Pontiac

Pontiac problems? Ask a mechanic for answers ASAP

Connect one-on-one with {0} who will answer your question

Related Pontiac Questions
After installing the heads I proceeded to put the intake
After installing the heads I proceeded to put the intake gaskets on the pushrods and rocker arms. On the front Bank starting from the pulley side the 4th push rod and rocker arm still has a lot of pla… read more
kalamykid
kalamykid
Pactor automotive
Vocational, Technical or Trade Scho
5,537 satisfied customers
I replaced cylinder head gasket on my 2007 montana sv6 3.9,
i replaced cylinder head gasket on my 2007 montana sv6 3.9, started motor up runs horrible, sounds like its misfiring, shut her down, spoke to someone last time… read more
GM Bob
GM Bob
Automobile Technician
High School or GED
1,105 satisfied customers
I have a 2003 pontiac gran prix se....it has a ticking
I have a 2003 pontiac gran prix se....it has a ticking noise......like a bad lifter noise..we added all the oil additive stuff changed the oil and took off the valve cover and inspected the lifters...… read more
Gary
Gary
Pontiac Technician
Vocational, Technical or Trade Scho
1,463 satisfied customers
Pontiac grand prix: was lower intake gasket leaking...have
was lower intake gasket leaking...have off.do i have to pull push rods to change gasket..looks so ,,just back off rockers?… read more
jazzmaster
jazzmaster
LEAD AUTO TECH
Vocational, Technical or Trade Scho
2,324 satisfied customers
Pontiac G6: hi pete, i just got done replacing the lower intake
hi pete, i just got done replacing the lower intake manifold gasket and valve cover gasket. when i hooked everything up and added the fluids that needed I started up the car and a very loud knocking n… read more
Gary
Gary
Pontiac Technician
Vocational, Technical or Trade Scho
1,463 satisfied customers
Pontiac aztec: dude i have a 2004 aztec im rebuilding the top
dude i have a 2004 aztec im rebuilding the top end on and let my employee take it apart and he pulled all the push rods out and dont know where they go.... its a 3.4 front of motor please tell me in o… read more
Gary
Gary
Pontiac Technician
Vocational, Technical or Trade Scho
1,463 satisfied customers
Pontiac Grand Am: 2000 pontiac Grand Am 3.4 Had head
2000 pontiac Grand Am 3.4 Had blown head gaskets so replaced them on starting the car we heard a rattle which turned out to be bent exhaust push rod. Changed it out and restarted car and now that lift… read more
Gary
Gary
Pontiac Technician
Vocational, Technical or Trade Scho
1,463 satisfied customers
We have a 2004 Pontiac Grand AM that is making a loud clicking
We have a 2004 Pontiac Grand AM that is making a loud clicking noise from the valve cover on the back side of a V6 engine.… read more
Virtual Wrench
Virtual Wrench
Owner of LJ Auto Repair 37 years
Associate Degree
14,398 satisfied customers
Pontiac Grand Prix GT: Hi, I removed push rods and roller
Hi, I removed push rods and roller rockers, in a 2004 Pontiac Grand Prix, 3800 N/S. (Changed head gaskets) Im done with the job, put back everything, adjustments made according torque especs, fill fre… read more
Dave Nova
Dave Nova
Pontiac Technician
Associate Degree
2,014 satisfied customers
Pontiac: I have a 1999 pontiac gm v-6 3.4l. replaced the heads
I have a 1999 pontiac gm v-6 3.4l. replaced the heads with new heads but only 2 valve springs are moving in the front and 4 springs are moving in the rear. what could this be.… read more
GM Tech (Cam)
GM Tech (Cam)
Pontiac Technician
Vocational, Technical or Trade Scho
2,403 satisfied customers
transport: parked..valve cover..seal on the passenger side..v6
ok i was driving my van one night and as i stopped and baccked up the van stalled never before has it stalled so the next morning i checked the fluids and all were good started the van and it had a kn… read more
John
John
GM FACTORY CERTIFIED TECHNICIAN
2 YEARS COLLEGE
514 satisfied customers
2001 Pontiac Grand AM: car back fires..cylinders..spark plug wires
I am working on a 2001 Pontiac Grand AM, 3.4 Liter v6, I just replaced the lower intake gaskets and now the car back fires through the intake, I checked compression on 2,4,6 cylinders and all have bet… read more
GM Tech (Cam)
GM Tech (Cam)
Pontiac Technician
Vocational, Technical or Trade Scho
2,403 satisfied customers
1997 Pontiac Montana: 000 Miles..intake manifold gasket..the van..pull
Hi I have a 1997 Pontiac Montana van that is about at the end of it's life, (175,000 Miles) the intake manifold gasket started leaking antifreeze and I priced this out and found that the repair is alm… read more
jazzmaster
jazzmaster
LEAD AUTO TECH
Vocational, Technical or Trade Scho
2,324 satisfied customers
6 grand prix: lower intake gasket on my 1996 3100 v..i cant figure
i was changing the lower intake gasket on my 1996 3100 v-6 grand prix and didnt mark the push rods when i took them out when i went to reinstall them i realized the exhaust ones were longer but i cant… read more
Ironmike
Ironmike
ASE Master ,Ford Certified Master Tech
Vocational, Technical or Trade Scho
3,442 satisfied customers
I have a 2003 Pontiac Grand AM GT with a 3.4 engine. I replaced
I have a 2003 Pontiac Grand AM GT with a 3.4 engine. I replaced a leaking lower intake gasket and the upper intake gasket. In the process I replaced the lifters. I used new factory parts from the loca… read more
Joe
Joe
Owner Kingsland Auto & Marine Services
Vocational, Technical or Trade Scho
1,596 satisfied customers
im replacing the valve seals on my 1989 Trans am GTA...lash..torque
I'm replacing the valve seals on my 1989 Trans Am GTA. I've only removed the rocker arms and this not an over hual of the engine. My question is, do I need to adjust the lash or can I just torque the … read more
Jerry
Jerry
Service consultant
Vocational, Technical or Trade Scho
13,107 satisfied customers
1992 pontiac grand prix: intake gasket..i sprayed break..vaccum leak
i have a 1992 pontiac grand prix. i just put intake gasket in and now the engine runs rough and does not have good power. i sprayed break clean to try to find a vaccum leak but did not change the runn… read more
jazzmaster
jazzmaster
LEAD AUTO TECH
Vocational, Technical or Trade Scho
2,324 satisfied customers
pontiac aztek: engine noise appears to be upper rear by ignition coil
pontiac aztec engine noise appears to be upper rear by ignition coil pac. engine will run but very roughly. what is… read more
Pete
Pete
Automotive Diagnostic Specialist
General auto certifications
30,680 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

