Small Engine

Small Engine Troubleshooting Problems? Ask a Mechanic Now.

Ask an Expert,
Get an Answer ASAP!

Small Engine

I have a GENERAC prime pact 55G rv generator. I can start it

Customer Question
from inside or out but...
I have a GENERAC prime pact 55G rv generator. I can start it from inside or out but it doesn't seem to run smoothly and at times it doesn't have the power to run the microwave & ref ridge. I think it was knocked loose on the back side where the exhaust hooks into it. Any ideas
Submitted: 1 year ago.Category: Small Engine
Show More
Show Less
Ask Your Own Small Engine Question
Answered in 15 hours by:
6/22/2016
Technician: peterpete190,
 replied 1 year ago
peterpete190
Category: Small Engine
Satisfied Customers: 29,570
Verified

My name is ***** ***** I am a professional here at Just Answer. I noticed that your question had not received a response and thought I would see if you still need help with this.I apologize for the delay and I hope I can still assist you with this here.My info is somewhat limited on your model here but I had seen no one else has responded and would like to see if I can help here.If at any time you feel that I cannot help with this please let me know.

If you have not had the fuel feed and supply checked for any issues this needs done.I have seen restricted fuel lines and fuel filters cause this fault here needing replaced or corrected.If this is or has been checked and found o.k. let me know so we can continue from here.

If more help is needed, use the reply tab to continue our conversation. If no further assistance is needed, kindly rate my service.You can rate at any time and we can continue to work on your question as this will not close out your question.Keep in mind in some cases it can be difficult to fully diagnose or help repair your vehicle without seeing it and I work on delivering the best possible answer from what I see to work with.

Thanks Pete

Ask Your Own Small Engine Question
Ask peterpete190 Your Own Question
peterpete190
peterpete190
peterpete190
Category: Small Engine
Satisfied Customers: 29,570
29,570 Satisfied Customers

peterpete190 is online now

A new question is answered every 9 seconds

How JustAnswer works:

  • Ask an ExpertExperts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional AnswerVia email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction GuaranteeRate the answer you receive.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Curtis B.

Curtis B.

Technician

14,060 satisfied customers

have worked on and around most engine models for 35 yrs./Polaris ATV expert

Rick

Rick

Factory Authorized Trainer

4,218 satisfied customers

Outdoor Power Equipment technical trainer since 1990, covering eight states.

Jon K.

Jon K.

Small Engine Diagnostic Expert

2,995 satisfied customers

Gold certified Stihl tech, Service Manager for a rental/repair shop.Certified in most small engines

James W

James W

Small Engine Troubleshooting Expert

2,986 satisfied customers

7 years as Mechanic & Parts Manager for Brother who has Owned Lawn & Garden Repair shop for 35 years

Vince O.

Vince O.

Small Engine Technician

2,844 satisfied customers

Over 30 years experience repairing lawn and garden equipment. Chainsaws, mowers,blowers and trimmers

