Nissan

Nissan repair questions? Ask a mechanic for answers ASAP

Ask an Expert,
Get an Answer ASAP!

Related Nissan Questions
99 Altima. threw a P1400 code. I tested the harness with a
Second opinion] 99 Altima. threw a P1400 code. I tested the harness with a multi meter. also tested the solenoid and I did hear a clicking noise. vacuum lines look fine. I'm stuck. help please… read more
Jay
Jay
Shop Forman / Lead Tech
Vocational, Technical or Trade Scho
21,934 satisfied customers
P0300 code. We tryed receting. Let me start with. swapped
let me start with . swapped motors in a 2007 Murano. Put a 2006 Murano motor in with all its sensores compleat everything. now showing the P0300 code. It starts up and idles ok reves up okay. but under load no power and exhaust stinks bad … read more
david craig
david craig
ASE Certified Technician
6,628 satisfied customers
My 02 maxima cranks but does not start. very low idle 500
my 02 maxima cranks but does not start. very low idle 500 rpm. try to give it gas and it dies. no codes. no check engine light. … read more
Jay
Jay
Shop Forman / Lead Tech
Vocational, Technical or Trade Scho
21,934 satisfied customers
Nissan/Datsun: 01 sentra 1.8 high idle at start up then surges
01 sentra 1.8 high idle at start up then surges after a few min. stalls sometimes but then starts right up pulled codes (tps) changed tps iac cleaned throttle body, new maf, checked for vacuum leaks i… read more
Chris(aka-Moose)
Chris(aka-Moose)
Nissan Technician
Vocational, Technical or Trade School
747 satisfied customers
nissan murano: 03 murano sl wont start after 2-5 min hot soak
03 murano sl won't start after 2-5 min hot soak after 10 min starts with long crank time l have replaced crank sensor coolant sensor battery did idle relern still not fixed. Has crank reference and in… read more
Tom
Tom
ASE Certified Technician
Vocational, Technical or Trade School
2,496 satisfied customers
Nissan sentra gxe 2001, 1.8 vin# 3n1cb51d51L419278 1) why
nissan sentra gxe 2001, 1.8 vin# ***** 1) why does my FMVSS label says engine is QDO8DE and ownr man says QG18DE 2) when start car it revs fine thun i put in drive and after a min or so the engine bog… read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
9,482 satisfied customers
Altima: it in reverse and it wouldnt move..backfire..tester
i was driving my altima, put it in reverse and it wouldnt move. prior to this it has been reving up and down loudly and conking out, also starting to backfire. it was hooked up to a tester and we were… read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
9,482 satisfied customers
2000 nissan: v..6 stalls and skip and exhaust is fire..sensor code
2000 nissan eterra v-6 stalls and skip and exhaust is fire red both sides has a knock sensor code will the knock sensor make the truck do theses things… read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
9,482 satisfied customers
Nissan/Datsun sentra I have a 01 nissan sentra it will not
I have a 01 nissan sentra it will not revup over 2000rpm it has no codes. I have replaced the mass air tried a tps, computor,checked fuel presure, and the converter everything checked good.… read more
normanahoyt
normanahoyt
Owner/technician/manager
Bachelor's Degree
367 satisfied customers
1995 Maxima: with just over 200,000 miles..rough idle..RPMs...warming
I have a 1995 Maxima with just over 200,000 miles. It has a very rough idle and some performance issues at low RPMs. It runs very good when warming up. No codes present. The longer it idles the roughe… read more
Amedee
Amedee
Automotive Consultant
Vocational, Technical or Trade Scho
19,501 satisfied customers
98 PATHFINDER: RUN ROUGH WHEN IT WARMS..TROUBLE CODE..KNOCK SENSOR
I HAVE A 98 PATHFINDER THAT STARTED TO RUN ROUGH WHEN IT WARMS UP. I GET A TROUBLE CODE P 0325 KNOCK SENSOR.… read more
Jay
Jay
Shop Forman / Lead Tech
Vocational, Technical or Trade Scho
21,934 satisfied customers
2003 murano: all cylinders..accelerating..air filter..alternator
My 2003 murano is running like it's not on all cylinders when slightly accelerating to maintain speed. I have had the catalytic converter replaced, plugs and air filter, injection service,alternator a… read more
Jay
Jay
Shop Forman / Lead Tech
Vocational, Technical or Trade Scho
21,934 satisfied customers
95 altima: Cam position sensor..distributor..not a Nissan..harness
Problem with 95 altima. Died on me a few months back. Cam position sensor plug at the distributor was falling apart, found a replacement not a Nissan but the junk yard since they are the only place th… read more
Jay
Jay
Shop Forman / Lead Tech
Vocational, Technical or Trade Scho
21,934 satisfied customers
Xterra: new battery in it and it starts fine..It idles..accelerate
I have a 03 Xterra that has been sitting for 6 mos. I put a new battery in it and it starts fine. It idles great but will not accelerate. It is an 3.3L auto non supercharged and will not move under it… read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
9,482 satisfied customers
Altima: drive my..my 03..it only stays running up to 2500 rpms..rev
When I start/drive my 03 Altima, it only stays running up to 2500 RPM's. It sounds like the rev limiter is on at 2500 rpms. Hard starts, poor excelleration. Ran codes P1102 and P1102P. The mass airflo… read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
9,482 satisfied customers
2000 Nissan Maxima: idles and runs great at part throttle..rev..shift
2000 Nissan Maxima starts, idles and runs great at part throttle. Will not rev over 4800 under full throttle. Transmission will not shift up under full throttle. Shifts fine otherwise. Fuel pressure 5… read more
Mike V.
Mike V.
Nissan Technician
Subaru and Nissan factory training.
9,482 satisfied customers
2000 Quest: hesitates..stalls..engine running..Diagnostic show
2000 Quest 3.3L Motor hesitates, stalls, speed drops off to a crawl and quits after about 40+minutes of engine running. My mech replaced fuel filter and fuel pump and it still behaves the same. Diagno… read more
Jay
Jay
Shop Forman / Lead Tech
Vocational, Technical or Trade Scho
21,934 satisfied customers
Murano: 000 miles..surge..2 grand, it will down shift into second
03'' Murano, 90,000 miles... Not does it surge and have a loss of power but when the RPM''s go just past 2 grand, it will down shift into second and stay there until I have to stop.. When it''s in thi… read more
Infiniti Nissan Specialist
Infiniti Nissan Specialist
Master Technician
Vocational, Technical or Trade Scho
915 satisfied customers
Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

