Small Engine

Small Engine Troubleshooting Problems? Ask a Mechanic Now.

Connect one-on-one with {0} who will answer your question

Related Small Engine Questions
Curtis. I have an extensive record with online ordering for
Hey Curtis. I have an extensive record with online ordering for a craftsman lawn tractor. Have ordered a complete lawn deck. I'm looking for a carb seal for my lawn tractor. you can find my history un… read more
Curtis B.
Curtis B.
Technician
Associate Degree
16,214 satisfied customers
I have a627809x5a snow thrower and have a fuel problem. The
I have a627809x5a snow thrower and have a fuel problem. The primer bulb would start the engine , but the engine does not continue to run, the bottom of the carb bowl is full. The manual does not show … read more
Curtis B.
Curtis B.
Technician
Associate Degree
16,214 satisfied customers
I have an old Dixon ZTR mower with a 252707 B&S engine. We
I have an old Dixon ZTR mower with a 252707 B&S engine. We replaced the point condenser and mag this spring, and it was running nicely. Last week I was mowing and it quit suddenly. I re-started and it… read more
Curtis B.
Curtis B.
Technician
Associate Degree
16,214 satisfied customers
my la115 was running lean. I fitted new carby kit, straightened
my la115 was running lean. I fitted new carby kit, straightened warped manifold. that fixed the idle problem, but now it runs rich & misfires at full throttle. needle & seat works perfectly & float le… read more
Curtis B.
Curtis B.
Technician
Associate Degree
16,214 satisfied customers
I have a toro ccr 1000 snow blower. The carb overflows fuel
I have a toro ccr 1000 snow blower. The carb overflows fuel when stopped and when the engine is running, the fuel squirts out the side of the carb thru a small hole on the left side. Is the float stuc… read more
Curtis B.
Curtis B.
Technician
Associate Degree
16,214 satisfied customers
Snapper rider 8 horse briggs pull start. Shaft connecting to
Snapper rider 8 horse briggs pull start. Shaft connecting to pull start spinning freely. Not spinning flywheel. Need to loosen shaft. Is this left thread? If I put wrench on shaft and drive with hamme… read more
Curtis B.
Curtis B.
Technician
Associate Degree
16,214 satisfied customers
Vince what is the easiest way to put the belt on a 3186 cub
Vince what is the easiest way to put the belt on a 3186 cub cadet 54" deck? Do I have to remove some bolts, or can it be done by threading the belt through some small gaps?… read more
Curtis B.
Curtis B.
Technician
Associate Degree
16,214 satisfied customers
I need to remove the reverse thread extension on the end of
I need to remove the reverse thread extension on the end of a Ryobi trimmer in order to put a new trimmer head on. However, I apparently did not put the flange washer on the last time I did this, so t… read more
Vince O.
Vince O.
Small Engine Technician
High School or GED
2,943 satisfied customers
have a craftsman garden tractor with walbro carb. believe the
have a craftsman garden tractor with walbro carb. believe the model is K1-LMH. Orderd kit but will only run at part choke. will not respond to any idle/speed adjustments. throttyle body fills up with … read more
Curtis B.
Curtis B.
Technician
Associate Degree
16,214 satisfied customers
1985 ezgo 244cc robin two cycle .. previous owner thought it
1985 ezgo 244cc robin two cycle .. previous owner thought it was blown. disassembled reassembled all checked out. 120 compression no leaks tested and verified. soaked cylinder with oil. great spark ra… read more
Jeremy R.
Jeremy R.
1,138 satisfied customers
Hello I have a early 1980,s troy bilt tiller 8 hp model
Hello I have a early 1980,s troy bilt tiller 8 hp model 195 432 type 0149-01 code 801117 11 serial# XXXXX .the pull starter broke. ordered a new one .to put the new pull on the squareish shaft on the … read more
