How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site. Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Hank F. Your Own Question
Hank F.
Hank F., Technician
Category: Small Engine
Satisfied Customers: 15274
Experience:  Certified on Onan and Generac generators
Type Your Small Engine Question Here...
Hank F. is online now
A new question is answered every 9 seconds

Have a onan 2.8kvfa26100k started with carb had varnish

Customer Question

Have a onan 2.8kvfa26100k started with carb had varnish wasn't running right. I have taken off and reassembled still runs rough. I have messed with 2 linkage screws and need help starting from beginning to get generator running again.
Submitted: 1 year ago.
Category: Small Engine
Customer: replied 1 year ago.
Generator serial # ***** ..carb reads: xxxxxxxx
9 z18
Carb looks very clean inside now. Was running after I reassembled it but I turned it off from inside trailer and will not start even manually. I did take off altitude knob not sure how rich or lean it sits at this point
Expert:  Hank F. replied 1 year ago.

Are you still needing help with this?

Customer: replied 1 year ago.
I asked for a refund i never got answer