How JustAnswer Works:
  • Ask an Expert
    Experts are full of valuable knowledge and are ready to help with any question. Credentials confirmed by a Fortune 500 verification firm.
  • Get a Professional Answer
    Via email, text message, or notification as you wait on our site.
    Ask follow up questions if you need to.
  • 100% Satisfaction Guarantee
    Rate the answer you receive.
Ask Chris(aka-Moose) Your Own Question
Chris(aka-Moose), Nissan Technician
Category: Nissan
Satisfied Customers: 615
Experience:  16 years of experience
Type Your Nissan Question Here...
Chris(aka-Moose) is online now
A new question is answered every 9 seconds

I has 2000 Nissan quest V-6 Engine, The Fuel lines bracket

Customer Question

I has 2000 Nissan quest V-6 Engine, The Fuel lines bracket under Plenum
( Upper Intake Manifold ) Two Screws coming Off and Two mounting bolts
was push in . I want to replace
new longer bolts, But , I don't want
to take off lots things to do it .
What's the simple methods ???
Submitted: 1 year ago.
Category: Nissan
Expert:  Jay replied 1 year ago.

Hi, My name is*****'m happy to help you. During our conversation, I may be presenting you with different things to try, and ask you some Questions to get a better understand of the issue so I can answer your question properly. So stick with me to the end, and I am sure we should be able to get this issue resolved for you!

What is it that you need to do on the Van that you are looking to take the plenum off?

Customer: replied 1 year ago.
I just replace the knock sensor which under the Lower intake manifold and change the rear valve cover gasket .
I was already replace all new gasket and seal the upper and lower intake manifold , also , replace all new small coolant hoses / vacuum hoses on the upper intake manifold ( attached to the plenum ) . Additional , I already
connected all spark plug wires , breather tube , electrical harness conntors ......etc , But , When I try to connecting
both fuel lines into fuel injectors rail . Then , I discovered the fuel lines bracket under the Plenum , that two retainer bolts was walking inside the metal plate , almostly flat with the plate , I trying to used my finger at behind plate to pushing those two bolts out and pliers at front , try many times but failed . then , I try to used camera to located
the retainer bolts which holding this metal plate , So , I can disconnected it from engine block , it's also failed .
I was very angry and frustrated . please help me , Thank you very much !!!
Expert:  Jay replied 1 year ago.

Sorry for getting back to you so late. Can you take a picture and show me exactly where the bracket is.

It's been a while since I have worked on a 2000 Quest. If I see what you are dealing with I ca help you much better.