Small Engine

Small Engine Troubleshooting Problems? Ask a Mechanic Now.

Connect one-on-one with {0} who will answer your question

Related Small Engine Questions
In Birmingham mich. I have a e.g. 6010 that will not fun
Hi. Nick in Birmingham mich. I have a e.g. 6010 that will not fun unless I … read more
TIMOTO
TIMOTO
Bachelor's Degree
1,326 satisfied customers
My onan 4000 generator will run if i hold the start button
My onan 4000 generator will run if i hold the start button there is no output i have replaced the carb and voltage regulator. Prior to installing the regulator i checked ohms on the number 9 and 10 sp… read more
Hank F.
Hank F.
Technician
High School or GED
17,378 satisfied customers
1988 Dayton 5000 W generator produces no AC output.
Hank, I have 1988 Dayton 5000 W generator produces no AC output. With bush leads disconnected and generator running at about 3700 rpm I get no AC volts across bushes but do get about 2.5 v ac off each… read more
Hank F.
Hank F.
Technician
High School or GED
17,378 satisfied customers
I have an np52g serial number(NNN) NNN-NNNN I have run a series
I have an np52g serial number(NNN) NNN-NNNN I have run a series of tests on it and the rotor is showing no ohm reading between the slip rings. Does this always mean that the rotor is bad?… read more
Hank F.
Hank F.
Technician
High School or GED
17,378 satisfied customers
modelNNN-NN-NNNNcraftsman AC generator doesnt produce voltage.
modelNNN-NN-NNNNcraftsman AC generator doesn't produce voltage. found burned off negative male wire terminal on bridge rectifier, replaced rectifier assembly still no output. have 1.6 ohms reading acr… read more
Hank F.
Hank F.
Technician
High School or GED
17,378 satisfied customers
I am working on an Onan 5.5HGJAB-1038c generator that has been
I am working on an Onan 5.5HGJAB-1038c generator that has been taken out of an RV and is setting on my test bench. The engine runs as long as i keep the start switch depress, once I let off it dies. I… read more
Hank F.
Hank F.
Technician
High School or GED
17,378 satisfied customers
i have a powermate pm0675700 generator starts great only produces
i have a powermate pm0675700 generator starts great only produces 4.5 volts. went to the generator head the brush module was worn out. replaced module and field flashed it. still only 4.5 volts. how d… read more
Hank F.
Hank F.
Technician
High School or GED
17,378 satisfied customers
I have a Briggs and Stratton Portable Generator Model 030235.
I have a Briggs and Stratton Portable Generator Model 030235. I think I overloaded it today. It's has no power on 110 or 220 outlets. I checked the circuit breaker and it has continunity so I guess it… read more
Hank F.
Hank F.
Technician
High School or GED
17,378 satisfied customers
My 5500EXL experienced a short of the 12V+ to ground on the
My 5500EXL experienced a short of the 12V+ to ground on the generator housing (the insulation to the wire running up to the electric start switch melted over time). The rectifier leads were fried, alo… read more
Hank F.
Hank F.
Technician
High School or GED
17,378 satisfied customers
I have a Honda EG2500XK1 JPN EZCR-1067440 During a power
I have a Honda EG2500XK1 JPN EZCR-1067440 During a power fail..I started it, and plugged in a power cord to operate a 7 amp 120V Reefer, and a lamp . all was working great..then.. The lamp started pul… read more
Hank F.
Hank F.
Technician
High School or GED
17,378 satisfied customers
Resistance Table for Stator on a 030426-0 BRiggs and stratton
Resistance Table for Stator on a 030426-0 BRiggs and stratton generator. The book 87971 does not carry my model. I get 00.6 ohms on the #11 and #22 power winding. Is this a bad stator?… read more
Hank F.
Hank F.
Technician
High School or GED
17,378 satisfied customers
ONAN GEN 10,000 MODEL 10HDCAA11506A S/N B010203851 .IT WILL
ONAN GEN 10,000 MODEL 10HDCAA11506A S/N B010203851 .IT WILL RUN FOR ABOUT 15 SEC THEN SHUTS DOWN. I GET CODE OF 13 WHICH IS A REGULATOR ,IT SAYS TO SHUT DOWN SOME POWER IN THE RV.I SHUT OFF THE MAIN B… read more
Hank F.
Hank F.
Technician
High School or GED
17,378 satisfied customers
I have a Onan 3.0 MAJB with 7 hours run time on it. It was
I have a Onan 3.0 MAJB with 7 hours run time on it. It was running fine under load and just shut down. It will now run only when you hold the start button and dies as soon as you release, but produces… read more
Hank F.
Hank F.
Technician
High School or GED
17,378 satisfied customers
I have an SDMO generator with a Leroy Somer alternator model
I have an SDMO generator with a Leroy Somer alternator model LSA 35L 6 E on it. It only produces 75 volts with engine speed correctly governed at 3600 rpm. Both rotor diodes check out good using a 9vo… read more
cameronsmallengines
cameronsmallengines
Small Engine Service Technician
High School or GED
170 satisfied customers
my generator is an old one without any fuses or reset buttons.
my generator is an old one without any fuses or reset buttons. The wires inside where the plugs are at don't look bad either. it will not produce electricity.… read more
cameronsmallengines
cameronsmallengines
Small Engine Service Technician
High School or GED
170 satisfied customers
Hello; I own a Honda generator (ES6500) that is only putting
Hello; I own a Honda generator (ES6500) that is only putting out about 89.5 VAC The brushes are OK and I checked the Bridge Rectifier behind the Voltage Reg. module - also OK. The resistance across th… read more
cameronsmallengines
cameronsmallengines
Small Engine Service Technician
High School or GED
170 satisfied customers
Onan Marquis 7000 Generator Model# 7NHMFA26106D A/C 120 AMP-56.7
Onan Marquis 7000 Generator Model# XXXXX A/C 120 AMP-56.7 HZ-60 RPM 1800 PH-1 PF-1 GASOLINE. Problem: no A/c Replaced: Brushes, Replaced 4 way voltage rectifier, replaced voltage regulator. Only volta… read more
Hank F.
Hank F.
Technician
High School or GED
17,378 satisfied customers
I have a MGE5800 generator. Engine runs fine. There is no
I have a MGE5800 generator. Engine runs fine. There is no electrical out put to the panel. Can you provide the out put voltage for the magneto and out of the power board into the coil? Thanks David XX… read more
Hank F.
Hank F.
Technician
High School or GED
17,378 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Rick

Rick

Factory Authorized Trainer

4,218 satisfied customers

Outdoor Power Equipment technical trainer since 1990, covering eight states.

Vince O.

Vince O.

Small Engine Technician

3,158 satisfied customers

Over 30 years experience repairing lawn and garden equipment. Chainsaws, mowers,blowers and trimmers

Jon K.

Jon K.

Small Engine Diagnostic Expert

2,995 satisfied customers

Gold certified Stihl tech, Service Manager for a rental/repair shop.Certified in most small engines

James W

James W

Small Engine Troubleshooting Expert

2,987 satisfied customers

7 years as Mechanic & Parts Manager for Brother who has Owned Lawn & Garden Repair shop for 35 years

RUSS

RUSS

SERVICE TECHNICIAN

1,723 satisfied customers

28 YEAR SERVICE TECHNICIAN

CJBennett

CJBennett

Small Engine Technician

624 satisfied customers

Briggs and Stratton Master Service Tech, Kohler, Tecumseh, Kawasaki certified. 18 years exp.

Chris Huber

Chris Huber

Small Engine Technician

576 satisfied customers

20 years experience. Briggs and Stratton Master Service Technician. Dealer for most engine lines.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x