RUSS

RUSS

SERVICE TECHNICIAN

1,723 satisfied customers

28 YEAR SERVICE TECHNICIAN

Wayne

Wayne

Engine Rebuilder

1,431 satisfied customers

many years on egine rebuilding, lawn mower,roto tiller,Truck,and small engines

< Previous | Next >

Related Small Engine Questions
I have a quick question and it sounds like you guys can
I have a quick question and it sounds like you guys can answer . I have a gx630 and I need to wire a kill switch 6 ft away from the motor. The gx630 has a key operated ignition switch. I currently hav… read more
JON
JON
Master Service Tech
MASTER SERVICE TECHNICIAN
1,460 satisfied customers
I am wiring a 20kw Generac. The control or signal wires
Hi Pearl, i am wiring a 20kw Generac. The control or signal wires connect to a new kind of block i have never seen before. They have a plastic piece with a philips head mark onto the plastic cover but… read more
Hank F.
Hank F.
Service Technician
High School or GED
5,361 satisfied customers
I was talking to somebody about my pole saw that the plastic
Hi I was talking to somebody about my pole saw that the plastic around the connection to the battery cracked and I've taped it together but I was wondering if there's a case available that I can buy t… read more
Wayne
Wayne
Engine Rebuilder
Vocational, Technical or Trade Scho
1,431 satisfied customers
I have a MTD series 300 4-cycle, two stage snowblower. I
I have a MTD series 300 4-cycle, two stage snowblower. I tried to start it today but copious amounts of smoke blew from the exhaust and the engine stalled. I checked the oil, and it smelled of gasolin… read more
JON
JON
Master Service Tech
MASTER SERVICE TECHNICIAN
1,460 satisfied customers
Craftsman Lawn tractor, 21 hp &S engine (model
Craftsman Lawn tractor, 21 hp B&S engine (model(###) ###-####1-121120ZD) was running fine, then just stopped dead. Can not restart. Turns over (saw starter gear spin-up, engage flywheel). Spark tester… read more
Curtis B.
Curtis B.
Technician
Associate Degree
14,060 satisfied customers
I have a Stihl FS36 trimmer. Trying to check why does not
I have a Stihl FS36 trimmer. Trying to check why does not start. I have spark. Cleaned carby real good. Carby is WT 1608. Want to check the needle valve works OK by blowing through a hose. Saw this te… read more
Donald
Donald
Owner / Technician
High School
2,217 satisfied customers
My Generac xg8000 stand buy gen shunts and surges so much
My Generac xg8000 stand buy gen shunts and surges so much when it runs, it has very little use. I have gas in the tank with Stabil. Should I drain tank and put in new gas or a carb cleaner ? Thanks. *… read more
JohnF2015
JohnF2015
High School Diploma
1,157 satisfied customers
I have a new 22kw generac generator and get a T1 battery
I have a new 22kw generac generator and get a T1 battery charger disconnect on my generator screen … read more
Hank F.
Hank F.
Service Technician
High School or GED
5,361 satisfied customers
What are the points settings/clearance and float level for a
what are the points settings/clearance and float level for a 4 stroke Briggs & Stratton engine on a Masport rotary hoe. Old model. … read more
Curtis B.
Curtis B.
Technician
Associate Degree
14,060 satisfied customers
I have a troy bilt vac with a Tecumseh H50-65582_. Not sure
I have a troy bilt chipper vac with a Tecumseh H50-65582_. Not sure what the last number or letter is. The engine is blown and I am looking for a replacement … read more
JohnF2015
JohnF2015
High School Diploma
1,157 satisfied customers
Which line coming out of thank goes where? two lines come
which line coming out of thank goes where ? two lines come out top to where? I think it goes to carb. … read more
Wayne
Wayne
Engine Rebuilder
Vocational, Technical or Trade Scho
1,431 satisfied customers
I have a 1997 polaris xplorer. We have had an intermittent
I have a 1997 polaris xplorer. We have had an intermittent problem with gas leaking out of the carburetor from the hoses. Recently it has begun flooding the engine. We have rebuilt the carb but the pr… read more
JON
JON
Master Service Tech
MASTER SERVICE TECHNICIAN
1,460 satisfied customers
I bought a 21R707-0011-G1 engine did not come with gas tank
I bought a 21R707-0011-G1 engine did not come with gas tank i got a799111 tank for it how does it mount … read more
JON
JON
Master Service Tech
MASTER SERVICE TECHNICIAN
1,460 satisfied customers
How do I get the program from Spanish to english. I ha an
I ha an electrician put it in thurs and some how he got it in the Spanish program … read more
Hank F.
Hank F.
Service Technician
High School or GED
5,361 satisfied customers
I'm replacing the centrifical clutch pulley on a 12 hp
I'm replacing the centrifical clutch pulley on a 12 hp Tecumseh (sawmill) engine is OHM 120 YTPXS3582AC, they have 3 rpm startings 1200, 1800, 3000 rpm. what do I need? … read more
Curtis B.
Curtis B.
Technician
Associate Degree
14,060 satisfied customers
I have 3184 cub cadet hyd deck lift leaking at top piston
I have 3184 cub cadet hyd deck lift leaking at top piston that goes up and down when lifting and lower mower deck … read more
Curtis B.
Curtis B.
Technician
Associate Degree
14,060 satisfied customers
Where to get engine wiring diagram for 20 Hp Briggs and
Where to get engine wiring diagram for 20 Hp Briggs and Stratton model no 40N877-0029. … read more
Wayne
Wayne
Engine Rebuilder
Vocational, Technical or Trade Scho
1,431 satisfied customers
Cutter blades do no engage. 1 day. Lever moves hard
cutter blades do no engage JA: I'll do all I can to help. How long have you been dealing with this? Customer: 1 day JA: Do you plan on doing the work yourself? Customer: yes JA: Anything else we shoul… read more
JON
JON
Master Service Tech
MASTER SERVICE TECHNICIAN
1,460 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x