Pool and Spa

Questions about pool repair? Ask an Expert online.

Connect one-on-one with {0} who will answer your question

Related Pool and Spa Questions
Have Sundance Optima 880 (2011) Installed new heater and flo
Have Sundance Optima 880 (2011) Installed new heater and flo switch. Heater worked great for a couple of days. Now, the heater symbol comes up on the control panel and goes back off after a few second… read more
Fix my Pool and Spa
Fix my Pool and Spa
Owner / Technition
Certified Service Technician
1,154 satisfied customers
La kona spa error code flo come on i checked filter i can
la kona spa error code flo come on i checked filter i can manually set temp one motor but low speed wont come on only clicks high speed heats up ok … read more
TheHotTubGuy
TheHotTubGuy
483 satisfied customers
FLO warning on my Vita Spa LC560. I pulled breaker, I
FLO warning on my Vita Spa LC560. I pulled breaker, I drained it, refilled it, changed filter, and reset computer by holding PROG for 5 seconds. Still have same issue … read more
Fix my Pool and Spa
Fix my Pool and Spa
Owner / Technition
Certified Service Technician
1,154 satisfied customers
I am getting 120v to my heater element. 2004 Hydrospa 3,
I am getting 120v to my heater element. 2004 Hydrospa mark 3, circ pump, element, and pressure switch all new.… read more
poolguy810
poolguy810
owner - pool and spa service company
2 years electro mechanical training
1,735 satisfied customers
, I have a 2005 sundance maxxus 3 pump hot tub. i was
I have a 2005 sundance maxxus 3 pump hot tub. i was experiencing issues with temperature and OH errors on the control board so I replaced the temperature sensor. The tub worked for a few days, but then would need to be turned off at the main breaker and reset. Checking the voltage at the circuit board showed 120 on each incoming line, but not 240 in combination. More research led me to believe that the circuit board was bad, so I replaced that too. The tub powered on after the circuit board replacement, the topside control showed a FLO error and one of the pump indicators was lit but it it didn't sounds like it was on. I selected another pump, and the tub immediately shut down, and I have nothing on my topside control. Any thoughts? I plan to check the fuses again tonight when I get home..but I am leaning towards a new control board. The temps in my area have been hovering around 0 degrees, but I have a heater keeping the inside of the tub surround and pumps warm (38 degrees) I don't believe anything has frozen, but would a frozen component shut my system down that quickly (seconds after activation) I was not getting an ICE error at the time. … read more
garrygoeson
garrygoeson
Owner/Operator
Associate Degree
469 satisfied customers
I have replaced my heater circuit board and thermistors.
I have a hot springs vanguard. I have replaced my heater circuit board and thermistors. When I direct wired the heater to power it worked. But it doesn't seem to want to work on its own. I have no pow… read more
TheHotTubGuy
TheHotTubGuy
483 satisfied customers
Trying to start up a bengal tiger river spa, jets and light
trying to start up a bengal tiger river spa, jets and light are working, but I'm not sure if the heater is working. Also, I can't find any reset switch on the heater. An extension part from the silver… read more
TheHotTubGuy
TheHotTubGuy
483 satisfied customers
Pool Guy! It looks like you're in Dayton! Make trips to Cin
Hello Pool Guy! It looks like you're in Dayton! Make trips to Cincinnati? We have a hot tub that is on the fritz and it looks like you've diagnosed similar issues. The all too famous FLO indicator is … read more
BillyHvac
BillyHvac
Journeyman Service Technician/Inspector
State Licensed Mechanical Contractor
16,300 satisfied customers
Mike, I have been ask by my neighbor to fix her hot tub. It
Mike, I have been ask by my neighbor to fix her hot tub. It is a 120 VAC unit CS 6000-U1-WP. I have a electrical background. The heater will only come on when I push in the heater contactor the water … read more
BillyHvac
BillyHvac
Journeyman Service Technician/Inspector
State Licensed Mechanical Contractor
16,300 satisfied customers
I have an LA spas allure III 2005 and am getting three flashing
