How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Hank F. Your Own Question
Hank F.
Hank F., Technician
Category: Small Engine
Satisfied Customers: 15263
Experience:  Certified on Onan and Generac generators
19372534
Type Your Small Engine Question Here...
Hank F. is online now
A new question is answered every 9 seconds

There seems to be no power to the solenoid connection on the

Customer Question

There seems to be no power to the solenoid connection on the starter also code 19 hen set was running fine got to campsite and shut it down got ready ro leave the next day and nothing is there a reset dor the code i know about the 15 minute disconnect and the stop botton 1 minute checked power at inverter and connections ingen set it is an 7.5cummins onan
JA: I'll do all I can to help. How long have you been dealing with this?
Customer: 2 days
JA: Do you plan on doing the work yourself?
Customer: If possible right now i am travelling and do not have the means to remove the genset
JA: Anything else we should know to help you best?
Customer: Do you need the complete model number
Submitted: 2 months ago.
Category: Small Engine
Expert:  Hank F. replied 2 months ago.
Hello, my name is ***** ***** I am going to assist you with this.
What is the full model number of the genset?
Customer: replied 2 months ago.
7.5hdkaj11451c
Customer: replied 2 months ago.
Is your reply on this page or will it appear somewhere else
Expert:  Hank F. replied 2 months ago.
Sorry, I am at work right now.
I work 2 day jobs, and usually just help on Just Answer in the evenings, but sometimes I can get in a couple questions during my breaks.
Code 19 is Governor Actuator Short or Open.
Remove the cover from the governor actator, and unplug the wire connector.
Set your meter to ohms, and place one lead to each terminal of the actuator. It should read 1.7 - 2.8 ohms.
If it reads out of range, the actator is bad.
If it reads good, touch one meter lead to either terminal of the actuator, and the other lead to a good ground.
It should read no continuity.
If you get continuity here, the actuator is bad.
If the actuator tests good, the inverter is bad.
Customer: replied 2 months ago.
As it is storming here now when it clears i will check these items as indicated and will let you know the out come
Expert:  Hank F. replied 2 months ago.

Ok.

Thank you for using Just Answer, and please take a moment to rate my assistance.

Customer: replied 2 months ago.
When we finish i will be glad to rate seems to be off to a good start
Expert:  Hank F. replied 2 months ago.

For a Code 19, it is going to be one of those 2 items.

Expert:  Hank F. replied 2 months ago.

Did the actuator test bad?

Expert:  Hank F. replied 2 months ago.

Hello, did the actuator test bad?