Wonderful service, prompt, efficient, and accurate. Couldn't have asked for more. I cannot thank you enough for your help.

Mary C.Freshfield, Liverpool, UK

This expert is wonderful. They truly know what they are talking about, and they actually care about you. They really helped put my nerves at ease. Thank you so much!!!!

AlexLos Angeles, CA

Thank you for all your help. It is nice to know that this service is here for people like myself, who need answers fast and are not sure who to consult.

GPHesperia, CA

I couldn't be more satisfied! This is the site I will always come to when I need a second opinion.

JustinKernersville, NC

Just let me say that this encounter has been entirely professional and most helpful. I liked that I could ask additional questions and get answered in a very short turn around.

EstherWoodstock, NY

Thank you so much for taking your time and knowledge to support my concerns. Not only did you answer my questions, you even took it a step further with replying with more pertinent information I needed to know.

RobinElkton, Maryland

He answered my question promptly and gave me accurate, detailed information. If all of your experts are half as good, you have a great thing going here.

DianeDallas, TX

< Previous | Next >

Meet the Experts:

GM Tech (Cam)

GM Tech (Cam)

Pontiac Technician

2,403 satisfied customers

GM Grand Master Technician 2007. 14 years experience.

Dave Nova

Dave Nova

Pontiac Technician

2,014 satisfied customers

ASE Master Certification. GM World Class Certification

Gary

Gary

Pontiac Technician

1,463 satisfied customers

15 years GM master tech/15 years ASE master

Ron Z.

Ron Z.

- Pontiac Tech -

778 satisfied customers

18+yrs experience. State Inspector and Pontiac Diagnostics

Don - Mo Lurch

Don - Mo Lurch

Pontiac Mechanic

558 satisfied customers

GM, Chevrolet Cert., Heavy Line Mech, Race Shop Owner, Mobile Electronics.

John

John

GM FACTORY CERTIFIED TECHNICIAN

514 satisfied customers

ASE A1-A8 w/L1 GM master technician.Factory certified/40 years experience

car tech

car tech

ASE Certified Technician

446 satisfied customers

25 years master tech and shop owner

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x