Nissan

Nissan repair questions? Ask a mechanic for answers ASAP

Connect one-on-one with {0} who will answer your question

Related Nissan Questions
4th mass air flow sensor due to p0101 problem slowly got
4th mass air flow sensor due to p0101 problem slowly got worse after pcm upgrade … read more
JOHN aka Eauto
JOHN aka Eauto
self employed
High School or GED
21,990 satisfied customers
I have a 2004 Altima, 2.5 l, with 205,000 on it.The problem
I have a 2004 Altima, 2.5 l, with 205,000 on it.The problem is the engine starts fine, but will not rev up past 2500 rpm and if I try to hold it at 2500 rpm, it fluxuates. I have no codes, no check en… read more
David Craig
David Craig
OWNER/MECHANIC
Associates
11,678 satisfied customers
I have a Nissan Altima 3.5se. All of a sudden at 2500rpms
I have a Nissan Altima 3.5se. All of a sudden at 2500rpms the engine starts sputtering. I just filled the gas tank with 87 octane. Any ideas?… read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
9,976 satisfied customers
It has loss of power and spits and spudders. We have
It has loss of power and spits and spudders. We have replaced the catalytic converter and checked the rear. It's clear. … read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
9,976 satisfied customers
2006 Altima 2.5 was throwing a p 300 code (random misfire
2006 Altima 2.5 was throwing a p 300 code (random misfire hard starting paint, thinner smell coming out of the exhaust ran fine after you got it started) took it to a mec for a deeper scan and he said… read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
9,976 satisfied customers
I have a 2003 Nissan altima and if I accelerate my car past
Hi I have a 2003 Nissan altima and if I accelerate my car past 2000 or so rpms that seems to activate the Rev limitor,so I checked the oil and it was low added a quart , afterwards it drove fine, what… read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
9,976 satisfied customers
I have a 2005 Altima 3.5. Within the past year I have
I have a 2005 Altima 3.5. Within the past year I have replaced the Throttle body due to a bad Throttle Position Sensor, the cam shaft position sensors, spark plugs, transmission control module among v… read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
9,976 satisfied customers
altima: 2002 Nissan Altima 2.5s Bought this car recently and
2002 Nissan Altima 2.5s Bought this car recently and CEL stated Crankshaft sensor has an issue and I had a code of P0507 but hasn't come back on. I replaced both crank/cam with Nissan sensors. Car wil… read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
9,976 satisfied customers
Nissan Pathfinder: I have a 1998 Nissan Pathfinder with 203,000
I have a 1998 Nissan Pathfinder with 203,000 miles. I just started misfiring mildly when first started and then gets worse as engine warms up. RPM's swing up and down at idle and after engine warmed t… read more
Jay
Jay
Shop Forman / Lead Tech
Vocational, Technical or Trade Scho
25,966 satisfied customers
NISSAN MAXIMA: I have a 2011 maxima. Intermittently Im getting
I have a 2011 maxima. Intermittently Im getting engine misses at 2500 rpm. At times when I accelerate the engine will lose power until I drop below the 2500 rpm mark. Service engine lite will also com… read more
Jay
Jay
Shop Forman / Lead Tech
Vocational, Technical or Trade Scho
25,966 satisfied customers
Nissan Altima: I brought my car to the dealer today and they
I brought my car to the dealer today and they told me I need a map sensor its a 96 altima. I went to the parts store and they told me I don't have one. Is this true?… read more
Jay
Jay
Shop Forman / Lead Tech
Vocational, Technical or Trade Scho
25,966 satisfied customers
Nissan/Datsun Altima S: I have a 2002 Nissan Altima 2.5s. I
I have a 2002 Nissan Altima 2.5s. I just replaced the MAF sensor and now the car is wanting to stall out when in drive sitting at a light. Will run fine if on freeway. When the car is in park rpm are … read more
Jay
Jay
Shop Forman / Lead Tech
Vocational, Technical or Trade Scho
25,966 satisfied customers
98 nissan pathfinder: f..morning it works finr but after it warms
my 98 nissan pathfinder won't go pass 2500 rpm. I f I start it in the morning it works finr but after it warms up and then i shut it off and turn it back on it wont go pass 2500 rpm. then after a whil… read more
Jake
Jake
5,877 satisfied customers
1998 Nissan 200sx: Automatic, It has 186,000 Miles on it.
I have a 1998 Nissan 200sx 1.6 DOHC. Automatic, It has 186,000 Miles on it. Im having a major issue with it not running. It starts and runs very rough, Sometimes it will rev in park or nuetral with li… read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
22,461 satisfied customers
how many 02 sensors does a 2002 3.5 nissan altima have. had
how many 02 sensors does a 2002 3.5 nissan altima have. had the cats replaced a yr ago but now the car wont accelerate, maybe goes 30, and will die out. taken it to autozone but lots of codes popped u… read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
9,976 satisfied customers
2000 infinity i30: lean..all o2 sensors and a minor tune..maf sensor
i have an 2000 infinity i30 and pulled two codes p0171 and p0174 system to lean bank1 and bank2. i replaced all o2 sensors and a minor tune up. car still has same code then replaced the maf sensor and… read more
Arench
Arench
President
CT State GED w/ Honors
1,484 satisfied customers
86 300zx: running fine..parked..starts fine..2500 it stalls out misses
86 300zx car was running fine parked it now it wont rev past about 2500 rpm it starts fine idles fine revs up to 2500 fine when it hits 2300-2500 it stalls out misses a bit goes down to about 1200 the… read more
Dennis
Dennis
Automotive Master Tech
Mechanical Engineer
224 satisfied customers
1995 Nissan Maxima: started stalling..it wont go over 2500 Rpm
I have a 1995 Nissan Maxima. Last week it started stalling a little. Now it wont go over 2500 Rpm. The car starts fine when its cold but if i put it in gear before it warms up it cuts right off. Even … read more
Infiniti Nissan Specialist
Infiniti Nissan Specialist
Master Technician
Vocational, Technical or Trade Scho
915 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was in trouble with an electrical issue with my brand new Nissan. I frantically went online trying to find help and luckily I found your site. I reached a NISSAN tech named RIP. He was absolutely tremendous and helped me work through the issue. What a pro!

cjazLexington, KY

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

< Previous | Next >

Meet the Experts:

Chris(aka-Moose)

Chris(aka-Moose)

Nissan Technician

1,000 satisfied customers

24 years of experience diagnosing & repairing

Tim Mohr

Tim Mohr

ASE MASTER TECH

650 satisfied customers

30 YRS EXPERIENCE, FOREIGN AND DOMESTIC, GAS AND DEISEL

Marty

Marty

ASE Certified Technician

203 satisfied customers

ASE & Bosch master tech. 30 years experience.

Mike V.

Mike V.

Nissan Technician

9,976 satisfied customers

Nissan factory trained and Certified Subaru Technician.

Ron

Ron

ASE Certified Technician

669 satisfied customers

34 years of automotive Repair

Anthony

Anthony

ASE Certified Technician

332 satisfied customers

ASE Master Automobile Technician with over 18 years exp. in this field.

Richard

Richard

ASE Certified Technician

92 satisfied customers

Nissan Tech ASE certified technician

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x