JustAnswer in the News:

Ask-a-doc Web sites: If you've got a quick question, you can try to get an answer from sites that say they have various specialists on hand to give quick answers... Justanswer.com.
JustAnswer.com...has seen a spike since October in legal questions from readers about layoffs, unemployment and severance.
Web sites like justanswer.com/legal
...leave nothing to chance.
Traffic on JustAnswer rose 14 percent...and had nearly 400,000 page views in 30 days...inquiries related to stress, high blood pressure, drinking and heart pain jumped 33 percent.
Tory Johnson, GMA Workplace Contributor, discusses work-from-home jobs, such as JustAnswer in which verified Experts answer people’s questions.
I will tell you that...the things you have to go through to be an Expert are quite rigorous.

What Customers are Saying:

I was in trouble with an electrical issue with my brand new Nissan. I frantically went online trying to find help and luckily I found your site. I reached a NISSAN tech named RIP. He was absolutely tremendous and helped me work through the issue. What a pro!

cjazLexington, KY

I would (and have) recommend your site to others I was quite satisfied with the quality of the information received, the professional with whom I interacted, and the quick response time. Thanks, and be sure that I'll be back whenever I need a question answered in a hurry.

Stephanie PElm City, NC

used your service this weekend with "Trecers" help. thank you ,thank you, thank you. replaced an A/C fan motor. Local Auto Zone had part. $15.00 "tracer" fee and $40.00 for parts, I saved several hundreds of dollers at a shop. i will recommend you and use you in the future.

David L.Richmond, TX

9 dollars, 2 hours of my time, and I drove away. Your diagnosis was right on the mark. Thank you so much.

PhilMarysville, CA

Lurch. Thank you very much. I had real doubts about this website but your promptness of response, quick followup and to the point answer with picture was incredible.

CharlesWalnut Creek, CA

As a single woman, I really appreciate an excellent and affordable opinion.
Thank you Geordie, I will not hesitate to contact justanswer in the future!

SueCharleston, WV

Another great insight to what may be the problem. I will have my mechanic take a look at it tomorrow. Thanks again, Frank...you do indeed know your stuff.

JimCastleberry, FL

< Previous | Next >

Meet the Experts:

Chris(aka-Moose)

Chris(aka-Moose)

Nissan Technician

747 satisfied customers

16 years of experience

Tim Mohr

Tim Mohr

ASE MASTER TECH

602 satisfied customers

30 YRS EXPERIENCE, FOREIGN AND DOMESTIC, GAS AND DEISEL

Marty

Marty

ASE Certified Technician

161 satisfied customers

ASE & Bosch master tech. 30 years experience.

Mike V.

Mike V.

Nissan Technician

9,482 satisfied customers

Nissan factory trained and Certified Subaru Technician.

Ron

Ron

ASE Certified Technician

589 satisfied customers

34 years of automotive Repair

Anthony

Anthony

ASE Certified Technician

332 satisfied customers

ASE Master Automobile Technician with over 18 years exp. in this field.

Richard

Richard

ASE Certified Technician

92 satisfied customers

Nissan Tech ASE certified technician

< Previous | Next >

Disclaimer: Information in questions, answers, and other posts on this site ("Posts") comes from individual users, not JustAnswer; JustAnswer is not responsible for Posts. Posts are for general information, are not intended to substitute for informed professional advice (medical, legal, veterinary, financial, etc.), or to establish a professional-client relationship. The site and services are provided "as is" with no warranty or representations by JustAnswer regarding the qualifications of Experts. To see what credentials have been verified by a third-party service, please click on the "Verified" symbol in some Experts' profiles. JustAnswer is not intended or designed for EMERGENCY questions which should be directed immediately by telephone or in-person to qualified professionals.

Show MoreShow Less

Ask Your Question

x