Pool and Spa

Questions about pool repair? Ask an Expert online.

Connect one-on-one with {0} who will answer your question

Related Pool and Spa Questions
I have a J355 JACUZZI SPA i HAVE THE 616 ERROR CODE
hi i have a J355 JACUZZI SPA i HAVE THE 616 ERROR CODE FLASHING. i READ THAT MEANS I NEED TO CHANGE THE CLEARRAY BULB AND RESET THE TIMER. i CHECKED AND CONFIRMED I DO NOT HAVE THE CLEAR RAY SYSTEM I … read more
TheHotTubGuy
TheHotTubGuy
483 satisfied customers
I have a Vita Spa....Just had the 2 pumps worked on because
I have a Vita Spa....Just had the 2 pumps worked on because the left pump was leaking....I put them in and no leaks....However the left pump is quite loud and when I press the switch to bring both pum… read more
poolguy810
poolguy810
owner - pool and spa service company
2 years electro mechanical training
1,675 satisfied customers
Pool Guy 810, calling from Spring ll Florida. Are you
Hello Pool Guy 810, This is John calling from Spring Hill Florida. Are you available to talk about a problem with a Jacuzzi Hot Tub?… read more
poolguy810
poolguy810
owner - pool and spa service company
2 years electro mechanical training
1,675 satisfied customers
I get a 3 DOT error identification on my display. when I
i get a 3 DOT error identification on my display. when I open up the control box I have a light on the circuit board by a C29. If the 3 dot error message is not on I don't get that light by the C29. w… read more
Fix my Pool and Spa
Fix my Pool and Spa
Sales Manager
Certified Service Technician
1,135 satisfied customers
I replaced the pump and motor in my hot tub. When I first
I replaced the pump and motor in my hot tub. When I first installed it, it ran in low speed and then kicked into high on its own. Now it only seems to run on high, no matter how I try to adjust things… read more
poolguy810
poolguy810
owner - pool and spa service company
2 years electro mechanical training
1,675 satisfied customers
I'm having the same problem as the thing I'm looking at. A
I'm having the same problem as the thing I'm looking at. A vanguard 2001 spa, and I keep needing to reset the heater switch, but the filters are new, as are the panels. What else could it be?… read more
AssuredElectrical
AssuredElectrical
Electrical Contractor
High School or GED
3,844 satisfied customers
I have a cal spa tub the model number is ***** I set
I have a cal spa tub the model number is ***** I set the temp at 99 degrees, It seems to cycle fine, but the temp slowly increases over a matter of a few days until it hits 110 and shuts down. Does it… read more
Mike R.
Mike R.
3,168 satisfied customers
I have a 2002 master spa and I need to know what the codes
I have a 2002 master spa and I need to know what the codes F0 through F-8 mean. Also either code 5L or S-L… read more
Steve G.
Steve G.
Chief Engineer
801 satisfied customers
I have 10 year Sarratoga SPa Victoria with Gecko Controls.
I have 10 year Sarratoga SPa Victoria with Gecko Controls. My top side control always flashes 86 degrees. The heater & ciculator remain on with setpoint of 102 and the temperature keeps climbing (107 … read more
poolguy810
poolguy810
owner - pool and spa service company
2 years electro mechanical training
1,675 satisfied customers
I have a BAJA WHITEWATER SPA, Model # XXXXX 44 28.Over the very
I have a BAJA WHITEWATER SPA, Model # XXXXX 44 28. Over the very cold winter I could not raise the temperature which remained stuck at 54F. It has since with Spring risen up to 62F. Older original reb… read more
TheHotTubGuy
TheHotTubGuy
483 satisfied customers
i have a 2007 Sundance Optima 880. I think the temperature
i have a 2007 Sundance Optima 880. I think the temperature sensor is bad. The control panel says the water should be 97degrees but in fact the water is over 105 degrees. What do believe the diagnosis … read more
poolguy810
poolguy810
owner - pool and spa service company
2 years electro mechanical training
1,675 satisfied customers
I have a strong spa-the heat keeps a contant 104, but I cant
I have a strong spa-the heat keeps a contant 104, but I can't get the jets on or light on. the aux. won't turn on either. And I can't turn the heat up or down. It seems the digital push pad isn't work… read more
Poolservice123
Poolservice123
Owner
Associate Degree
489 satisfied customers
I have an Auqalink RS4 controller by Jandy. When I turn on
I have an Auqalink RS4 controller by Jandy. When I turn on the heater to my spa, the spa light flashes / blinks about once per second until the temperature is reached. It's very annoying. Can that be … read more
Poolservice123
Poolservice123
Owner
Associate Degree
489 satisfied customers
We have a 2008 jacuzzi hot tub model number j-345 that has
We have a 2008 jacuzzi hot tub model number j-345 that has a watchdog safety warning that deactivates the spa indicating a problem. The indicator looks like this (_ _ _ ). Thinking that maybe the ther… read more
TheHotTubGuy
TheHotTubGuy
483 satisfied customers
I have a Baja Whitewater 1068 that was purchaed in 2001 for
I have a Baja Whitewater 1068 that was purchaed in 2001 for $7700. It is in great condition and has been serviced and maintained regularly. It could use a new cover, but the one I have is OK. It is in… read more
poolguy810
poolguy810
owner - pool and spa service company
2 years electro mechanical training
1,675 satisfied customers
I have a Beachcomber hot tub Model #550c spa ser#b3546 pak
I have a Beachcomber hot tub Model #550c spa ser#b3546 pak ser #b3546 and MFG date 04-2001. How do you change light bulb ? also if I put the tub on foam insulation will it cut down on noise heard in t… read more
Fix my Pool and Spa
Fix my Pool and Spa
Sales Manager
Certified Service Technician
1,135 satisfied customers
I have a catalina spa and am getting an Ec error message.
I have a catalina spa and am getting an "Ec" error message. Everything seems to be working properly. Filters needed cleaned for sure and I did that. Do you know what this error means? Do I need to res… read more
poolguy810
poolguy810
owner - pool and spa service company
2 years electro mechanical training
1,675 satisfied customers
I have a cal spa model 3-3da-44 with a manufacture date of
I have a cal spa model 3-3da-44 with a manufacture date of quarter 4-2 03. the controller is a cs5000. The question is, I get a OH fault when it gets to the preset temp 100 degrees. I can reset it by … read more
poolguy810
poolguy810
owner - pool and spa service company
2 years electro mechanical training
1,675 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

poolguy810

poolguy810

owner - pool and spa service company

1,675 satisfied customers

Servicing pools and all brands of spas for over 28 years.

Jerry

Jerry

Technician

310 satisfied customers

owned and operated spa and pool retail store for 12 yrs

PitschPlumbing

PitschPlumbing

master plumber

185 satisfied customers

Factory Authorized service for Rheem, Raypak, Jandy and Laars pool heaters. Gas licensed

spaman101

spaman101

spa/hot tub technician

125 satisfied customers

Spa repair and troubleshooting ..

Charles

Charles

Technician

38 satisfied customers

20 years experience

Poolscaper

Poolscaper

Pool and Spa Installer

26 satisfied customers

I own & operate a full service Pool & Spa Const.~ Service~Retail store

answersmadeeasy

answersmadeeasy

Pool Technician

13 satisfied customers

Experienced in pool and spa equip, heaters, salt systems

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x