Small Engine

Small Engine Troubleshooting Problems? Ask a Mechanic Now.

Connect one-on-one with {0} who will answer your question

Related Small Engine Questions
Small Engine Question I have an Onan 12HDKCD-2209A QD
Small Engine Question I have an Onan 12HDKCD-2209A QD generator SN B050744770 with 678 hours that I bought new in 2005. Last night we had a power outage and we started it. It ran for about 35 minutes … read more
Hank F.
Hank F.
Technician
High School or GED
16,717 satisfied customers
I have a onan 6500 emerald plus model6.5nhefb26100g it stop
i have a onan 6500 emerald plus model6.5nhefb26100g it stop putting out power i cleans rings replaced volt reg. board and brushes not try to start it will start then stop about time i let off of start… read more
Hank F.
Hank F.
Technician
High School or GED
16,717 satisfied customers
Honda EM5000sx Generator - no voltage Engine/rpm fine Brushes
Honda EM5000sx Generator - no voltage Engine/rpm fine Brushes fine tried 12V flash directly to brushes - no AC voltage resulted when running AV voltage across brushes = 46V L1/L2 = 1.2V R1/R2 = 1.2V L… read more
Hank F.
Hank F.
Technician
High School or GED
16,717 satisfied customers
Generator model 030324 has burned out brush lead. Replaced
Generator model 030324 has burned out brush lead. Replaced brush, generator started to put out power for about 30seconds, and then burned out brush-holder again. Rotor circuit resistance measured 30 o… read more
Hank F.
Hank F.
Technician
High School or GED
16,717 satisfied customers
I am working on an Onan 5.5HGJAB-1038c generator that has been
I am working on an Onan 5.5HGJAB-1038c generator that has been taken out of an RV and is setting on my test bench. The engine runs as long as i keep the start switch depress, once I let off it dies. I… read more
Hank F.
Hank F.
Technician
High School or GED
16,717 satisfied customers
Hank F. Onan Generator Pro 4000e. I am not familiar enough
Hank F. Onan Generator Pro 4000e. I am not familiar enough with Onan to know if it has a more specific model number on it, though I can do some looking if you can tell me where. Has low voltage at AC … read more
Hank F.
Hank F.
Technician
High School or GED
16,717 satisfied customers
Hank, Was just reading your article and diag of onan emerald
Hank, Was just reading your article and diag of onan emerald genset 4bge and have the same problem. followed your advice and found the slip rings black with carbon, but brushes are ok, cleaned slip ri… read more
Hank F.
Hank F.
Technician
High School or GED
16,717 satisfied customers
I have a Generac 7550EXL with no ouptut. it was working up
I have a Generac 7550EXL with no ouptut. it was working up to the point I connected a 220v 6.7a well pump to it. did some poking around and this is what I have discovered thus far. 1. 9.5 ohms through… read more
Hank F.
Hank F.
Technician
High School or GED
16,717 satisfied customers
I have a 4.OBFA 4kw onan IR spec c 1800 I replaced the stator
I have a 4.OBFA 4kw onan IR spec c 1800 I replaced the stator could not find new rotor but found new rotor same as old one but is 50 hertz not 60 hertz I was told by a rewinding company that I could c… read more
Hank F.
Hank F.
Technician
High School or GED
16,717 satisfied customers
1 volt..stay running..12v going to the coil and fuel pump.On monday
6.5 HNEF r.v gen set.replaced control board,vr,brusses,cleaned slip rings,cleaned carb.Gen still starts and shuts off.I am gitting 23-25 om's at pin 9 &10.I am getting 1 volt at pins 2 & 3.The engine … read more
Hank F.
Hank F.
Technician
High School or GED
16,717 satisfied customers
I have an Onan 4.5 genset model # XXXXX 30502B serial
