How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Machinc Your Own Question
Machinc
Machinc, General Contractor
Category: Pool and Spa
Satisfied Customers: 913
Experience:  Has written home improvement articles since 2008. Earned South Carolina Residential Builders License in 1991.
75209918
Type Your Pool and Spa Question Here...
Machinc is online now
A new question is answered every 9 seconds

I have jandy lights in my pool and spa. There are two lights

Customer Question

I have j***** *****ghts in my pool and spa. There are two lights in the spa controlled by the same AUX. One of the spa lights goes off and on every two or three minutes, the other one stays lit. The pool light is fine.I have tried resetting the breaker and reprogramming the light on the Aqualink remote but neither of these worked. Any thoughts you have would be appreciated.
Submitted: 11 months ago.
Category: Pool and Spa
Expert:  Machinc replied 11 months ago.
If you are sure the bulb is good then it is most likely a loose connection.
Expert:  Machinc replied 11 months ago.
This can be anywhere from where the bulb is placed to the wiring to the bulb
Expert:  Machinc replied 11 months ago.
Since only one is doing it it is in
the circuit to that light .
Expert:  Machinc replied 11 months ago.
If wired on one wire for both lights then there is a splice or split to the one that blinks.
This point is a likely place gor the trouble.
Expert:  Machinc replied 11 months ago.
If there are two wires (cables) one for each light wired all the way back to the "aux" check connections at the AUX.
Expert:  Machinc replied 11 months ago.
If that is the case try connecting just the one that blinks to test its overall wiring
Expert:  Machinc replied 11 months ago.
Make sure connections are clean, tight , and free of corrosion.
Expert:  Machinc replied 11 months ago.
NOTE: If these are 120 volt lights it would be best to have a licensed electrician correct the ptoblem