Small Engine
Connect one-on-one with a technician who will answer your question
Expert avatar
Curtis B., Technician
15,478 satisfied customers
have worked on and around most engine models for 35 yrs./Polaris ATV expert
Pearl avatarPearl Wilson, Assistant
Technician is Online Now

Have small engine troubleshooting questions?

Verified technicians are online around the clock and ready to answer your question online or by phone. 
Related Small Engine questions
How can i tell if my starter solenoid 1s working. About 1
about 1 week i have replaced both. But feel the solenoid still is not working properly … read more
Curtis B.
Curtis B.
Technician
Associate Degree
15,478 satisfied customers
My child's Polaris outlaw 50cc has a problem.The throttle
My child's Polaris outlaw 50cc has a problem.The throttle does not release after starting … read more
Curtis B.
Curtis B.
Technician
Associate Degree
15,478 satisfied customers
Have a deere L110. Will not crank or turn over. Change
Have a john deere L110. Will not crank or turn over. Change solenoid, battery good, starter good, fuel filter is good, carburetor new, smoke coming from battery area when ignition is turned on. Clicki… read more
Curtis B.
Curtis B.
Technician
Associate Degree
15,478 satisfied customers
I have onan p216 that is surging/hunting at high throttle
I have onan p216 that is surging/hunting at high throttle while mowing.what could be cause/ fix? … read more
Curtis B.
Curtis B.
Technician
Associate Degree
15,478 satisfied customers
I have a Toro 6.5 Recycler GTS. It will not start. I've
I have a Toro 6.5 Recycler GTS. It will not start. I've replaced the carburetor and the starter coil. The plug, air filter, oil change. No start. what can I check now? … read more
Curtis B.
Curtis B.
Technician
Associate Degree
15,478 satisfied customers
Have a Generac 27 hp on my 2008 Dixie Chopper. New two
Have a Generac 27 hp on my 2008 Dixie Chopper. New two seasons ago. Took in for service this spring, Got it back. Few weeks later went to start it … read more
JohnF2015
JohnF2015
High School Diploma
1,238 satisfied customers
I have a cub cadet lt1018 I was mowing the yard and it cut
I have a cub cadet lt1018 I was mowing the yard and it cut off at first it would crank but not start now it turns a half of a turn and stops … read more
Curtis B.
Curtis B.
Technician
Associate Degree
15,478 satisfied customers
Got a Z-254 with very low power. Started 2 weeks ago when it
started 2 weeks ago when it basically would not move forward. Replaced belts and had it serviced. Moves forward but slow. … read more
JON
JON
Master Service Tech
MASTER SERVICE TECHNICIAN
1,852 satisfied customers
MY Mower will start, but diesa off right away. When I prime
MY Mower will start, but diesa off right away. When I prime it, it starts within a pull or two, rev's up, and the slowly dies. … read more
Curtis B.
Curtis B.
Technician
Associate Degree
15,478 satisfied customers
I have a troy-bilt generator and I'm having trouble starting
I have a troy-bilt generator and I'm having trouble starting it, wont start by battery power and manually the cord seems to be jammed do you have any suggestions? … read more
Hank F.
Hank F.
Service Technician
High School or GED
5,365 satisfied customers
I have a mtd riding mower I cannot get it to start,I put a
Richard I have a mtd riding mower I cannot get it to start,I put a new battery,starter,sylnoid,coil and 2 new safety switches one on the clutch and one on the blades.when I go to start it,it won't tur… read more
JohnF2015
JohnF2015
High School Diploma
1,238 satisfied customers
Have mod 31p977,0635e1,,motor chocks out when mower blade
have mod 31p977,0635e1,,motor chocks out when mower blade gear is operated … read more
Curtis B.
Curtis B.
Technician
Associate Degree
15,478 satisfied customers
Can,t get my tiller out of gear so it will move. Yardmach
can,t get my tiller out of gear so it will move JA: What's the make and model of the tiller? And can you guesstimate how old it is? Customer: yardmach mod 618-04593 dont know year JA: Do you plan on d… read more
Curtis B.
Curtis B.
Technician
Associate Degree
15,478 satisfied customers
I have Honda GCV160 and it was working fine. This morn it
Hi. I have Honda GCV160 and it was working fine. This morn it started up right away then I realized I had no water flow from house as had turned off valve. I shut unit down, got water back on. Restart… read more
Curtis B.
Curtis B.
Technician
Associate Degree
15,478 satisfied customers
Ex commercial rear riding 22hp Kohler. Made a loud pop and
Ex mark commercial rear riding 22hp Kohler. Made a loud pop and shut off .will not start back … read more
Curtis B.
Curtis B.
Technician
Associate Degree
15,478 satisfied customers
Replaced coil & carb on 14 HP MTD. Engine runs but misses
Replaced coil & carb on 14 HP MTD. Engine runs but misses out, blows black smoke and fouls plugs … read more
Curtis B.
Curtis B.
Technician
Associate Degree
15,478 satisfied customers
I need parts for an older Lincoln welder. The welder is
I need parts for an older Lincoln welder. The welder is model #ac-225/dc-210/6. I have looked on several sites and am having trouble finding tis welder.… read more
Curtis B.
Curtis B.
Technician
Associate Degree
15,478 satisfied customers
I have a Cub Cadet Z54 mower. When you pull the PTO switch
I have a Cub Cadet Z54 mower. When you pull the PTO switch the charge light comes on an eventually the mower will die until you charge it back up. If you disengage the PTO the charge light goes out. W… read more
Curtis B.
Curtis B.
Technician
Associate Degree
15,478 satisfied customers

Get small engine troubleshooting help online


Following here are examples of small engine repair questions already asked on JustAnswer:


  • I changed the spark plug in my Simplicity garden tractor and cleaned and gapped the coil. However, it still won’t start. Any suggestions?
  • Where can I find the wiring diagram for a Briggs 405777 0112E 030206YG?
  • My pressure washer is blowing the pressure hose. Is this caused by the thermal relief valve, or is the problem in the pump?
  • Would you know the weight and dimensions of a Cub Cadet?
  • We have a Tecumseh HM100 with a 5000 watt generator, and we need to replace the governor. How do I separate the generator from the engine?

Before bringing your questions to the Experts on JustAnswer, be sure to prepare any information you believe would be helpful to whoever assists you. This includes your machine’s make and model, any symptoms or issues you’ve noticed, and any troubleshooting you’ve already attempted.