How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask poolguy810 Your Own Question
poolguy810, owner - pool and spa service company
Category: Pool and Spa
Satisfied Customers: 1675
Experience:  Servicing pools and all brands of spas for over 28 years.
Type Your Pool and Spa Question Here...
poolguy810 is online now
A new question is answered every 9 seconds

I have a VITA Spa L200. When power is turned on topside

Customer Question

Hi Jerry, I have a VITA Spa L200. When power is turned on topside shows temp then filter icon comes on then second later FLO flashes then I hear a click then sequence starts over again and continues same sequence until I shut the power off. I have replaced the pressure switch
Submitted: 1 year ago.
Category: Pool and Spa
Expert:  Billy replied 1 year ago.


is the circulator pump running during this time?

And if so have you removed the filter to see if code goes away?

Customer: replied 1 year ago.
No pump running,filter removed.
Expert:  Billy replied 1 year ago.

Thank you...nothing can happen until the circulator pump runs...which cause water to flow...which closes pressure switch...

We now need to see if the motor gets power but does not run (bad motor) or motor does NOT get power (bad board)

Customer: replied 1 year ago.
I bipassed the pressure switch nothing changed.I unplugged topside, pump comes on one or two seconds then nothing.
Expert:  Billy replied 1 year ago.

so we still have no circulation pump activity?

That is our main concern right now. The circulator pump must run before anything can continue

Customer: replied 1 year ago.
Expert:  poolguy810 replied 1 year ago.

If you're still needing help with this, just let me know. I'll need you to post me a picture of the equipment area so I can walk you through some testing. Thanks, Jeff