How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Donald Your Own Question
Donald
Donald, Small Engine Technician
Category: Small Engine
Satisfied Customers: 2086
Experience:  I have 25+ years of experience repairing 2 & 4 cycle engines
72377906
Type Your Small Engine Question Here...
Donald is online now
A new question is answered every 9 seconds

My zero turn husqvarna want start,Ihave changed the solenoid,ignition

Customer Question

my zero turn husqvarna want start,Ihave changed the solenoid,ignition switchand it still want start.
Submitted: 2 years ago.
Category: Small Engine
Customer: replied 2 years ago.
It has been an hour ,since I contacted you and gave my credit for payment.
I didn't recieve a conformation number nor have Iheard from you.
Customer: replied 2 years ago.
I have put a new starter and battery
Expert:  Donald replied 2 years ago.
Hello and thank you for choosing Just Answer. My name is ***** ***** I will do my very best to get you the answer you need to your question.
If you are still needing assistance, I will be happy to work with you. I will need the model numbers from your mower. I need to find a wiring diagram. With a wiring diagram, we should be able to find a solution to our problem. Thanks!
Customer: replied 2 years ago.
model #966659302
Expert:  Donald replied 2 years ago.
Thanks for this information. I did find a wiring diagram. This will be a big help. You did not mention a fuse. Have you checked for a blown fuse?
Customer: replied 2 years ago.
yes, found two fuses both 20amp .One was blowed and the other was good.
Customer: replied 2 years ago.
In myoperator manuel my model number is###-##-####rz5424.
Expert:  Donald replied 2 years ago.
I have marked the checkpoints on the wiring diagram. This will help make troubleshooting a little easier. Click on the link to open it. If you print it out, you can view it an your screen at the same time.
Expert:  Donald replied 2 years ago.
Did you replaced the blown fuse?
Customer: replied 2 years ago.
yes
Expert:  Donald replied 2 years ago.
Do you have a 12 volt test light, or a multimeter? If so, remove the wiring connector from your ignition switch. Check to see if you are getting voltage, if you probe the Red/Black wire in your wiring connector. This will confirm, whether or not you are getting power to your ignition switch.
Customer: replied 2 years ago.
nor able to finish this,because bad weather.
thank you!
Expert:  Donald replied 2 years ago.
No problem. You are very welcome! The weather is getting bad here too. We can continue whenever it is convenient for you. I am usually here after 4:00 pm central time.