How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask JohnF2015 Your Own Question
JohnF2015
JohnF2015, Small Engine Technician
Category: Small Engine
Satisfied Customers: 1132
Experience:  Owner/Service Technician at S & J Small Engines
87465640
Type Your Small Engine Question Here...
JohnF2015 is online now
A new question is answered every 9 seconds

I have a 10 hp Lincoln welder/generator pull start, replaced

Customer Question

I have a 10 hp Lincoln welder/generator pull start, replaced coil, plug ,points and condenser. still no spark???
Submitted: 2 years ago.
Category: Small Engine
Expert:  Hank F. replied 2 years ago.
Hello!
My name is ***** ***** I am going to assist you with this.
Is this engine equipped with a magneto ignition, or a battery ignition?
Did you clean the points before installing them?
Did you set the gap to the proper .020"?
Did you use the proper spark plug (RH10)?
Did you set the plug to the properl gap? .018" if running on LP, .025" if equipped with a magneto ignition, .035" if equipped with a battery ignition.
.
Customer: replied 2 years ago.
the motor is magneto ignition new clean points, plug and properly set.
Expert:  Hank F. replied 2 years ago.
If you have replaced all of that, and still do not have spark, I am going to be unable to help you.
I will opt out and let someone else take over.
.
Customer: replied 2 years ago.
yeah I can't figure it out either, thanks for trying.
Expert:  JohnF2015 replied 2 years ago.

Hi, my name is***** will try to assist you.

Can you provide the spec number from the engine so that I can better assist you?