Rick
Rick
Factory Authorized Trainer
Vocational, Technical or Trade Scho
4,218 satisfied customers
Hi Curtis, I have a Northstar generator with a Honda engine,
Hi Curtis, I have a Northstar generator with a Honda engine, circa 1993. Engine model GX240/GX270/GX340/GX390--not sure which. It was recently tuned up, but won't start. It's leaking gasoline at the f… read more
Curtis B.
Curtis B.
Technician
Associate Degree
16,214 satisfied customers
My Troy-Bilt Bronco tiller with B & S 5hp will only run on
My Troy-Bilt Bronco tiller with B & S 5hp will only run on full choke. I've taken the carb off, cleaned it up and same thing. I've tried the govenor spring in every hole. It surges when running at ful… read more
Curtis B.
Curtis B.
Technician
Associate Degree
16,214 satisfied customers
hi, i have a sears mower 158 cc 22 in cut push mower model
hi, i have a sears mower 158 cc 22 in cut push mower model XXXXXXXXX briggs and stratton 5.50 it wont run if i shoot starting fluid in it starts and runs 2 seconds thats it i took carb apart and clean… read more
Curtis B.
Curtis B.
Technician
Associate Degree
16,214 satisfied customers
Briggs&Stratton 15hp, Model 28N707,Type 0635-A1 ,Code 961023ZE History,,,
Briggs&Stratton 15hp, Model 28N707,Type 0635-A1 ,Code 961023ZE History,,, mowed lawns was ok, shut off, went to start a few hours later, it wouldnt start , removed aircleaner, it then started ok, thou… read more
Curtis B.
Curtis B.
Technician
Associate Degree
16,214 satisfied customers
hAVING TROUBLE REMOVING MAGNETO ON LV195EA ENGINE OM MY TORO
hAVING TROUBLE REMOVING MAGNETO ON LV195EA ENGINE OM MY TORO LAWN MOWER.OIL SEAL IS LEAKING. USING 3 PRONGED PULLER, IT WONT BUDGE. AM I MISSING SOMETHING? A PIN OR SOMEKIND OF FASTENER… read more
RUSS
RUSS
SERVICE TECHNICIAN
Vocational, Technical or Trade Scho
1,723 satisfied customers
removed carburetor on model 10415, serial #3904608 and now
removed carburetor on model 10415, serial #3904608 and now can't figure out where the throttle spring E connects to. This is the spring that is on the throttle shaft controlling the governor. There is… read more
TaxTom
TaxTom
Accountant
Bachelor's Degree
1,466 satisfied customers
John Deere F910 mower with a B48G 20 HP Onan. 1600 hours. Ran
John Deere F910 mower with a B48G 20 HP Onan. 1600 hours. Ran good with good power. Started missing under a load. Had plugged filters. Started missing under a load again filters were clean. Took it to… read more
TaxTom
TaxTom
Accountant
Bachelor's Degree
1,466 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Curtis B.

Curtis B.

Technician

16,214 satisfied customers

have worked on and around most engine models for 35 yrs./Polaris ATV expert

Rick

Rick

Factory Authorized Trainer

4,218 satisfied customers

Outdoor Power Equipment technical trainer since 1990, covering eight states.

Jon K.

Jon K.

Small Engine Diagnostic Expert

2,995 satisfied customers

Gold certified Stihl tech, Service Manager for a rental/repair shop.Certified in most small engines

James W

James W

Small Engine Troubleshooting Expert

2,986 satisfied customers

7 years as Mechanic & Parts Manager for Brother who has Owned Lawn & Garden Repair shop for 35 years

Vince O.

Vince O.

Small Engine Technician

2,943 satisfied customers

Over 30 years experience repairing lawn and garden equipment. Chainsaws, mowers,blowers and trimmers

Wayne

Wayne

Engine Rebuilder

2,108 satisfied customers

many years on egine rebuilding, lawn mower,roto tiller,Truck,and small engines

RUSS

RUSS

SERVICE TECHNICIAN

1,723 satisfied customers

28 YEAR SERVICE TECHNICIAN

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x