Small Engine

Small Engine Troubleshooting Problems? Ask a Mechanic Now.

Connect one-on-one with {0} who will answer your question

Related Small Engine Questions
I need to buy a generator to allow us to remodel homes
I need to buy a generator to allow us to remodel homes before we have power in them.As I consider generators I realize I need to spend $1,000 to get what I want. I see that inverter generators are nee… read more
Don
Don
fleet superintendent
Vocational, Technical or Trade Scho
1,636 satisfied customers
My ***** ***** bilt 2410 snowblower will start but won't run
Customer: My ***** ***** bilt 2410 snowblower will start but won't run unless fully choked and won't rev even when it has run long enough to warm up. Suspect bad gas in the carburetor, but can't readi… read more
Vince O.
Vince O.
Small Engine Technician
High School or GED
3,195 satisfied customers
My &S engine in my generator model 93412 type 0136 01
My B&S engine in my Coleman generator model 93412 type 0136 01 governor is causing the engine speed to oscillate between fast and slow. What should I be looking for to fix… read more
Donald
Donald
Owner / Technician
High School
7,302 satisfied customers
I pull garden pulling tractors and I put a new predator 301
I pull garden pulling tractors and I put a new predator 301 on it and my 1st pull was good but after that something must of happen to my engine cause it want rev up past 5,000 rpms and it sounds like … read more
Briggs-Fan
Briggs-Fan
2,794 satisfied customers
I have a Troy Bilt generator with a briggs and stratton
Hi I have a Troy Bilt generator with a briggs and stratton model 204412 engine. My terminal oil plug got disconnected from the wire inside the block. I can see the wire and terminal but cannot get it … read more
Curtis B.
Curtis B.
Retired service manager
Associate Degree
3,938 satisfied customers
I have an Onan 4.0 CCK Spec R that fried the 300C859 board.
I have an Onan 4.0 CCK Spec R that fried the 300C859 board. I got another one and installed it, placing all wires at the proper terminals. After starting the Genset, the very same resistor, R1, got ex… read more
Hank F.
Hank F.
Service Technician
High School or GED
1,541 satisfied customers
Hi, I have a 12 year old 15kW unit with a 1 Liter (2 cylinder)
Hi, I have a 12 year old 15kW unit with a 1 Liter (2 cylinder) engine. It isn't getting propane. There is spark, but if I get it to start, it runs rough and then conks out. I have Diagnostic Repair Ma… read more
Hank F.
Hank F.
Service Technician
High School or GED
1,541 satisfied customers
Ladies and Gentlemen, I am trying to sell my Generac Power
Ladies and Gentlemen, I am trying to sell my Generac Power Model QT045 24ANSN and would like to know if you could get me an asking price for it. It is in excellent condition, is installed indoors and … read more
James W
James W
Small Engine Troubleshooting Expert
Bachelor's Degree
2,987 satisfied customers
Am interested in a generator to provide emergency power in
Am interested in a generator to provide emergency power in the event of a power outage. I live in a rural area with a well, have electric heat. Need something that will automatically start up and can … read more
Don
Don
fleet superintendent
Vocational, Technical or Trade Scho
1,636 satisfied customers
Hi, I have an Onan 20ES propane fueled 4 cyl Ford engine driven
Hi, I have an Onan 20ES propane fueled 4 cyl Ford engine driven generator that I purchased used, about six years ago. It does not carry the load as it once did. I live in the forest with no grid power… read more
Hank F.
Hank F.
Service Technician
High School or GED
1,541 satisfied customers
Hank, you answered a justanswer users question about an Onan
Hank, you answered a justanswer user's question about an Onan 4.5BGD, rewiring it for 240V. Here is part of your answer. "I have uploaded the instructions for rewiring. The instructions are on page 59… read more
Hank F.
Hank F.
Service Technician
High School or GED
1,541 satisfied customers
I have a 70s model EK 220 single phase. It started and ran
I have a 70's model EK 220 single phase. It started and ran when purchased in Orlando last year. I transported this beast to Houston, Texas where it has sat until now( hurrican season is involved in i… read more
Hank F.
Hank F.
Service Technician
High School or GED
1,541 satisfied customers
What can you tell me about this model of generator 45EM-
What can you tell me about this model of generator? 45EM-4XR8/5746A When were these made? Average life expectancy in run hours? Voltage outputs? Any "usual" problems associated with this brand/type of… read more
Hank F.
Hank F.
Service Technician
High School or GED
1,541 satisfied customers
The pin in the carter which turn to regulate the speed is not
The pin in the carter which turn to regulate the speed is not working anymore. The machine runs at max revs when started. Only with my hand I can slow down the revs. It is the pin that is connected wi… read more
Hank F.
Hank F.
Service Technician
High School or GED
1,541 satisfied customers
Purchased a used coleman powermate 15kw, with a 3 cylinder
Purchased a used coleman powermate 15kw, with a 3 cylinder water cooled diahatsu engine. Starts up but idles only. will not increase rpms even when putting an electrical load on it. Have to push and h… read more
Hank F.
Hank F.
Service Technician
High School or GED
1,541 satisfied customers
Onan Marquis 7000, model 7NHMFA26105H wilth 800 hours (9 yrs
Onan Marquis 7000, model 7NHMFA26105H wilth <800 hours (9 yrs old) well maintained i.e. air filters, oil filters, oil changes, spark plugs. Unit is in a Tiffin built year 2000 Allegro Bay motor hom… read more
Hank F.
Hank F.
Service Technician
High School or GED
1,541 satisfied customers
I have a Guardian 9000 watt portable gas generator with a 16HP
I have a Guardian 9000 watt portable gas generator with a 16HP Vanguard Briggs & Stratton Engine. I have serviced oil/filter/air filter including draining the gas tank, & sprayed the carb linkage with… read more
Ranwell1
Ranwell1
CEO
High School or GED
5,898 satisfied customers
I have an ETQ TG7000 gas powered generator. It was putting
I have an ETQ TG7000 gas powered generator. It was putting out 220 volts and then when I turned it off and back on - it only puts out 9-10 v. I traced this back to the generator through the wiring pan… read more
The Small Engine Doctor
The Small Engine Doctor
One year, Automotive Tech toward as
46 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

Rick

Rick

Factory Authorized Trainer

4,218 satisfied customers

Outdoor Power Equipment technical trainer since 1990, covering eight states.

Vince O.

Vince O.

Small Engine Technician

3,195 satisfied customers

Over 30 years experience repairing lawn and garden equipment. Chainsaws, mowers,blowers and trimmers

Jon K.

Jon K.

Small Engine Diagnostic Expert

2,995 satisfied customers

Gold certified Stihl tech, Service Manager for a rental/repair shop.Certified in most small engines

James W

James W

Small Engine Troubleshooting Expert

2,987 satisfied customers

7 years as Mechanic & Parts Manager for Brother who has Owned Lawn & Garden Repair shop for 35 years

RUSS

RUSS

SERVICE TECHNICIAN

1,723 satisfied customers

28 YEAR SERVICE TECHNICIAN

roger

roger

Small Engine Technician

390 satisfied customers

23 years of being a shop owner..small engine trade schools

bgsengineclinic

bgsengineclinic

Small Engine Technician

380 satisfied customers

Over 20 years of experience in Small engine repair, Kohler Certified Expert Technician, Self-Employed in my own dealership.

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x