I have an LA spas allure III 2005 and am getting three flashing lights on the control panel and only a click when I press the Jet buttons. I replaced the 240 V double pole CGFI and am getting 120 V fo… read more
poolguy810
poolguy810
owner - pool and spa service company
2 years electro mechanical training
1,735 satisfied customers
Our spa is a tiger River Sumatran Model N installed 8-07, operating
Our spa is a tiger River Sumatran Model N installed 8-07, operating on 240V. Worked fine until 2 weeks ago. No heat. All circuits work except heater. Here is what I have done so far. Shut off GFCI cle… read more
poolguy810
poolguy810
owner - pool and spa service company
2 years electro mechanical training
1,735 satisfied customers
My hot tub heater is not working. I just received the hot tub
My hot tub heater is not working. I just received the hot tub from my father who recently passed ( no manual). After taking apart my 4.5 kw 240 flow through tube I found no damage to the heating eleme… read more
poolguy810
poolguy810
owner - pool and spa service company
2 years electro mechanical training
1,735 satisfied customers
i have a hydro quip spa that when turned on comes up with r1.0
i have a hydro quip spa that when turned on comes up with r1.0 on the display also the heater is not heating the water. i have checked the flow switch what and this is working fine also i have metered… read more
TheHotTubGuy
TheHotTubGuy
483 satisfied customers
I have a vita spa L200 control box made in 1999 it is 240
I have a vita spa L200 control box made in 1999 it is 240 volt. the board has 240 in and only 106 to the heater element. when I hook up element it shorts the breaker the disconnected heater element re… read more
TheHotTubGuy
TheHotTubGuy
483 satisfied customers
i have a 2003 sundance optima hot tub. when heater is activated
i have a 2003 sundance optima hot tub. when heater is activated circulation pump runs. everything works when temp is reched heater shuts down cir pump runs 30 seconds shuts down then display shows flo… read more
poolguy810
poolguy810
owner - pool and spa service company
2 years electro mechanical training
1,735 satisfied customers
I think my spa is on economy mode and I cant figure out how
I think my spa is on economy mode and I cant figure out how to reset this back to normal operation. Geckp Spa MSPA-1-P112-P212-B2-O1-CP2… read more
TheHotTubGuy
TheHotTubGuy
483 satisfied customers
I have a hot springs sovereign. Since we had a power outage
I have a hot springs sovereign. Since we had a power outage the spa will not heat up. I have replaced both temp sensors and the heater. The heating light LED on the main board is not on. Seems like so… read more
TheHotTubGuy
TheHotTubGuy
483 satisfied customers
I have a 605 spa that was working till last night. Now the
I have a 605 spa that was working till last night. Now the LEDs on the control panel work in repsonse to button pushes, the spa light comes on whne I opush the button, but no jets, air, or heat. I can… read more
Fix my Pool and Spa
Fix my Pool and Spa
Owner / Technition
Certified Service Technician
1,154 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

You did one super job of explaining to me everything there is to know about this fridge. I'm looking forward to asking you questions in the future.

JimmyBagley, IA

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

< Previous | Next >

Meet the Experts:

poolguy810

poolguy810

owner - pool and spa service company

1,735 satisfied customers

Servicing pools and all brands of spas for over 28 years.

Jerry

Jerry

Technician

375 satisfied customers

owned and operated spa and pool retail store for 12 yrs

PitschPlumbing

PitschPlumbing

master plumber

185 satisfied customers

Factory Authorized service for Rheem, Raypak, Jandy and Laars pool heaters. Gas licensed

Charles

Charles

Technician

38 satisfied customers

20 years experience

answersmadeeasy

answersmadeeasy

Pool Technician

13 satisfied customers

Experienced in pool and spa equip, heaters, salt systems

electrifier

electrifier

Elec Inspector, troubleshooter

12 satisfied customers

Electrical contractor and inspector 21 years experience with pools and spas

Fix my Pool and Spa

Fix my Pool and Spa

Owner / Technition

1,154 satisfied customers

Over 24 years in pool and spa service and construction

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x