Nissan

Nissan repair questions? Ask a mechanic for answers ASAP

Connect one-on-one with {0} who will answer your question

Related Nissan Questions
P1145 code. 2 times. 1 - bank1 intake valve timing control
2 times. 1 - bank1 intake valve timing control position sensor circuit and this time, it read bank 2. just reset it again. we just bought it and changed the oil and it was very nasty. … read more
David Craig
David Craig
OWNER/MECHANIC
Associates
6,950 satisfied customers
2002 nissan pathfinder. code p1145 already change the intake
2002 nissan pathfinder. code p1145 already change the intake timing control solenoid valve and camshaft crankshaft position sensor. i check harness for open or shorted connection, check ok. any ideas?… read more
Richard Greer
Richard Greer
Vocational, Technical or Trade School
771 satisfied customers
My 2004 pathfinder loses power when it gets to 3000 rpm, and
my 2004 pathfinder loses power when it gets to 3000 rpm, and drops down to about 1000rpm. It runs fine as long as it's below 3000. The code that's coming up is p1130. I've already changed the swirl co… read more
Jake
Jake
4,535 satisfied customers
I am getting the codes for one of the solenoids in the valve
I am getting the codes for one of the solenoids in the valve body on a 2006 pathfinder. It sometimes has trouble when I start out like it is missing a low gear. I turn it off and back on and it is lik… read more
Jay
Jay
Shop Forman / Lead Tech
Vocational, Technical or Trade Scho
22,209 satisfied customers
Pathfinder LE: 1998 Nissan Pathfinder, 160k miles, just had
1998 Nissan Pathfinder, 160k miles, just had valve cover gaskets and exhaust manifold gasket replaced, tune up, rotor rotor replaced. Engine jerks at 50-55, then lets up; idles at light funny for 3 se… read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
28,540 satisfied customers
Pathfinder: Hi my name is***** have 1998 Nissan pathfinder
Hi my name is***** have 1998 Nissan pathfinder with 100,000 miles. After having the mechanic changed the leaky valve covers I started getting a "Service engine soon" Light. The following were done: 1)… read more
Jake
Jake
4,535 satisfied customers
Nissan Pathfinder: My 2005 Nissan Pathfinder vibrates whenever
My 2005 Nissan Pathfinder vibrates whenever I reach 40 MPH and above. It seems to be coming from the rear, but can feel the vibration in the driver's seat and steering wheel. Also, the vibration ONLY … read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
28,540 satisfied customers
Nissan/Datsun 350Z: If I understand this correctly then if
If I understand this correctly then if the crankshaft is damaged it will impact rpms? If the camshaft sensors have been replaced a couple of times then the issue is pointing to crankshaft issue? So co… read more
Clifton B.
Clifton B.
nissan master auto tech
Associate Degree
4,585 satisfied customers
2004 nissan quest: Engine starts cutting..was 303, cyl 3 misfire
I have a 2004 nissan quest. Engine starts cutting out around 2500-3000rpms. Code coming up was 303, cyl 3 misfire. Took intake all off and switched coil from front bank to back to see if misfire follo… read more
Jan Andersson
Jan Andersson
Master Tech
Bachelor's Degree
809 satisfied customers
2001 Nissan Pathfinder: SES light..getting codes..ignition coil
I have a 2001 Nissan Pathfinder. The SES light had been on, and we were getting codes that led us to replace the #1 ignition coil. That code is now gone. The #3 has previously been replaced. Now that … read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
28,540 satisfied customers
1997 Nissan Sentra: im guessing it has something to do with intake?
Hi, I have the P1110 code on my 1997 Nissan Sentra... what exactly does this mean? I'm guessing it has something to do with intake?… read more
Dan
Dan
Automotive Technician
Vocational, Technical or Trade Scho
23,947 satisfied customers
shifting..5th gear at 38mph and dropping the rpms to 1100
Is there a way to get a 2010 transmission from shifting into 5th gear at 38mph and dropping the rpms to 1100?… read more
Jay
Jay
Shop Forman / Lead Tech
Vocational, Technical or Trade Scho
22,209 satisfied customers
2006 Nissan Pathfinder LE: 4x4..vibration..60 mph..40-45 mph..shifting
I have 2006 Nissan Pathfinder LE 4x4 with 98K miles. I'm having a noise/vibration that feels like its in the drive train at low rpms at 35-60 mph it varies, mostly around 40-45 mph. Transmission is sh… read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
28,540 satisfied customers
1998 Nissan Pathfinder: drive line clunk appeared..cycled..70 mph
1998 Nissan Pathfinder 4 WD. While decending a long grade a drive line clunk appeared when the transmission lockup feature cycled on or off. Speed about 70 mph. RPM changed about 300 which seemed norm… read more
Roy
Roy
Vocational, Technical or Trade Scho
5,454 satisfied customers
2001 nissan frontier: fuel filter..vaccum leaks,injectors..ck..miss
p0301 is the code i am working with,2001 nissan frontier 2.4 l engine.plug, wires,cap rotor ,fuel filter replaced,fuel press ok.no vaccum leaks,injectors are ok.cylinders leak down ck ok, idle ok,abov… read more
Roy
Roy
Vocational, Technical or Trade Scho
5,454 satisfied customers
1994 Nissan Pathfinder: v6 standard 4WD with efi injector..it warms up
I have a 1994 Nissan Pathfinder v6 standard 4WD with EFI injector. The engine misses especially under load or going uphill. When the engine is cold it seems fine until it warms up. It seems fuel is no… read more
AutoTech08
AutoTech08
Workshop owner
Vocational, Technical or Trade Scho
676 satisfied customers
Nissan maxima: v6..coil clear codes no more misfire but the light came
hi i just got a nisan maxima 1997 v6 3.0 liter with 153000 miles. had a misfire #1 replace coil clear codes no more misfire but the light came on with code p1320 never had before is this coil too good… read more
Arench
Arench
President
CT State GED w/ Honors
1,484 satisfied customers
Jerking..accelerator..speeds above 40 miles per hour
an abnormal jerking motion is felt when the accelerator is pressed and released at speeds above 40 miles per hour… read more
Infiniti Nissan Specialist
Infiniti Nissan Specialist
Master Technician
Vocational, Technical or Trade Scho
915 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was in trouble with an electrical issue with my brand new Nissan. I frantically went online trying to find help and luckily I found your site. I reached a NISSAN tech named RIP. He was absolutely tremendous and helped me work through the issue. What a pro!

cjazLexington, KY

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

< Previous | Next >

Meet the Experts:

Chris(aka-Moose)

Chris(aka-Moose)

Nissan Technician

747 satisfied customers

16 years of experience

Tim Mohr

Tim Mohr

ASE MASTER TECH

602 satisfied customers

30 YRS EXPERIENCE, FOREIGN AND DOMESTIC, GAS AND DEISEL

Marty

Marty

ASE Certified Technician

161 satisfied customers

ASE & Bosch master tech. 30 years experience.

Mike V.

Mike V.

Nissan Technician

28,540 satisfied customers

Nissan factory trained and Certified Subaru Technician.

Ron

Ron

ASE Certified Technician

589 satisfied customers

34 years of automotive Repair

Anthony

Anthony

ASE Certified Technician

332 satisfied customers

ASE Master Automobile Technician with over 18 years exp. in this field.

Richard

Richard

ASE Certified Technician

92 satisfied customers

Nissan Tech ASE certified technician

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x