I have an Onan 4.5 genset model # XXXXX 30502B serial # XXXXX when try to start it - motor will start, but when let key off, motor will die and sometimes when I start it, it will keep running quite a … read more
Hank F.
Hank F.
Technician
High School or GED
16,717 satisfied customers
my 16,000 is 5 years old and has exercised weekly. it has
my 16,000 is 5 years old and has exercised weekly. it has never supplied power to the house. I was told that i should have been turning off the power from the street to put a load on it regularly, I t… read more
Hank F.
Hank F.
Technician
High School or GED
16,717 satisfied customers
Resistance Table for Stator on a 030426-0 BRiggs and stratton
Resistance Table for Stator on a 030426-0 BRiggs and stratton generator. The book 87971 does not carry my model. I get 00.6 ohms on the #11 and #22 power winding. Is this a bad stator?… read more
Hank F.
Hank F.
Technician
High School or GED
16,717 satisfied customers
I have a 2.8 micro lite, it starts , wont stay running, wil
I have a 2.8 micro lite, it starts , won't stay running, will exciting the brushes solve my problem? what are the brush lead numbers ? will the regulator be the next thing i look at?… read more
Hank F.
Hank F.
Technician
High School or GED
16,717 satisfied customers
ONAN GEN 10,000 MODEL 10HDCAA11506A S/N B010203851 .IT WILL
ONAN GEN 10,000 MODEL 10HDCAA11506A S/N B010203851 .IT WILL RUN FOR ABOUT 15 SEC THEN SHUTS DOWN. I GET CODE OF 13 WHICH IS A REGULATOR ,IT SAYS TO SHUT DOWN SOME POWER IN THE RV.I SHUT OFF THE MAIN B… read more
Hank F.
Hank F.
Technician
High School or GED
16,717 satisfied customers
I have a Onan 3.0 MAJB with 7 hours run time on it. It was
I have a Onan 3.0 MAJB with 7 hours run time on it. It was running fine under load and just shut down. It will now run only when you hold the start button and dies as soon as you release, but produces… read more
Hank F.
Hank F.
Technician
High School or GED
16,717 satisfied customers
We have a Marquies 7000 (NHM)generator in our RV (1995) that
We have a Marquies 7000 (NHM)generator in our RV (1995) that we just purchased. It starts, runs normaly but is only putting out 59.5 volts on both legs, this was measured from hot legs to neutral wire… read more
Hank F.
Hank F.
Technician
High School or GED
16,717 satisfied customers
i have an onan model #4kyfa26100k, serial # d040635970, wire
i have an onan model #4kyfa26100k, serial # XXXXX wire diagram 0611-12.67, it will start for about three seconds then the light flashes and it stalls out, checked the code and found code fourteen, NOW… read more
Hank F.
Hank F.
Technician
High School or GED
16,717 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Curtis B.

Curtis B.

Technician

18,036 satisfied customers

have worked on and around most engine models for 35 yrs./Polaris ATV expert

Rick

Rick

Factory Authorized Trainer

4,218 satisfied customers

Outdoor Power Equipment technical trainer since 1990, covering eight states.

Vince O.

Vince O.

Small Engine Technician

3,047 satisfied customers

Over 30 years experience repairing lawn and garden equipment. Chainsaws, mowers,blowers and trimmers

Jon K.

Jon K.

Small Engine Diagnostic Expert

2,995 satisfied customers

Gold certified Stihl tech, Service Manager for a rental/repair shop.Certified in most small engines

James W

James W

Small Engine Troubleshooting Expert

2,987 satisfied customers

7 years as Mechanic & Parts Manager for Brother who has Owned Lawn & Garden Repair shop for 35 years

RUSS

RUSS

SERVICE TECHNICIAN

1,723 satisfied customers

28 YEAR SERVICE TECHNICIAN

CJBennett

CJBennett

Small Engine Technician

624 satisfied customers

Briggs and Stratton Master Service Tech, Kohler, Tecumseh, Kawasaki certified. 18 years exp.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x