Small Engine

Small Engine Troubleshooting Problems? Ask a Mechanic Now.

Ask an Expert,
Get an Answer ASAP!

Related Small Engine Questions
Generator was partially under water. i replaced the
Generator was partially under water. i replaced the automatic carburetor that was bad, and it worked fine for about a month. now getting error code 1505. battery is good. generator cranks once for abo… read more
Hank F.
Hank F.
Service Technician
High School or GED
1,521 satisfied customers
I have a pole saw that in. I have a pole saw that I
I have a pole saw that I purchased a couple years ago. I tried using it the other day, and it stopped running after about 10 seconds. I tried all of the suggestions in the Manuel, and it still wouldn't run. I made sure the battery was completely changed, so i bought a new battery and chrarged it completely. Just tried it, and the saw did not work. What should I do now? … read more
Expert
Expert
I have an ariens snowblower with a Huayi 35. Reassembling
I have an ariens snowblower with a Huayi 35 carburetor. Reassembling and looking for a video or diagram showing the needle valve and whether the spring in carb kit fits on the needle valve at the floa… read more
Briggs-Fan
Briggs-Fan
2,782 satisfied customers
I have a Husqvarna 445 chainsaw. The primer ball worked the
I have a Husqvarna 445 chainsaw. The primer ball worked the first time I started the saw. 20 min later I depressed the ball and it stayed flat, then slowly inflated , not drawing gas. The saw will not… read more
Donald
Donald
Owner / Technician
High School
5,602 satisfied customers
I've been using my Troy-bilt TB5908C -4 years and never had
I've been using my Troy-bilt TB5908C for 3-4 years and never had troubles with it until two days ago. While using the trimmer attachment I began to hear a higher RPM from the head unit and noticed the… read more
Vince O.
Vince O.
Small Engine Technician
High School or GED
2,943 satisfied customers
I got a stihl ht131 pole saw. I took it in to service
I got a stihl ht131 pole saw. I took it in to service because the pole end keeps coming apart, even in a small pinch. It had a minor bend in the inner shaft that extends outside on the high cuts. It w… read more
Briggs-Fan
Briggs-Fan
2,782 satisfied customers
455 rancher 1.5 years old. Used it today ran fine but to start
455 rancher 1.5 years old. Used it today ran fine but to start I had to hold throttle wide open. Cut a few logs. Put saw down to split it up. Went to start I pulled 3 times on the 4th the rope would n… read more
Curtis B.
Curtis B.
Technician
Associate Degree
15,770 satisfied customers
I have a Poulan ES300 electric 16" chain saw bought at Sears
I have a Poulan ES300 electric 16" chain saw bought at Sears several years ago. It has run perfectly until yesterday, when the chain suddenly began to stop in the middle of a cut while the motor kept … read more
Vince O.
Vince O.
Small Engine Technician
High School or GED
2,943 satisfied customers
How do I remove a bent cylinder pin(NNN) NNN-NNNNfrom my 5hp troy-bilt
How do I remove a bent cylinder pin(NNN) NNN-NNNNfrom my 5hp troy-bilt Tomahawk Chipper/Shredder Model 15013? I lost a roll pin which caused the cylinder pin to slide and bend. I have unsuccessfully t… read more
Curtis B.
Curtis B.
Technician
Associate Degree
15,770 satisfied customers
I have a Poulan 3.5 HP electric chainsaw. I was using it and
I have a Poulan 3.5 HP electric chainsaw. I was using it and it was working fine. I sat it down and when I picked it up to cut my next item, it would not run. It acts as if no power is getting to the … read more
bluextc89
bluextc89
Owner
Vocational, Technical or Trade Scho
35 satisfied customers
I have a stihl ht 101pole saw, has worked very well, however
I have a stihl ht 101pole saw, has worked very well, however yesterday while in use I first noticed oil on my hand than while operating, the pole separated from the engine. Nothing appears broken, wha… read more
bgsengine
bgsengine
Owner
High School or GED
7 satisfied customers
I have a Stihl HT 75 saw & now the pole will not adjust. It
I have a Stihl HT 75 saw & now the pole will not adjust. It just moves & locks up. When I start the saw it acts like it has a brake on.… read more
Jon K.
Jon K.
Small Engine Diagnostic Expert
Some College, military training,
2,995 satisfied customers
I have an LT155 lawn tractor that wont start. The starter
I have an LT155 lawn tractor that won't start. The starter was spinning but the gear wouldn't jump up to engage the fly wheel. So I assumed it was the started and purchased and installed a new starter… read more
Curtis B.
Curtis B.
Technician
Associate Degree
15,770 satisfied customers
I left gas in the tank of my PP445ET pole saw this winter and
I left gas in the tank of my PP445ET pole saw this winter and now it won't start. I've replaced the fuel tubes (one in the tank broke when I checked it), installed a new spark plug, and filled it with… read more
RUSS
RUSS
SERVICE TECHNICIAN
Vocational, Technical or Trade Scho
1,723 satisfied customers
I just replaced the gas line in my poulan pro pole saw--when
I just replaced the gas line in my poulan pro pole saw--when parts put together it started 2nd pull--idled great--I attached the pole saw and went to trim some branches--each time I lifted the end up … read more
Jon K.
Jon K.
Small Engine Diagnostic Expert
Some College, military training,
2,995 satisfied customers
i just bought a poulan electric pole chainsaw. after a few
i just bought a poulan electric pole chainsaw. after a few cuts i tightened the chain as instructed. now, when i turn it on it sounds kind of funny and when it hits a branch it (the chain) stops.… read more
Jon K.
Jon K.
Small Engine Diagnostic Expert
Some College, military training,
2,995 satisfied customers
I have a Mitsubishi MGE4800 portable generator. When I open
I have a Mitsubishi MGE4800 portable generator. When I open the fuel cock, gasoline starts leaking out of just above the carburetor float chamber. Any suggestions as to the reason and how I can make i… read more
RUSS
RUSS
SERVICE TECHNICIAN
Vocational, Technical or Trade Scho
1,723 satisfied customers
I want to know,or where to find how you rewind the cutting
I want to know,or where to find how you rewind the cutting line spool on the f45 gas trimmer,I can get the spool to extend the line when it is short,like when you tap the end it should automatically e… read more
Rick
Rick
Factory Authorized Trainer
Vocational, Technical or Trade Scho
4,218 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Curtis B.

Curtis B.

Technician

15,770 satisfied customers

have worked on and around most engine models for 35 yrs./Polaris ATV expert

Rick

Rick

Factory Authorized Trainer

4,218 satisfied customers

Outdoor Power Equipment technical trainer since 1990, covering eight states.

Jon K.

Jon K.

Small Engine Diagnostic Expert

2,995 satisfied customers

Gold certified Stihl tech, Service Manager for a rental/repair shop.Certified in most small engines

James W

James W

Small Engine Troubleshooting Expert

2,986 satisfied customers

7 years as Mechanic & Parts Manager for Brother who has Owned Lawn & Garden Repair shop for 35 years

Vince O.

Vince O.

Small Engine Technician

2,943 satisfied customers

Over 30 years experience repairing lawn and garden equipment. Chainsaws, mowers,blowers and trimmers

Wayne

Wayne

Engine Rebuilder

2,108 satisfied customers

many years on egine rebuilding, lawn mower,roto tiller,Truck,and small engines

RUSS

RUSS

SERVICE TECHNICIAN

1,723 satisfied customers

28 YEAR SERVICE TECHNICIAN

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x