Nissan

Nissan repair questions? Ask a mechanic for answers ASAP

Ask an Expert,
Get an Answer ASAP!

Related Nissan Questions
New maf sensor now getting p0300 and stft1 is at positive 25
New maf sensor now getting p0300 and stft1 is at positive 25 bank 2 stft2 is at -25 at 2800 to 3k rpm. Reading anywhere from -2 to 5 at idle on both banks … read more
Jake
Jake
311 satisfied customers
I have a '00 Nissan Xterra 3.3 L V6 2WD & ever since my
I have a '00 Nissan Xterra 3.3 L V6 2WD & ever since my radiator blew, I had to keep replacing parts like the ignition, distributor cap & new spark plugs. It will start, but it will just start sputter… read more
Jay
Jay
Nissan Technician
21,932 satisfied customers
I have replaced a maf sensor crankshaft position sensor and
I have replaced a maf sensor crankshaft position sensor and throttle body but my car still reads a p1102 code and wont rev over 2500rpm and now shifts really hard from park to drive and reverse im los… read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
9,482 satisfied customers
Hey mike spoke too soon. After putting everything back together
Hey mike spoke too soon. After putting everything back together and driving the limp mode came right back. Now short term fuel trim is about 10% at idle and just to 15-25% at about 2k rmps.… read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
9,482 satisfied customers
I have a 2005 Altima 3.5. Within the past year I have
I have a 2005 Altima 3.5. Within the past year I have replaced the Throttle body due to a bad Throttle Position Sensor, the cam shaft position sensors, spark plugs, transmission control module among v… read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
9,482 satisfied customers
Nissan/Datsun Pathfinder SE: 2014 Pathfinder SE - got problem
2014 Pathfinder SE - got problem with going over 50 mph. Went to pepboys and scan read that need AirMass Sensor, Idle Air Control and Cam Position sensor. Do I really need to buy all those parts… read more
Jake
Jake
311 satisfied customers
D21: I have an 86 d21 that is running like . Rebuilt
Hi I have an 86 d21 that is running like crap. Rebuilt the throttle body changed both injectors changed cap and rotor. Appears to be running to rich as the cat was glowing red last time we took it out… read more
Ron
Ron
ASE Certified Technician
Vocational, Technical or Trade Scho
589 satisfied customers
Nissan Sentra: I have an 05 Sentra (145,000 kms) with the
I have an '05 Sentra (145,000 kms) with the 1.8 and the lower the outside temperature the harder it is to start. If the temp is around 0 C (32F) or it has been in the garage overnight it starts okay b… read more
Matt
Matt
Engineer
Bachelor's Degree
5 satisfied customers
Maxima: I have a 1996 Nissan Maxima. Its showing code P0100.
I have a 1996 Nissan Maxima. Its showing code P0100. I changed the air filter and checked the connection. The car keeps stalling out. I unplugged the MAF sensor plug and the car ran but idled up a lit… read more
Jay
Jay
Nissan Technician
21,932 satisfied customers
97 Nissan sentra gxe: fuel gauge..scanner..same problem, changed tps
I have a 97 Nissan sentra gxe got 38psi on fuel gauge car will idle all day,if u try 2 guvs it gas it will bog down. & shut off changed air flow meter BC it came up on scanner, cleared code, light not… read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
9,482 satisfied customers
Altima: fuel pump and crank sensor car ran about 15 miles..revving
02 altima, changed fuel pump and crank sensor car ran about 15 miles and started not revving up would idle but not move. 5 spd. 140000 miles. any suggestions… read more
Anthony
Anthony
ASE Certified Technician
Vocational, Technical or Trade Scho
332 satisfied customers
Limit: I found the plugs and plan on changing them today
jpaug01,Sorry about lack of feed back. didn't know there wasa time limit. I found the plugs and plan on changing them today. in the mean time, had a fender bender and shortly after came up with a powe… read more
jpaug01
jpaug01
technician
Vocational, Technical or Trade Scho
427 satisfied customers
95 nissan quest: gas pedal..the engine will stall and rev..rpms
i have a 95 nissan quest mini van. the engine will rev to 2500 rpm ok but if i hold the gas pedal pass 2500 or so rpm the engine will stall and rev back down and then back up again. the engine will no… read more
Jay
Jay
Nissan Technician
21,932 satisfied customers
1997 nissan: idles..reverse..it sputters and ultimately stalls
1997 nissan pathfinder......starts and idles perfect. put it in reverse or drive and it sputters and ultimately stalls. changed the fuel filter but didnt help. need help… read more
Jay
Jay
Nissan Technician
21,932 satisfied customers
2002 pathfinder: started right..right back..stall..neutral and gas it
I have a 2002 pathfinder with 150k, the other night the idle was a bit high, so I filled with super and continued on my way. I hit a bump in the road a half hour later and my truck stalled out-it star… read more
Tony Tool
Tony Tool
Vocational School
8 satisfied customers
ltd: 000 miles..Problem was, rough running when it was fully warmed
I own a 2000 3.3 ltr. Nissan Pathfinder w/120,000 miles on it . Problem was, rough running when it was fully warmed up Idle a little high approx.1000rpm when cold, OK @ high RPM but from idle up to 20… read more
AutoTech08
AutoTech08
Workshop owner
Vocational, Technical or Trade Scho
676 satisfied customers
3.3 liter, 128K miles : Bucking engine as if timing is..fuel delivery
re.2000xterra 3.3 liter, 128K miles : Bucking engine as if timing is off, or fuel delivery, but seems like timing. started with a single falter/buck, progressed to serious bucking/faltering at medium … read more
Roy
Roy
Vocational, Technical or Trade Scho
5,421 satisfied customers
2000 Nissan Maxima: 40 degrees..I start the car the rpms..stall..warms
I have a 2000 Nissan Maxima when it is 40 degrees or lower outside and I start the car the rpms will drop and the car will stop. If I keep my foot on the excelerator and keep the rpms at 2000 and let … read more
Shimell
Shimell
Team Leader/ Master technician
Vocational, Technical or Trade Scho
363 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was in trouble with an electrical issue with my brand new Nissan. I frantically went online trying to find help and luckily I found your site. I reached a NISSAN tech named RIP. He was absolutely tremendous and helped me work through the issue. What a pro!

cjazLexington, KY

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

< Previous | Next >

Meet the Experts:

Chris(aka-Moose)

Chris(aka-Moose)

Nissan Technician

747 satisfied customers

16 years of experience

Tim Mohr

Tim Mohr

ASE MASTER TECH

602 satisfied customers

30 YRS EXPERIENCE, FOREIGN AND DOMESTIC, GAS AND DEISEL

Marty

Marty

ASE Certified Technician

161 satisfied customers

ASE & Bosch master tech. 30 years experience.

Mike V.

Mike V.

Nissan Technician

9,482 satisfied customers

Nissan factory trained and Certified Subaru Technician.

Ron

Ron

ASE Certified Technician

589 satisfied customers

34 years of automotive Repair

Anthony

Anthony

ASE Certified Technician

332 satisfied customers

ASE Master Automobile Technician with over 18 years exp. in this field.

Richard

Richard

ASE Certified Technician

92 satisfied customers

Nissan Tech ASE certified technician

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x