfied customers

Gold certified Stihl tech, Service Manager for a rental/repair shop.Certified in most small engines

James W

James W

Small Engine Troubleshooting Expert

2,989 satisfied customers

7 years as Mechanic & Parts Manager for Brother who has Owned Lawn & Garden Repair shop for 35 years

RUSS

RUSS

SERVICE TECHNICIAN

1,723 satisfied customers

28 YEAR SERVICE TECHNICIAN

roger

roger

Small Engine Technician

390 satisfied customers

23 years of being a shop owner..small engine trade schools

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x