Nissan

Nissan repair questions? Ask a mechanic for answers ASAP

Connect one-on-one with {0} who will answer your question

Related Nissan Questions
I have a 06 nissan Sentra spec v it started makin a loud
I have a 06 nissan Sentra spec v it started makin a loud knocking noise … read more
Roy Sheidenberger
Roy Sheidenberger
8,904 satisfied customers
In my last question I asked about engine hesitation when gas
In my last question I asked about engine hesitation when gas pedal pressed was told to check on fuel filter or Catalytic converter, we did replace Catalytic converter and did engine tune up including … read more
Clifton B.
Clifton B.
nissan master auto tech
Associate Degree
5,312 satisfied customers
I have a 2006 nissan titan Le and it's stuck in safe mode.
I have a 2006 nissan titan Le and it's stuck in safe mode. It won't rev past 3k rpm and the longer I drive it the worse it becomes there's no check engine lights and when I stop for a bit it seems to … read more
Dan
Dan
Automotive Technician
Vocational, Technical or Trade Scho
24,892 satisfied customers
I have a 2005 Nissan Altima SE-R with 127k on it. I have
I have a 2005 Nissan Altima SE-R with 127k on it. I have engine codes of P0011, P0022, and P1273 - i took it to the nissan dealer and they said that the gasket on the back side of the time chain was b… read more
Jay
Jay
Shop Forman / Lead Tech
Vocational, Technical or Trade Scho
25,778 satisfied customers
Xtrail 2003 starts won't keep going - like its starved for
Xtrail 2003 starts won't keep going - like its starved for petrol - it's now 3 day at auto electrician - they have had it in their computer and haven't been able to find anything - now suggesting timi… read more
Jay
Jay
Shop Forman / Lead Tech
Vocational, Technical or Trade Scho
25,778 satisfied customers
As i press on the gas the car seems to loose power and kinna
As i press on the gas the car seems to loose power and kinna wants to die out changed out cam shaft position sensor and crank shaft position sensor … read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
9,976 satisfied customers
Need assistance with a 2005 Nissan Quest? I am. It had a
I am. It had a clogged pre cat (next to firewall) I removed the intake plenum and the throttle assembly. Replaced the pre cat, the back air/fuel sensor. Buttoned it all up and the car idles great. When you rev up the engine, it hits around 3k rpm, then begins to stutter, sound like is muffled or strained. I read it may be the MAF, so I replaced that, same behavior. I did do the throttle reset. I verified that if the switch is on, van in Drive, and your press the accelerator to the floor, the butterfly on the throttle is fully open … read more
Pete
Pete
Automotive Diagnostic Specialist
General auto certifications
35,231 satisfied customers
Sentra se-r spec v: I have a 2004 nissan sentra se-r specv.
I have a 2004 nissan sentra se-r specv. It has been jerking while driving and then my car shuts down. I thought it was the knock sensor or crank sensor. I replaced both and still have the same problem… read more
I. Silva
I. Silva
High School or GED
1,437 satisfied customers
R51 Pathfinder V6 4.0: , I have a 06 Pathfinder V6 4.0 that
, I have a 06 Pathfinder V6 4.0 that is suffering from a very rough idle and lack of power under acceleration. It has lost all power twice while driving. A faulty crank sensor earth was found and all … read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
9,976 satisfied customers
2000 nissan: i have a 2000 nissan sentra she cranks up but
i have a 2000 nissan sentra she cranks up but will only go 5-15 mph,the rpm will go up 3000 but then dies down ,when hooked up to a computer it reads wiring,emisions and coil 4, i just replaced all co… read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
9,976 satisfied customers
Nissan 2006 QR25DE: Hello, My Nissan Altima 2006 model does
Hello, My Nissan Altima 2006 model does not fire well. When you step on the throttle lever it does not go beyond "mark 3" speed meter. Please what is the problem? How can I fix this!… read more
Jake
Jake
5,781 satisfied customers
Nissan Maxima: 1995 Maxima starts fine and drives fine until
1995 Maxima starts fine and drives fine until the engine gets hot and I try to accelerate at speeds above 40 mph. Car hesitates as if it is going to cut off and like no gas is getting through. It will… read more
Dan
Dan
Automotive Technician
Vocational, Technical or Trade Scho
24,892 satisfied customers
NISSAN MAXIMA: I have 2004 Maxima which stalled while driving.
I have 2004 Maxima which stalled while driving. Re-started drove home. Later on that night car ran rough , stalled went into fail safe mode.Back home. I read the code po 335-crank shaft sensor. ( Comm… read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
22,325 satisfied customers
Sentra: Hi, im a service tech for my local toyota dealership
Hi, im a service tech for my local toyota dealership and ran into a problem. I have a question related to an idle surge/variation after trying to do the tps closed position learning and idle air volum… read more
Jay
Jay
Shop Forman / Lead Tech
Vocational, Technical or Trade Scho
25,778 satisfied customers
Nissan/Datsun 350Z: Brought a 2004 Nissan 350Z into mechanic
Brought a 2004 Nissan 350Z into mechanic with oil consumption issue, ck engine light on and engine won't go over 2100 rpms. I already paid a ton of $ and the car is still doing the same thing. Replace… read more
Clifton B.
Clifton B.
nissan master auto tech
Associate Degree
5,312 satisfied customers
2002 Xterra SE: V6..4x4..supercharged..SES light came on
2002 Xterra SE 3.3 V6 4x4 not supercharged. 141000 miles. SES light came on. Codes showed multiple misfire, knock sensor, etc. Replaced plugs, wires, distributor cap and rotor. Plugs had only grey/whi… read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
9,976 satisfied customers
2002 Nissan Maxima SE: a metalic sounding rattle, which..rattle
I have a 2002 Nissan Maxima SE 6 speed with 54k miles. About a month ago, I started to notice a metalic sounding "rattle", which sounds like it's coming from underneath the car (or under the engine?).… read more
BOBBYSS
BOBBYSS
Automotive Repair/Damage Investigator
Associate Degree
14,708 satisfied customers
I have a 1999 Nissan Altima that blew the code P1419 which
I have a 1999 Nissan Altima that blew the code P1419 which happens to be a clogged Vacuum Cut Bypass Valve. Is this essential to replace and could a clogged valve really decrease the cars performance?… read more
James
James
Technician
High School or GED
182 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was in trouble with an electrical issue with my brand new Nissan. I frantically went online trying to find help and luckily I found your site. I reached a NISSAN tech named RIP. He was absolutely tremendous and helped me work through the issue. What a pro!

cjazLexington, KY

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

< Previous | Next >

Meet the Experts:

Chris(aka-Moose)

Chris(aka-Moose)

Nissan Technician

1,000 satisfied customers

24 years of experience diagnosing & repairing

Tim Mohr

Tim Mohr

ASE MASTER TECH

650 satisfied customers

30 YRS EXPERIENCE, FOREIGN AND DOMESTIC, GAS AND DEISEL

Marty

Marty

ASE Certified Technician

203 satisfied customers

ASE & Bosch master tech. 30 years experience.

Mike V.

Mike V.

Nissan Technician

9,976 satisfied customers

Nissan factory trained and Certified Subaru Technician.

Ron

Ron

ASE Certified Technician

669 satisfied customers

34 years of automotive Repair

Anthony

Anthony

ASE Certified Technician

332 satisfied customers

ASE Master Automobile Technician with over 18 years exp. in this field.

Richard

Richard

ASE Certified Technician

92 satisfied customers

Nissan Tech ASE certified technician

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x