Small Engine

Small Engine Troubleshooting Problems? Ask a Mechanic Now.

Connect one-on-one with {0} who will answer your question

Related Small Engine Questions
I have 4 chain saw and they allm seem tomhave the same
i have 4 chain saw and they allm seem tomhave the same problem. here ism what i have done .cleaned the filter. cleaned the sparkplug,poured out the old gas and put in , replaced with high octane fuel … read more
Curtis B.
Curtis B.
Technician
Associate Degree
19,291 satisfied customers
I have A 18 pOULAN pp4218avx pro chain saw ad was useing
I have A 18 " pOULAN pp4218avx pro chain saw ad was useing it when i put it down to move some limbs away I tried to start it up again and it will start up but when you give it the gas it shuts it self… read more
James W
James W
Small Engine Troubleshooting Expert
Bachelor's Degree
2,989 satisfied customers
My &S engine in my generator model 93412 type 0136 01
My B&S engine in my Coleman generator model 93412 type 0136 01 governor is causing the engine speed to oscillate between fast and slow. What should I be looking for to fix… read more
Donald
Donald
Owner / Technician
High School
7,310 satisfied customers
I pull garden pulling tractors and I put a new predator 301
I pull garden pulling tractors and I put a new predator 301 on it and my 1st pull was good but after that something must of happen to my engine cause it want rev up past 5,000 rpms and it sounds like … read more
Briggs-Fan
Briggs-Fan
2,794 satisfied customers
I have a Troy Bilt generator with a briggs and stratton
Hi I have a Troy Bilt generator with a briggs and stratton model 204412 engine. My terminal oil plug got disconnected from the wire inside the block. I can see the wire and terminal but cannot get it … read more
Curtis B.
Curtis B.
Technician
Associate Degree
19,291 satisfied customers
I HAVE A 2 CYLINDER KAWASAKI 19HP MODEL/OR CODE FH601D.
HI, I HAVE A 2 CYLINDER KAWASAKI 19HP MODEL/OR CODE FH601D. PROBLEM, FIRES ON #2 CYLINDER ONLY. I CAN PULL THE PLUG WIRE ON #1 AND NO CHANGE. IF I PULL #2 ENGINE WILL DIE. I PULLED PLUGS AND BOTH HAVE… read more
JohnF2015
JohnF2015
High School Diploma
3,210 satisfied customers
Kohler Command 17.5. Wont start. Compression (cold) 90. Good
Kohler Command 17.5. Won't start. Compression (cold) 90. Good spark. Question vacuum. Plug does not get wet, even with shot of starter fluid. Cleaned carb. Backfires. Cleaned and resurfaced valves. So… read more
Curtis B.
Curtis B.
Technician
Associate Degree
19,291 satisfied customers
I have a 13.5 HP briggs and stratton on my leaf blower. Its
I have a 13.5 HP briggs and stratton on my leaf blower. It's a brand new engine. Very clean, new plugs, filters, clean oil, clean fuel... etc. I cannot start the engine. A friend was using it last yea… read more
Jon K.
Jon K.
Small Engine Diagnostic Expert
Some College, military training,
2,995 satisfied customers
Same problem--10 yrold McC 3214 chain saw - rotted plastic
Same problem--10 yrold McC 3214 chain saw - rotted plastic fuel lines from primer pump to tank and carburetor to tank. There is a plastic wall between the carb compartment and the tank that has two ho… read more
Ranwell1
Ranwell1
CEO
High School or GED
6,046 satisfied customers
Just Bought a Poulan Pro pp446et Pole Saw/String trimmer
Just Bought a Poulan Pro pp446et Pole Saw/String trimmer form a coworker. Had only been used last fall for 30 min., then stored with gas left in it all winter. Now it starts , idles fine but will not … read more
James W
James W
Small Engine Troubleshooting Expert
Bachelor's Degree
2,989 satisfied customers
18.5 hp B & S twin, L head with electric start and alternator,
18.5 hp B & S twin, L head with electric start and alternator, 1997 model 42D777. This engine has surged for many years. It's annoying, but I've lived with it. It cranks over fast, and while it could … read more
Curtis B.
Curtis B.
Technician
Associate Degree
19,291 satisfied customers
Chainsaw Mod P3816. I have not been able to get it started
Chainsaw Mod P3816. I have not been able to get it started following the directions in the manual. Now what?… read more
James W
James W
Small Engine Troubleshooting Expert
Bachelor's Degree
2,989 satisfied customers
I need somebody who is a Tecumseh small engine expert. I have
I need somebody who is a Tecumseh small engine expert. I have a friends Lawnmower that was bought new was use one year and then was left setting for 3 years. It has a Tecumseh 3.5HP Model LEV80 333004… read more
Ranwell1
Ranwell1
CEO
High School or GED
6,046 satisfied customers
I have a 5.5HGJAB-1038C generator in my 2005 Pace Arrow. While
I have a 5.5HGJAB-1038C generator in my 2005 Pace Arrow. While the rig is garaged, I try to start the generator and it starts, but only runs for 1-3 minutes before quitting. The fuel tank in the rig i… read more
Hank F.
Hank F.
Service Technician
High School or GED
1,541 satisfied customers
I have a emerald 1 onan genorator in a rv use for dog rescue
I have a emerald 1 onan genorator in a rv use for dog rescue and the genorator won't start not even on Ether is there a saftey if it is not getting spark? I don't even know where to start on this. we … read more
Hank F.
Hank F.
Service Technician
High School or GED
1,541 satisfied customers
Blower BVM200LE. Bought 9/27/08. Used one season for leaf
Blower BVM200LE. Bought 9/27/08. Used one season for leaf pickup and blowing. 9/09 - unit would not start. Took into authorized dealer, B&L Outdoor Power Equip. Co. They said cylinder only had 80 PSI.… read more
Ranwell1
Ranwell1
CEO
High School or GED
6,046 satisfied customers
I have a 1989 7.5 KW Kohler generator as the power plant of
I have a 1989 7.5 KW Kohler generator as the power plant of a 40-ft cruiser. Genset has about 1700 hours and has never had any major problems. But recently, it starts and runs normally, then after abo… read more
Hank F.
Hank F.
Service Technician
High School or GED
1,541 satisfied customers
Ive had my stihl fs 110r for about 4 years now and have never
I've had my stihl fs 110r for about 4 years now and have never had a problem till this spring. I have had a near impossible time getting it to start. I took it to two different small engine repair pla… read more
Rick
Rick
Factory Authorized Trainer
Vocational, Technical or Trade Scho
4,218 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Curtis B.

Curtis B.

Technician

19,291 satisfied customers

have worked on and around most engine models for 35 yrs./Polaris ATV expert

Rick

Rick

Factory Authorized Trainer

4,218 satisfied customers

Outdoor Power Equipment technical trainer since 1990, covering eight states.

Vince O.

Vince O.

Small Engine Technician

3,347 satisfied customers

Over 30 years experience repairing lawn and garden equipment. Chainsaws, mowers,blowers and trimmers

Jon K.

Jon K.

Small Engine Diagnostic Expert

2,995 satisfied customers

Gold certified Stihl tech, Service Manager for a rental/repair shop.Certified in most small engines

James W

James W

Small Engine Troubleshooting Expert

2,989 satisfied customers

7 years as Mechanic & Parts Manager for Brother who has Owned Lawn & Garden Repair shop for 35 years

RUSS

RUSS

SERVICE TECHNICIAN

1,723 satisfied customers

28 YEAR SERVICE TECHNICIAN

roger

roger

Small Engine Technician

390 satisfied customers

23 years of being a shop owner..small engine trade schools

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x